-
The Long Baseline Neutrino Facility (LBNF) will utilize a beamline located at
Fermilab to provide and aim a neutrino beam of sufficient intensity and
appropriate energy range toward the Deep Underground Neutrino Experiment (DUNE)
detectors, placed deep underground at the SURF Facility in Lead, South Dakota.
The primary proton beam (60-120 GeV) will be extracted from the MI-10 section
of Fermilab's Main Injector. Neutrinos will be produced when the protons
interact with a solid target to produce mesons which will be subsequently
focused by magnetic horns into a 194m long decay pipe where they decay into
muons and neutrinos. The parameters of the facility were determined taking into
account the physics goals, spatial and radiological constraints, and the
experience gained by operating the NuMI facility at Fermilab. The Beamline
facility is designed for initial operation at a proton-beam power of 1.2 MW,
with the capability to support an upgrade to 2.4 MW. LBNF/DUNE obtained CD-1
approval in November 2015. We discuss here the design status and the associated
challenges as well as the R&D and plans for improvements before baselining the
facility.
-
This paper describes the hardware and operations of the Neutrinos at the Main
Injector (NuMI) beam at Fermilab. It elaborates on the design considerations
for the beam as a whole and for individual elements. The most important design
details of individual components are described. Beam monitoring systems and
procedures, including the tuning and alignment of the beam and NuMI long-term
performance, are also discussed.
-
The Mu2e experiment at Fermilab will search for charged lepton flavor
violation via the coherent conversion process mu- N --> e- N with a sensitivity
approximately four orders of magnitude better than the current world's best
limits for this process. The experiment's sensitivity offers discovery
potential over a wide array of new physics models and probes mass scales well
beyond the reach of the LHC. We describe herein the preliminary design of the
proposed Mu2e experiment. This document was created in partial fulfillment of
the requirements necessary to obtain DOE CD-2 approval.
This paper describes the hardware and operations of the Neutrinos at the Main Injector (NuMI) beam at Fermilab. It elaborates on the design considerations for the beam as a whole and for individual elements. The most important design details of individual components are described. Beam monitoring systems and procedures, including the tuning and alignment of the beam and NuMI long-term performance, are also discussed.