• The NA62 experiment will begin taking data in 2015. Its primary purpose is a 10% measurement of the branching ratio of the ultrarare kaon decay $K^+ \to \pi^+ \nu \bar{ \nu }$, using the decay in flight of kaons in an unseparated beam with momentum 75 GeV/c.The detector and analysis technique are described here.
• In this Technical Design Report (TDR) we describe the SuperB detector that was to be installed on the SuperB e+e- high luminosity collider. The SuperB asymmetric collider, which was to be constructed on the Tor Vergata campus near the INFN Frascati National Laboratory, was designed to operate both at the Upsilon(4S) center-of-mass energy with a luminosity of 10^{36} cm^{-2}s^{-1} and at the tau/charm production threshold with a luminosity of 10^{35} cm^{-2}s^{-1}. This high luminosity, producing a data sample about a factor 100 larger than present B Factories, would allow investigation of new physics effects in rare decays, CP Violation and Lepton Flavour Violation. This document details the detector design presented in the Conceptual Design Report (CDR) in 2007. The R&D and engineering studies performed to arrive at the full detector design are described, and an updated cost estimate is presented. A combination of a more realistic cost estimates and the unavailability of funds due of the global economic climate led to a formal cancelation of the project on Nov 27, 2012.
• ### A prototype large-angle photon veto detector for the P326 experiment at CERN(0711.3398)

Nov. 21, 2007 physics.ins-det
The P326 experiment at the CERN SPS has been proposed with the purpose of measuring the branching ratio for the decay K^+ \to \pi^+ \nu \bar{\nu} to within 10%. The photon veto system must provide a rejection factor of 10^8 for \pi^0 decays. We have explored two designs for the large-angle veto detectors, one based on scintillating tiles and the other using scintillating fibers. We have constructed a prototype module based on the fiber solution and evaluated its performance using low-energy electron beams from the Frascati Beam-Test Facility. For comparison, we have also tested a tile prototype constructed for the CKM experiment, as well as lead-glass modules from the OPAL electromagnetic barrel calorimeter. We present results on the linearity, energy resolution, and time resolution obtained with the fiber prototype, and compare the detection efficiency for electrons obtained with all three instruments.