
A dedicated simulation of the detectors is of great importance to the success
of the high energy physics experiments. It not only benefits the optimization
of the detectors, but can also improve the precision of the physics results. To
design a Multigap Resis tive Plate Chamber(MRPC) with a much higher time
resolution, a detailed montecarlo simulation of the detector is developed. The
simulation includes the formation of the analog waveform of the signal besides
all the other modules. The detector performance under different mixture of the
working gas is studied, and its comparison with the experiment shows a good
agreement.

Multigap Resistive Plate Chamber(MRPC) is a widely used timing detector with
a typical time resolution of about 60 ps. This makes MRPC an optimal choice for
the time of flight(ToF) system in many large physics experiments. The prior
work on improving the time resolution is mainly focused on altering the
detector geometry, and therefore the improvement of the data analysis algorithm
has not been fully explored. This paper proposes a new time reconstruction
algorithm based on the deep neural networks(NN) and improves the MRPC time
resolution by about 10 ps. Since the development of the high energy physics
experiments has pushed the timing requirements for the MRPC to a higher level,
this algorithm could become a potential substitution of the time over
threshold(ToT) method to achieve a time resolution below 30 ps.

The analysis and planning methods for competing risks model have been
described in the literatures in recent decades, and noninferiority clinical
trials are helpful in current pharmaceutical practice. Analytical methods for
noninferiority clinical trials in the presence of competing risks were
investigated by Parpia et al., who indicated that the proportional
subdistribution hazard model is appropriate in the context of biological
studies. However, the analytical methods of competing risks model differ from
those appropriate for analyzing noninferiority clinical trials with a single
outcome; thus, a corresponding method for planning such trials is necessary. A
sample size formula for noninferiority clinical trials in the presence of
competing risks based on the proportional subdistribution hazard model is
presented in this paper. The primary endpoint relies on the subdistribution
hazard ratio. A total of 120 simulations and an example based on a randomized
controlled trial verified the empirical performance of the presented formula.
The results demonstrate that the empirical power of sample size formulas based
on the Weibull distribution for noninferiority clinical trials with competing
risks can reach the targeted power.

Let $p$ be a prime integer and $\mathbb{Z}_p$ be the ring of $p$adic
integers. By a purely computational approach we prove that each nonzero normal
element of a completed group algebra over the special linear group ${\rm
SL}_3(\mathbb{Z}_p)$ is a unit. This give a positive answer to an open question
in \cite{WeiBian2} and make up for an earlier mistake in \cite{WeiBian1}
simultaneously.

Substantial experimental and theoretical efforts worldwide are devoted to
explore the phase diagram of strongly interacting matter. At LHC and top RHIC
energies, QCD matter is studied at very high temperatures and nearly vanishing
netbaryon densities. There is evidence that a QuarkGluonPlasma (QGP) was
created at experiments at RHIC and LHC. The transition from the QGP back to the
hadron gas is found to be a smooth cross over. For larger netbaryon densities
and lower temperatures, it is expected that the QCD phase diagram exhibits a
rich structure, such as a firstorder phase transition between hadronic and
partonic matter which terminates in a critical point, or exotic phases like
quarkyonic matter. The discovery of these landmarks would be a breakthrough in
our understanding of the strong interaction and is therefore in the focus of
various highenergy heavyion research programs. The Compressed Baryonic Matter
(CBM) experiment at FAIR will play a unique role in the exploration of the QCD
phase diagram in the region of high netbaryon densities, because it is
designed to run at unprecedented interaction rates. Highrate operation is the
key prerequisite for highprecision measurements of multidifferential
observables and of rare diagnostic probes which are sensitive to the dense
phase of the nuclear fireball. The goal of the CBM experiment at SIS100
(sqrt(s_NN) = 2.7  4.9 GeV) is to discover fundamental properties of QCD
matter: the phase structure at large baryonchemical potentials (mu_B > 500
MeV), effects of chiral symmetry, and the equationofstate at high density as
it is expected to occur in the core of neutron stars. In this article, we
review the motivation for and the physics programme of CBM, including
activities before the start of data taking in 2022, in the context of the
worldwide efforts to explore highdensity QCD matter.

Let $\mathcal{L}$ be a $\mathcal{J}$subspace lattice on a Banach space $X$
over the real or complex field $\mathbb{F}$ and $ \mathrm{Alg}\mathcal{L}$ be
the associated $\mathcal{J}$subspace lattice algebras. In this paper, we
characterize the structure of a family $\{L_n\}_{n=0}^{\infty}:
\mathrm{Alg}\mathcal{L}\rightarrow \mathrm{Alg}\mathcal{L}$ of linear mappings
satisfying the condition
$$L_n([A, B])=\sum_{i+j=n}[L_i(A), L_j(B)]$$ for any $A,
B\in\mathrm{Alg}\mathcal{L}$ with $AB = 0$. Moreover, the family
$\{L_n\}_{n=0}^{\infty}: \mathrm{Alg}\mathcal{L}\rightarrow
\mathrm{Alg}\mathcal{L}$ of linear mappings satisfying $L_n([A,
B]_{\xi})=\sum_{i+j=n}[L_i(A), L_j(B)]_{\xi}$ for any $A,
B\in\mathrm{Alg}\mathcal{L}$ with $AB = 0$ and $1\neq \xi\in \mathbb{F}$ is
also considered in the current work.

