-
Small-diameter muon drift tube (sMDT) detectors have been developed for
upgrades of the ATLAS muon spectrometer. With a tube diameter of 15 mm, they
provide an about an order of magnitude higher rate capability than the present
ATLAS muon tracking detectors, the MDT chambers with 30 mm tube diameter. The
drift-tube design and the construction methods have been optimised for mass
production and allow for complex shapes required for maximising the acceptance.
A record sense wire positioning accuracy of 0.005 mm has been achieved with the
new design. 14 new sMDT chambers are already operational in ATLAS, further 16
are under construction for installation in the 2019-2020 LHC shutdown. For the
upgrade of the barrel muon spectrometer for High-Luminosity LHC, 96 sMDT
chambers will be contructed between 2020 and 2024.
-
The High-Luminosity LHC (HL-LHC) will provide the unique opportunity to
explore the nature of physics beyond the Standard Model of strong and
electroweak interactions. Highly selective first-level triggers are essential
for the physics programme of the ATLAS experiment at HL-LHC, where the
instantaneous luminosity will exceed the instantaneous LHC Run 1 luminosity by
about an order of magnitude. The ATLAS first-level muon trigger rate is
dominated by low momentum muons, which are accepted because of the moderate
momentum resolution of the RPC and TGC trigger chambers. This limitation can be
overcome by exploiting the data of the precision Muon Drift-Tube (MDT) chambers
in the first-level trigger decision. This requires continuous fast transfer of
the MDT hits to the off-detector trigger logic and fast track reconstruction
algorithms. The reduction of the muon trigger rate achievable with the proposed
new trigger concept, the performance of a novel fast track reconstruction
algorithm, and the first hardware demonstration of the scheme with muon
testbeam data taken at the CERN Gamma Irradiation Facility are discussed.
-
The inclusive production of {\Lambda} hyperons in proton-proton collisions at
$\sqrt{s}$ = 3.18 GeV was measured with HADES at the GSI Helmholtzzentrum f\"ur
Schwerionenforschung in Darmstadt. The experimental data are compared to a
data-based model for individual exclusive {\Lambda} production channels in the
same reaction. The contributions of intermediate resonances such as
{\Sigma}(1385), {\Delta}++ or N* are considered in detail. In particular, the
result of a partial wave analysis is accounted for the abundant pK$^+${\Lambda}
final state. Model and data show a reasonable agreement at mid rapidities,
while a difference is found for larger rapidities. A total {\Lambda} production
cross section in p+p collisions at $\sqrt{s}$ = 3.18 GeV of {\sigma}(pp $\to$
{\Lambda} + X) = 207.3 $\pm$ 1.3 +6.0 -7.3 (stat.) $\pm$ 8.4 (syst.) +0.4 -0.5
(model) {\mu}b is found.
-
We report on the first measurement of $p\Lambda$ and $pp$ correlations via
the femtoscopy method in p+Nb reactions at $\mathrm{\sqrt{s_{NN}}=3.18}
~\mathrm{GeV}$, studied with the High Acceptance Di-Electron Spectrometer
(HADES). By comparing the experimental correlation function to model
calculations, a source size for $pp$ pairs of $r_{0,pp}=2.02 \pm
0.01(\mathrm{stat})^{+0.11}_{-0.12} (\mathrm{sys}) ~\mathrm{fm}$ and a slightly
smaller value for $p\Lambda$ of $r_{0,\Lambda p}=1.62 \pm
0.02(\mathrm{stat})^{+0.19}_{-0.08}(\mathrm{sys}) ~\mathrm{fm}$ is extracted.
Using the geometrical extent of the particle emitting region, determined
experimentally with $pp$ correlations as reference together with a source
function from a transport model, it is possible to study different sets of
scattering parameters. The $p\Lambda$ correlation is proven sensitive to
predicted scattering length values from chiral effective field theory. We
demonstrate that the femtoscopy technique can be used as valid alternative to
the analysis of scattering data to study the hyperon-nucleon interaction.
-
Small-diameter Muon Drift Tube (sMDT) chambers have been developed for the
ATLAS muon detector upgrade. They possess an improved rate capability and a
more compact design with respect to the existing chambers, which allows to
equip detector regions uninstrument at present. The chamber assembly methods
have been optimized for mass production, while the sense wire positioning
accuracy is improved to below ten microns. The chambers will be ready for
installation in the winter shutdown 2016/17 of the Large Hadron Collider. The
design and construction of the new sMDT chambers for ATLAS will be discussed as
well as measurements of their precision and performance.