• A new pixel detector for the CMS experiment was built in order to cope with the instantaneous luminosities anticipated for the Phase~I Upgrade of the LHC. The new CMS pixel detector provides four-hit tracking with a reduced material budget as well as new cooling and powering schemes. A new front-end readout chip mitigates buffering and bandwidth limitations, and allows operation at low comparator thresholds. In this paper, comprehensive test beam studies are presented, which have been conducted to verify the design and to quantify the performance of the new detector assemblies in terms of tracking efficiency and spatial resolution. Under optimal conditions, the tracking efficiency is $99.95\pm0.05\,\%$, while the intrinsic spatial resolutions are $4.80\pm0.25\,\mu \mathrm{m}$ and $7.99\pm0.21\,\mu \mathrm{m}$ along the $100\,\mu \mathrm{m}$ and $150\,\mu \mathrm{m}$ pixel pitch, respectively. The findings are compared to a detailed Monte Carlo simulation of the pixel detector and good agreement is found.
• The degradation of signal in silicon sensors is studied under conditions expected at the CERN High-Luminosity LHC. 200 $\mu$m thick n-type silicon sensors are irradiated with protons of different energies to fluences of up to $3 \cdot 10^{15}$ neq/cm$^2$. Pulsed red laser light with a wavelength of 672 nm is used to generate electron-hole pairs in the sensors. The induced signals are used to determine the charge collection efficiencies separately for electrons and holes drifting through the sensor. The effective trapping rates are extracted by comparing the results to simulation. The electric field is simulated using Synopsys device simulation assuming two effective defects. The generation and drift of charge carriers are simulated in an independent simulation based on PixelAV. The effective trapping rates are determined from the measured charge collection efficiencies and the simulated and measured time-resolved current pulses are compared. The effective trapping rates determined for both electrons and holes are about 50% smaller than those obtained using standard extrapolations of studies at low fluences and suggests an improved tracker performance over initial expectations.
• ### STE-QUEST - Test of the Universality of Free Fall Using Cold Atom Interferometry(1312.5980)

The theory of general relativity describes macroscopic phenomena driven by the influence of gravity while quantum mechanics brilliantly accounts for microscopic effects. Despite their tremendous individual success, a complete unification of fundamental interactions is missing and remains one of the most challenging and important quests in modern theoretical physics. The STE-QUEST satellite mission, proposed as a medium-size mission within the Cosmic Vision program of the European Space Agency (ESA), aims for testing general relativity with high precision in two experiments by performing a measurement of the gravitational redshift of the Sun and the Moon by comparing terrestrial clocks, and by performing a test of the Universality of Free Fall of matter waves in the gravitational field of Earth comparing the trajectory of two Bose-Einstein condensates of Rb85 and Rb87. The two ultracold atom clouds are monitored very precisely thanks to techniques of atom interferometry. This allows to reach down to an uncertainty in the E\"otv\"os parameter of at least 2x10E-15. In this paper, we report about the results of the phase A mission study of the atom interferometer instrument covering the description of the main payload elements, the atomic source concept, and the systematic error sources.
• ### The Infrared Light Curve of SN 2011fe in M101 and the Distance to M101(1205.3828)

May 16, 2012 astro-ph.CO
We present near infra-red light curves of supernova (SN) 2011fe in M101, including 34 epochs in H band starting fourteen days before maximum brightness in the B-band. The light curve data were obtained with the WIYN High-Resolution Infrared Camera (WHIRC). When the data are calibrated using templates of other Type Ia SNe, we derive an apparent H-band magnitude at the epoch of B-band maximum of 10.85 \pm 0.04. This implies a distance modulus for M101 that ranges from 28.86 to 29.17 mag, depending on which absolute calibration for Type Ia SNe is used.
• ### Resolving the Multiple Outflows in the Egg Nebula with Keck II Laser Guide Star Adaptive Optics(0709.0473)

Sept. 4, 2007 astro-ph
The Egg Nebula has been regarded as the archetype of bipolar proto-planetary nebulae, yet we lack a coherent model that can explain the morphology and kinematics of the nebular and dusty components observed at high-spatial and spectral resolution. Here, we report on two sets of observations obtained with the Keck Adaptive Optics Laser Guide Star: H to M-band NIRC2 imaging, and narrow bandpath K-band OSIRIS 3-D imaging-spectroscopy (through the H2 2.121micron emission line). While the central star or engine remains un-detected at all bands, we clearly resolve the dusty components in the central region and confirm that peak A is not a companion star. The spatially-resolved spectral analysis provide kinematic information of the H_2 emission regions in the eastern and central parts of the nebula and show projected velocities for the H_2 emission higher than 100 km/s. We discuss these observations against a possible formation scenario for the nebular components.
• ### Catfish: A Monte Carlo simulator for black holes at the LHC(hep-ph/0609001)

July 6, 2007 hep-th, hep-ph, physics.data-an
We present a new Fortran Monte Carlo generator to simulate black hole events at CERN's Large Hadron Collider. The generator interfaces to the PYTHIA Monte Carlo fragmentation code. The physics of the BH generator includes, but not limited to, inelasticity effects, exact field emissivities, corrections to semiclassical black hole evaporation and gravitational energy loss at formation. These features are essential to realistically reconstruct the detector response and test different models of black hole formation and decay at the LHC.
• ### The RFOFO Ionization Cooling Ring for Muons(physics/0504098)

April 14, 2005 hep-ex, physics.acc-ph
Practical ionization cooling rings could lead to lower cost or improved performance in neutrino factory or muon collider designs. The ring modeled here uses realistic three-dimensional fields. The performance of the ring compares favorably with the linear cooling channel used in the second US Neutrino Factory Study. The normalized 6D emittance of an ideal ring is decreased by a factor of approximately 240, compared with a factor of only 15 for the linear channel. We also examine such \textit{real-world} effects as windows on the absorbers and rf cavities and leaving empty lattice cells for injection and extraction. For realistic conditions the ring decreases the normalized 6D emittance by a factor of 49.
• ### Progress in Absorber R&D for Muon Cooling(physics/0108027)

Aug. 17, 2001 hep-ph, physics.acc-ph
A stored-muon-beam neutrino factory may require transverse ionization cooling of the muon beam. We describe recent progress in research and development on energy absorbers for muon-beam cooling carried out by a collaboration of university and laboratory groups.
• ### Multijet Structure of High E_T Hadronic Collisions(hep-ph/9612320)

Dec. 10, 1996 hep-ph
Multijet events at large transverse energy (sum E_T > 420 GeV) and large multijet invariant mass (M_jets > 600 GeV) have been studied by the CDF Collaboration at the Fermilab Tevatron. The observed jet multiplicity distribution can be understood in a QCD inspired exponentiation model, in regions of phase space which require going beyond fixed order perturbation theory.
• ### Muon Collider Design(acc-phys/9604001)

April 9, 1996 physics.acc-ph, acc-phys
Muon Colliders have unique technical and physics advantages and disadvantages when compared with both hadron and electron machines. They should thus be regarded as complementary. Parameters are given of 4 TeV and 0.5 TeV high luminosity \mu^+ \mu^- colliders, and of a 0.5 TeV lower luminosity demonstration machine. We discuss the various systems in such muon colliders, starting from the proton accelerator needed to generate the muons and proceeding through muon cooling, acceleration and storage in a collider ring. Detector background, polarization, and nonstandard operating conditions are discussed.