Consider a twoway communication scenario where two singleantenna nodes,
operating under fullduplex mode, exchange information to one another through
the aid of a (fullduplex) multiantenna relay, and there is another
singleantenna node who intends to eavesdrop. The relay employs artificial
noise (AN) to interfere the eavesdropper's channel, and amplifyforward (AF)
Alamoutibased ranktwo beamforming to establish the twoway communication
links of the legitimate nodes. Our problem is to optimize the ranktwo
beamformer and AN covariance for sum secrecy rate maximization (SSRM). This
SSRM problem is nonconvex, and we develop an efficient solution approach using
semidefinite relaxation (SDR) and minorizationmaximization (MM). We prove that
SDR is tight for the SSRM problem and thus introduces no loss. Also, we
consider an inexact MM method where an approximately but computationally cheap
MM solution update is used in place of the exact update in conventional MM. We
show that this inexact MM method guarantees convergence to a stationary
solution to the SSRM problem. The effectiveness of our proposed approach is
further demonstrated by an energyharvesting scenario extension, and by
extensive simulation results.

In the CBM (Compressed Baryonic Matter) experiment constructed at the
Facility for Antiproton and Ion Research (Fair) at GSI, Darmstadt, Germany,
MRPC(Multigap Resistive Plate Chamber) is adopted to construct the large TOF
(TimeofFlight) system to achieve an unprecedented precision of hadron
identification, benefiting from its good time resolution, relatively high
efficiency and low building price. We have developed a kind of doubleended
readout strip MRPC. It uses low resistive glass to keep good performance of
time resolution under highrate condition. The differential double stack
structure of 2x4 gas gaps help to reduce the required high voltage to half.
There are 24 strips on one counter, and each is 270mm long, 7mm wide and the
interval is 3mm. Ground is placed onto the MRPC electrode and feed through is
carefully designed to match the 100 Ohm impedance of PADI electronics. The
prototype of this strip MRPC has been tested with cosmic ray, a 98% efficiency
and 60ps time resolution is gotten. In order to further examine the performance
of the detector working under higher particle flux rate, the prototype has been
tested in the 2014 October GSI beam time and 2015 February CERN beam time. In
both beam times a relatively high rate of 1 kHz/cm2 was obtained. The
calibration is done with CBM ROOT. A couple of corrections has been considered
in the calibration and analysis process (including timewalk correction, gain
correction, strip alignment correction and velocity correction) to access
actual counter performances such as efficiency and time resolution. An
efficiency of 97% and time resolution of 48ps are obtained. All these results
show that the realsize prototype is fully capable of the requirement of the
CBMTOF, and new designs such as selfsealing are modified into the strip
counter prototype to obtain even better performance.

The Xray Timing and Polarization (XTP) is a mission concept for a future
space borne Xray observatory and is currently selected for early phase study.
We present a new design of Xray polarimeter based on the time projection gas
chamber. The polarimeter, placed above the focal plane, has an additional rear
window that allows hard Xrays to penetrate (a transmission of nearly 80% at 6
keV) through it and reach the detector on the focal plane. Such a design is to
compensate the low detection efficiency of gas detectors, at a low cost of
sensitivity, and can maximize the science return of multilayer hard Xray
telescopes without the risk of moving focal plane instruments. The sensitivity
in terms of minimum detectable polarization, based on current instrument
configuration, is expected to be 3% for a 1mCrab source given an observing time
of 10^5 s. We present preliminary test results, including photoelectron tracks
and modulation curves, using a test chamber and polarized Xray sources in the
lab.

With the constant increase of accelerator luminosity, the rate requirements
of the MRPC detectors become important. In the same time, aging problem of the
detector has to be studied meticulously. An online aging test system is set up
in our Lab. The setup of the system is described and the purpose is to study
the performance stability during the long time running under high luminosity
environment. The high rate MRPC has been irradiated by Xray for 36 days and
accumulated charge density reached 0.1C/cm2. No obvious performance degradation
is observed for the detector.

Tomographic Gamma Scanning (TGS) is a technique used to assay the nuclide
distribution and radioactivity in nuclear waste drums. Both transmission and
emission scans are performed in TGS and the transmission image is used for the
attenuation correction in emission reconstructions. The error of the
transmission image, which is not considered by the existing reconstruction
algorithms, negatively affects the final results. An emission reconstruction
method based on Noise Equivalent Counts (NEC) is presented. Noises from the
attenuation image are concentrated to the projection data to apply the NEC
MaximumLikelihood ExpectationMaximization algorithm. Experiments are
performed to verify the effectiveness of the proposed method.

In terms of energy resolution, temporal response to burst events, and thermal
stability, lanthanum bromide doped with Ce is a much better choice than the
traditional NaI(Tl) scintillator for hard Xray astronomy. We present the test
results of a phoswich detector with a diameter of 101.6 mm consisting of 6 mm
thick LaBr3:Ce and 40 mm thick NaI(Tl), which is the largest one of this type
reported so far. The measured energy resolution is 10.6% at 60 keV, varying
inversely proportional to the square root of the energy, and the energy
nonlinearity is found to be less than 1%, as good as those of smaller
phoswiches. The coupled scintillators and phototube also show excellent
uniformity across the detecting surface, with a deviation of 0.7% on the pulse
amplitude produced by 60 keV gammarays. Thanks to the large ratio of light
decay times of NaI(Tl) and LaBr3:Ce, 250 ns vs. 16 ns, pulse shape
discrimination is much easier for this combination than for NaI(Tl)/CsI(Na). As
the light decay time of LaBr3:Ce is about 15 times faster than that of NaI(Tl),
this phoswich is more suitable for detection of bright, transient sources such
as gammaray bursts and soft gammaray repeaters. The internal activity of
lanthanum produces a count rate of about 6 counts/s at 37.5 keV in the
detector. This peak could be used for inflight spectral calibration and gain
correction.