• Absolute Determination of Optical Constants by a Direct Physical Modeling of Reflection Electron Energy Loss Spectra(1609.02639)

We present an absolute extraction method of optical constants of metal from the measured reflection electron energy loss (REELS) spectra by using the recently developed reverse Monte Carlo (RMC) technique. The method is based on a direct physical modeling of electron elastic and electron inelastic scattering near the surface region where the surface excitation becomes important to fully describe the spectrum loss feature intensity in relative to the elastic peak intensity. An optimization procedure of oscillator parameters appeared in the energy loss function (ELF) for describing electron inelastic scattering due to the bulk- and surface-excitations was performed with the simulated annealing method by a successive comparison between the measured and Monte Carlo simulated REELS spectra. The ELF and corresponding optical constants of Fe were obtained from the REELS spectra measured at incident energies of 1000, 2000 and 3000 eV. The validity of the present optical data has been verified with the f- and ps-sum rules showing the accuracy and applicability of the present approach. Our data are also compared with previous optical data from other sources.
• Nanoscale characterization of thin immersion silver coatings on copper substrates(1502.01579)

Feb. 5, 2015 cond-mat.mtrl-sci
Microelectronic-grade copper foils were immersion silver plated in a home-made non-cyanide alkaline silver nitrate - thiosulfate solution and in two commercially available industrial baths via contact reductive precipitation. The concentration depth profiles of the freshly deposited silver layers were afterwards analyzed at nanoscale resolution by means of Secondary Neutral Mass Spectrometry (SNMS) and Glow Discharge Optical Emission Spectroscopy (GDOES). The thickness of deposited silver layers obtained with 30-60 s immersion time were in the range of 50-150 nm, depending on the parameters of the immersion procedure. Slight contamination of sulfur from the thiosulfate bath was detectable. Traces of Cr and Na could be observed as well around the interface between the copper substrate and silver deposit. Results also indicate that storage for longer time in air especially at higher than ambient temperatures induces a kind of ageing effect in the deposited layer, changing its composition. In case of samples prepared from home-made solution increasing amounts of copper together with its corrosion products became detectable.
• Independent identification of meteor showers in EDMOND database(1406.6598)

June 25, 2014 astro-ph.EP
Cooperation and data sharing among national networks and International Meteor Organization Video Meteor Database (IMO VMDB) resulted in European viDeo MeteOr Network Database (EDMOND). The current version of the database (EDMOND 5.0) contains 144 751 orbits collected from 2001 to 2014. In our survey we used EDMOND database in order to identify existing and new meteor showers in the database. In the first step of the survey, using Dsh criterion we found groups around each meteor within similarity threshold. Mean parameters of the groups were calculated and compared using a new function based on geocentric parameters (solar longitude, right ascension, declination, and geocentric velocity). Similar groups were merged into final clusters (representing meteor showers), and compared with IAU Meteor Data Center list of meteor showers. This paper presents the results obtained by the proposed methodology.
• Confirmation and characterization of IAU temporary meteor showers in EDMOND database(1405.1783)

May 8, 2014 astro-ph.EP, astro-ph.IM
The European viDeo MeteOr Network Database (EDMOND) is a database of video meteor orbits resulting from cooperation and data sharing among several European national networks and the International Meteor Organization Video Meteor Network, IMO VMN. At present, the 4th version of the EDMOND database, which contains 83 369 video meteor orbits, has been released. The first results of the database analysis, in which we studied minor streams, are presented. Using the radiant-geocentric velocity method we identified 267 meteor showers, among them 67 established showers and 200 from the working list of the IAU MDC. Making a more detailed examination, we clearly identified 22 showers of 65 pro tempore showers of the working list of the IAU MDC (updated in August 2013). The identification of 18 meteor showers was questionable, while 25 showers were not found. For all the identified temporary meteor showers, we list the weighted mean orbital elements, the radiant position and the geocentric velocity.
• Automatic Detection of Asteroids and Meteoroids - A Wide Field Survey(1401.4758)

Jan. 28, 2014 astro-ph.EP, astro-ph.IM
We propose a low-cost robotic optical survey aimed at $1-300$ m Near Earth Objects (NEO) based on four state-of-the-art telescopes having extremely wide field of view. The small Near-Earth Asteroids (NEA) represent a potential risk but also easily accessible space resources for future robotic or human space in-situ exploration, or commercial activities. The survey system will be optimized for the detection of fast moving - trailed - asteroids, space debris and will provide real-time alert notifications. The expected cost of the system including 1-year development and 2-year operation is 1,000,000 EUR. The successful demonstration of the system will promote cost-efficient ADAM-WFS (Automatic Detection of Asteroids and Meteoroids - A Wide Field Survey) systems to be built around the world.
• Structural Analysis of Combustion Mechanisms(1304.7964)

