• Silicon is a promising candidate for negative electrodes due to its high theoretical specific capacity (~3579 mAh g-1) and low lithiation potential (~0.40 V vs Li). However, its practical applications in battery have been inhibited by the large volume change (~400%) induced by Li+-insertion into Si lattices. Here, we attempt to resolve this issue at a fundamental level, and report for the first time a novel liquid metal (LM)-mediated spontaneous repairing conductive-additive-free Si anode for Li-ion battery. The fluidity of LM ensures the eternal contact between Si and the conducting-network during its repeated electrochemical reactions. The as-prepared nano-composite of LM/Si leads to superior performances as characterized by high capacity utilization (2300 mAh g-1 at 500 mA g-1), long-term stability (968 mAh g-1 after 1500 charge-discharge cycles at 8 A g-1 with 81.3% retention), high rate capability (360 mAh g-1 at 20 A g-1, equivalence of 55 C, or full charge/discharge in 65 seconds), and, in particular, an extra-ordinarily high initial coulombic efficiency (95.92%), which is not only the highest reported for Si to the best of our knowledge, but also higher than the mature graphitic carbon anodes. The unique approach described in this work not only resolves the basic stress challenges faced by the promising but often problematic alloy-type materials; in broader context it also provides a universal inspiration to all electrode materials whose electric properties suffer from extreme mechanic upheavals induced by the electrochemical strains during the cell reactions.
  • This paper reports the repeat-pass interferometric SAR results of Gaofen-3, a Chinese civil SAR satellite, acquired in November 2016 and March 2017 from Ningbo area. With the spatial baseline about 600 m and time baseline 116 days, the coherence of the two images still achieve good enough to generate the digital elevation model (DEM). During the InSAR processing, we compared several baseline estimating methods and obtained a good flat-earth phase removed interferogram map. By using the latest SAR interferogram filter and phase unwrapping method we proposed, we improved the coherence up to 0.88 in urban area and obtained a high quality DEM in Ningbo area. In addition, we evaluated the elevation model by comparing with the elevation values extracted from SRTM. And the result shows that accuracy of the elevation map is about 5 m (RMS) in plane area and 22m (RMS) in mountainous region, which demonstrated that Gaofen-3 has the powerful ability of repeat-pass SAR Interferometry.
  • Deep Spiking Neural Networks are becoming increasingly powerful tools for cognitive computing platforms. However, most of the existing literature on such computing models are developed with limited insights on the underlying hardware implementation, resulting in area and power expensive designs. Although several neuromimetic devices emulating neural operations have been proposed recently, their functionality has been limited to very simple neural models that may prove to be inefficient at complex recognition tasks. In this work, we venture into the relatively unexplored area of utilizing the inherent device stochasticity of such neuromimetic devices to model complex neural functionalities in a probabilistic framework in the time domain. We consider the implementation of a Deep Spiking Neural Network capable of performing high accuracy and low latency classification tasks where the neural computing unit is enabled by the stochastic switching behavior of a Magnetic Tunnel Junction. Simulation studies indicate an energy improvement of $20\times$ over a baseline CMOS design in $45nm$ technology.
  • A yoke-based permanent magnet, which has been employed in many watt balances at national metrology institutes, is supposed to generate strong and uniform magnetic field in an air gap in the radial direction. However, in reality the fringe effect due to the finite height of the air gap will introduce an undesired vertical magnetic component to the air gap, which should either be measured or modeled towards some optimizations of the watt balance. A recent publication, i.e., {\it Metrologia} 52(4) 445 [1], presented a full field mapping method, which in theory will supply useful information for profile characterization and misalignment analysis. This article is an additional material of [1], which develops a different analytical algorithm to represent the 3D magnetic field of a watt balance magnet based on only one measurement for the radial magnetic flux density along the vertical direction, $B_r(z)$. The new algorithm is based on the electromagnetic nature of the magnet, which has a much better accuracy.
  • In the joule balance developed at National Institute of Metrology (NIM), the dynamic phase of a watt balance is replaced by the mutual inductance measurement in an attempt to provide an alternative method for the kg redefinition. But for this method a rather large current in the exciting coil, is needed to offer the necessary magnetic field in the force weighing phase, and the coil heating becomes an important uncertainty source. To reduce coil heating, a new coil system, in which a ferromagnetic material is used to increase the magnetic field was designed recently. But adopting the ferromagnetic material brings the difficulty from the nonlinear characteristic of material. This problem can be removed by measuring the magnetic flux linkage difference of the suspended coil at two vertical positions directly to replace the mutual inductance parameter. Some systematic effects of this magnet are discussed.
  • The magnet system is one of the key elements of a watt balance. For the new watt balance currently under construction at the National Institute of Standards and Technology, a permanent magnet system was chosen. We describe the detailed construction of the magnet system, first measurements of the field profile, and shimming techniques that were used to achieve a flat field profile. The relative change of the radial magnetic flux density is less than $10^{-4}$ over a range of 5 cm. We further characterize the most important aspects of the magnet and give order of magnitude estimates for several systematic effects that originate from the magnet system.
  • The development of the joule balance method to measure the Planck constant, in support of the redefinition of the kilogram, has been going on at the National Institute of Metrology of China (NIM) since 2007. The first prototype has been built to check the feasibility of the principle. In 2011, the relative uncertainty of the Planck constant measurement at NIM is $7.7\times10^{-5}$. Self-heating of the coils, swing of the coil, are the main uncertainty contributions. Since 2012, some improvements have been made to reduce these uncertainties. The relative uncertainty of the joule balance is reduced to $7.2\times10^{-6}$ at present. The Planck constant measured with the joule balance is $h=6.6261041(470)\times10^{-34}$Js. The relative difference between the determined h and the CODATA2010 recommendation value is $5\times10^{-6}$. Further improvements are still being carried out on the NIM-1 apparatus. At the same time, the design and construction of a brand new and compact joule balance NIM-2 are also in progress and presented here.
  • An inertial mass measurement project, which is expected to precisely measure the Planck constant, $h$, for possible comparisons with known gravitational mass measurement projects, e.g., the watt balance and the Avogadro project, is being carried out at the National Institute of Metrology, China. The principle, apparatus, and experimental investigations of the inertial mass measurement are presented. The prototype of the experiment and the Planck constant with relative uncertainty of several parts in $10^{4}$ have been achieved for principle testing.
  • Given the potential for illicit nuclear material being used for terrorism, most ports now inspect a large number of goods entering national borders for radioactive cargo. The U.S. Department of Homeland Security is moving toward one hundred percent inspection of all containers entering the U.S. at various ports of entry for nuclear material. We propose a Bayesian classification approach for the real-time data collected by the inline Polyvinyl Toluene radiation portal monitors. We study the computational and asymptotic properties of the proposed method and demonstrate its efficacy in simulations. Given data available to the authorities, it should be feasible to implement this approach in practice.
  • This is essentially the author's thesis submited to The University of Chicago (May 1997). I prove the validity of Tamagawa number conjecture of Bloch-Kato for certain Hecke characters. I study the exponential map and local Tamagawa number for all odd primes (both ordinary and supersingular), using Kato's explicit reciprocity law for one dimensional Lubin-Tate formal group. I also study p-part of Shafarevich-Tate group for motives associated to Hecke characters, using Rubin's Main Conjecture in Iwasawa theory. Interestingly a congruence property between p-adic periods of elliptic curve and weight 1 Eisenstein series evaluated at torsion CM points play a crucial role in the proof of Bloch-Kato conjecture.