• The gyrotron is the high power millimeter wave source in the electron cyclotron resonance heating system for the tokamak. The cathode power supply is one of the most important ancillary devices for gyrotron. Some interesting transient phenomena about the cathode voltage and the cathode current was found in the gyrotron operation in the electron cyclotron resonance heating system for the Experimental Advanced Superconducting Tokamak. The cathode voltage drops to about 10% of the original value by about 90 {\mu}s in the overcurrent case, which is much longer than the 25 {\mu}s in the normal case. In order to explain these phenomena, an equivalent circuit model of the magnetron injection gun was proposed. The equivalent circuit is composed of parallel resistors and capacitors, and it can explain the test results very well. Using the equivalent circuit model to analyze gyrotrons may become an effective means of developing and operating an electron cyclotron heating system.
  • A coupling tunable D-band directional coupler is designed based on a novel coupling grid structure proposed in this letter. The designed directional coupler has excellent performance with ultra-wideband. The coupling can be tuned from -28.2 dB to -33.2 dB at 140 GHz by changing the angle of the coupling grid, and the dynamic range of the coupling is about 5 dB. The return loss is smaller than -15 dB in the whole D-band from 110 GHz to 170 GHz. A 3-dB coupler use the similar coupling structure is also designed. The coupling is 3.3144 dB at the center frequency of 140 GHz.
  • In this paper, an overcurrent protection system is designed to ensure the safety of the gyrotrons in the EAST ECRH system. Two overcurrent protection systems were established, a fast one and a slow one. The fast one uses the current transformers as the current sensors. The models of the current transformers and the superconducting magnet were built to analyze the effect of the environmental magnetic field on the current transformers using FI method. The analysis results show that the magnetic induction at the position near the current transformers must less than 0.002 T, i.e., the current transformers should be placed at a distance greater than 2.2 meters from the magnet center to ensure its normal work. The slow one uses the shunt to monitor the currents. An anti-fuse FPGA and a timer is used to realize the signal processing in the fast protection circuit and the slow protection circuit respectively. The response time of the fast protection circuit is less than 100 ns, and the response time of the slow protection circuit is less than 31 {\mu}s.
  • In this paper, the calorimetric power measurement method for electron cyclotron resonance heating system on EAST are presented. This method requires measurement of the water flow through the cooling circuits and the input and output water temperatures in each cooling circuit. Usually, the inlet water temperature is controlled to be stable to get more accurate results. The influence of the inlet water temperature change on the measurement results is analyzed for the first time in this paper. A novel temperature calibration method is proposed also. This kind of calibration method is accurate and effective, and can be easily implemented.
  • We report European Very Long Baseline Interferometry Network (EVN) radio continuum observations of ASASSN-14li, one of the best studied tidal disruption events (TDEs) to date. At 1.7 GHz with ~12x6mas resolution, the emission is unresolved. At 5.0 GHz with ~3x2mas resolution, the radio emission shows an extended structure that can be modeled with two components: a core-like component and a fainter, possibly elongated source 4.3mas (~2pc) away. Our observations are not conclusive as to the nature of the components, but three scenarios are discussed. One possibility is a core-jet/outflow morphology, thus making of ASASSN-14li the first TDE jet/outflow directly imaged. For this case, the projected separation between the two components can only be explained by superluminal motion, rather than the lower velocities inferred from low-resolution radio observations. However, typical fast moving jets have brightness temperatures ~5 orders of magnitude higher than we find, thus making this scenario less likely. The second possibility is that we are imaging a non-relativistic jet from past AGN/TDE activity. In this case a past TDE is preferred given that the spatial extension and radio luminosity of the elongated component are consistent with the theoretical predictions for a TDE outflow. Alternatively, the two sources could indicate the presence of a binary black hole, which would then naturally explain the enhanced TDE rates of post-starburst galaxies. Future EVN observations will help us to distinguish between these scenarios.
  • The present work reports on a feasibility study commissioned by the Chinese Academy of Sciences of China to explore various possible mission options to detect gravitational waves in space alternative to that of the eLISA/LISA mission concept. Based on the relative merits assigned to science and technological viability, a few representative mission options descoped from the ALIA mission are considered. A semi-analytic Monte Carlo simulation is carried out to understand the cosmic black hole merger histories starting from intermediate mass black holes at high redshift as well as the possible scientific merits of the mission options considered in probing the light seed black holes and their coevolution with galaxies in early Universe. The study indicates that, by choosing the armlength of the interferometer to be three million kilometers and shifting the sensitivity floor to around one-hundredth Hz, together with a very moderate improvement on the position noise budget, there are certain mission options capable of exploring light seed, intermediate mass black hole binaries at high redshift that are not readily accessible to eLISA/LISA, and yet the technological requirements seem to within reach in the next few decades for China.
  • Tidal stellar disruptions have traditionally been discussed as a probe of the single, massive black holes (MBHs) that are dormant in the nuclei of galaxies. In Chen et al. (2009), we used numerical scattering experiments to show that three-body interactions between bound stars in a stellar cusp and a non-evolving "hard" MBH binary will also produce a burst of tidal disruptions, caused by a combination of the secular "Kozai effect" and by close resonant encounters with the secondary hole. Here we derive basic analytical scalings of the stellar disruption rates with the system parameters, assess the relative importance of the Kozai and resonant encounter mechanisms as a function of time, discuss the impact of general relativistic (GR) and extended stellar cusp effects, and develop a hybrid model to self-consistently follow the shrinking of an MBH binary in a stellar background, including slingshot ejections and tidal disruptions. In the case of a fiducial binary with primary hole mass M_1=10^7\msun and mass ratio q=M_2/M_1=1/81, embedded in an isothermal cusp, we derive a stellar disruption rate \dot{N_*} ~ 0.2/yr lasting ~ 3X10^5 yr. This rate is 3 orders of magnitude larger than the corresponding value for a single MBH fed by two-body relaxation, confirming our previous findings. For q<<0.01, the Kozai/chaotic effect could be quenched due to GR/cusp effects by an order of magnitude, but even in this case the stellar-disruption rate is still two orders of magnitude larger than that given by standard relaxation processes around a single MBH. Our results suggest that >~10% of the tidal-disruption events may originate in MBH binaries.
  • We present the results of our optical monitoring of the BL Lacertae object OJ 287 during the first half of 2005. The source did not show large-amplitude variations during this period and was in a relatively quiescent state. A possible period of 40 days was derived from its light curves in three BATC wavebands. A bluer-when-brighter chromatism was discovered, which is different from the extremely stable color during the outburst in 1994--96. The different color behaviors imply different variation mechanisms in the two states. We then re-visited the optical data on OJ 287 from the OJ-94 project and found as well a probable period of 40 days in its optical variability during the late-1994 outburst. The results suggest that two components contribute to the variability of OJ 287 during its outburst state. The first component is the normal {\sl blazar} variation. This component has an amplitude similar to that of the quiescent state and also may share a similar periodicity. The second component can be taken as a `low-frequency modulation' to the first component. It may be induced by the interaction of the assumed binary black holes in the center of this object. The 40-day period may be related to the helical structure of the magnetic field at the base of the jet, or to the orbital motion close to the central primary black hole.