Aug. 5, 2013 physics.chem-ph
39 detailed mechanisms for combustion of hydrogen, carbon monoxide and methanol are investigated using ReactionKinetics, a Mathematica based package. The obtained results in most cases do not depend on the choice of reaction rate coefficients, the methods only use the underlying sets of reaction steps, thus the results are robust and general in a certain sense. These investigations can be used before or in parallel with usual numerical investigations, such as pathway analysis, sensitivity analysis, parameter estimation or simulation. The considered hydrogen mechanisms shared 90% of common reaction steps. The CO combustion mechanisms show a larger variety both in species and in reaction steps. There exist only a few methanol combustion mechanisms; the big differences between them shows that the modelling community is only at the very beginning of exploring this process. The package and the methods may be useful for automatic mechanism generations, testing, comparing and reduction of mechanisms as well, especially in the case of large systems.
• Quadratic First Integrals of Kinetic Differential Equations(1307.7957)

July 30, 2013 math.CA, nlin.SI
Classes of kinetic differential equations are delineated which do have a quadratic first integral, and classes which can not have one. Example reactions corresponding to the obtained kinetic differential equations are shown, and a few figures showing the trajectories of the corresponding systems are also included. Connections to other areas are mentioned and unsolved problems collected. The new results are theoretical, although computational tools are heavily used. Applications from biology and combustion theory will come later.
• Microscopic Reversibility or Detailed Balance in Ion Channel Models(1109.4262)

Sept. 20, 2011 math.CA, q-bio.MN
Mass action type deterministic kinetic models of ion channels are usually constructed in such a way as to obey the principle of detailed balance (or, microscopic reversibility) for two reasons: first, the authors aspire to have models harmonizing with thermodynamics, second, the conditions to ensure detailed balance reduce the number of reaction rate coefficients to be measured. We investigate a series of ion channel models which are asserted to obey detailed balance, however, these models violate mass conservation and in their case only the necessary conditions (the so-called circuit conditions) are taken into account. We show that ion channel models have a very specific structure which makes the consequences true in spite of the imprecise arguments. First, we transform the models into mass conserving ones, second, we show that the full set of conditions ensuring detailed balance (formulated by Feinberg) leads to the same relations for the reaction rate constants in these special cases, both for the original models and the transformed ones.
• ReactionKinetics---A Mathematica Package with Applications I. Requirements for a Reaction Kinetics Package(1107.3093)

July 15, 2011 math.NA
Requirements are formulated for a reaction kinetics package to be useful for an as wide as possible circle of users and illustrated with examples using ReactionKinetics, a Mathematica based package.
• ReactionKinetics - A Mathematica package with applications II. Computational problems when building a reaction kinetics package(1107.3098)

July 15, 2011 math.NA
Treating a realistic problem in any field of reaction kinetics raises a series of problems: we review these illustrated with examples using ReactionKinetics, a Mathematica based package.
• A detailed study is presented of the expected performance of the ATLAS detector. The reconstruction of tracks, leptons, photons, missing energy and jets is investigated, together with the performance of b-tagging and the trigger. The physics potential for a variety of interesting physics processes, within the Standard Model and beyond, is examined. The study comprises a series of notes based on simulations of the detector and physics processes, with particular emphasis given to the data expected from the first years of operation of the LHC at CERN.
• Response Uniformity of the ATLAS Liquid Argon Electromagnetic Calorimeter(0709.1094)

Sept. 7, 2007 physics.ins-det
The construction of the ATLAS electromagnetic liquid argon calorimeter modules is completed and all the modules are assembled and inserted in the cryostats. During the production period four barrel and three endcap modules were exposed to test beams in order to assess their performance, ascertain the production quality and reproducibility, and to scrutinize the complete energy reconstruction chain from the readout and calibration electronics to the signal and energy reconstruction. It was also possible to check the full Monte Carlo simulation of the calorimeter. The analysis of the uniformity, resolution and extraction of constant term is presented. Typical non-uniformities of 0.5% and typical global constant terms of 0.6% are measured for the barrel and end-cap modules.
• Hadronic Calibration of the ATLAS Liquid Argon End-Cap Calorimeter in the Pseudorapidity Region 1.6 < |eta| < 1.8 in Beam Tests(physics/0407009)

July 2, 2004 physics.ins-det
A full azimuthal phi-wedge of the ATLAS liquid argon end-cap calorimeter has been exposed to beams of electrons, muons and pions in the energy range 6 GeV <= E <= 200 GeV at the CERN SPS. The angular region studied corresponds to the ATLAS impact position around the pseudorapidity interval 1.6 < |eta| < 1.8. The beam test set-up is described. A detailed study of the performance is given as well as the related intercalibration constants obtained. Following the ATLAS hadronic calibration proposal, a first study of the hadron calibration using a weighting ansatz is presented. The results are compared to predictions from Monte Carlo simulations, based on GEANT 3 and GEANT 4 models.