-
This white paper summarizes the workshop "U.S. Cosmic Visions: New Ideas in
Dark Matter" held at University of Maryland on March 23-25, 2017.
-
This report, based on the Dark Sectors workshop at SLAC in April 2016,
summarizes the scientific importance of searches for dark sector dark matter
and forces at masses beneath the weak-scale, the status of this broad
international field, the important milestones motivating future exploration,
and promising experimental opportunities to reach these milestones over the
next 5-10 years.
-
The Heavy Photon Search (HPS), an experiment to search for a hidden sector
photon in fixed target electroproduction, is preparing for installation at the
Thomas Jefferson National Accelerator Facility (JLab) in the Fall of 2014. As
the first stage of this project, the HPS Test Run apparatus was constructed and
operated in 2012 to demonstrate the experiment's technical feasibility and to
confirm that the trigger rates and occupancies are as expected. This paper
describes the HPS Test Run apparatus and readout electronics and its
performance. In this setting, a heavy photon can be identified as a narrow peak
in the e$^+$e$^-$ invariant mass spectrum, above the trident background or as a
narrow invariant mass peak with a decay vertex displaced from the production
target, so charged particle tracking and vertexing are needed for its
detection. In the HPS Test Run, charged particles are measured with a compact
forward silicon microstrip tracker inside a dipole magnet. Electromagnetic
showers are detected in a PbW0$_{4}$ crystal calorimeter situated behind the
magnet, and are used to trigger the experiment and identify electrons and
positrons. Both detectors are placed close to the beam line and split
top-bottom. This arrangement provides sensitivity to low-mass heavy photons,
allows clear passage of the unscattered beam, and avoids the spray of degraded
electrons coming from the target. The discrimination between prompt and
displaced e$^+$e$^-$ pairs requires the first layer of silicon sensors be
placed only 10~cm downstream of the target. The expected signal is small, and
the trident background huge, so the experiment requires very large statistics.
Accordingly, the HPS Test Run utilizes high-rate readout and data acquisition
electronics and a fast trigger to exploit the essentially 100% duty cycle of
the CEBAF accelerator at JLab.
-
This report, Volume IV of the International Linear Collider Reference Design
Report, describes the detectors which will record and measure the charged and
neutral particles produced in the ILC's high energy e+e- collisions. The
physics of the ILC, and the environment of the machine-detector interface, pose
new challenges for detector design. Several conceptual designs for the detector
promise the needed performance, and ongoing detector R&D is addressing the
outstanding technological issues. Two such detectors, operating in push-pull
mode, perfectly instrument the ILC interaction region, and access the full
potential of ILC physics.
-
This report summarises the activity of the E3 working group "Experimental
Approaches at Linear Colliders". The group was charged with examining
critically the physics case for a linear collider of energy of order 1 TeV as
well as the cases for higher energy machines, assessing the performance
requirements and exploring the viability of several special options. In
addition it was asked to identify the critical areas where R&D is required.
-
(Report of the Top Physics working group at the 1996 DPF/DPB Snowmass
workshop, to appear in the proceedings). We discuss the study of the top quark
at future experiments and machines. Top's large mass makes it a unique probe of
physics at the natural electroweak scale. We emphasize measurements of the top
quark's mass, width, and couplings, as well as searches for rare or nonstandard
decays, and discuss the complementary roles played by hadron and lepton
colliders.