• Iron-free CCT magnet design offers many advantages, one being the excellent field quality and the absence of multipole components. However, edge effects are present, although they tend to integrate out over the length of the magnet. Many modern accelerator applications, however, require that these magnets are placed in an area of rapidly varying optics parameters, so magnets with greatly reduced edge effects have an advantage. We have designed such a magnet (a quadrupole) by adding multipole components of the opposite sign to the edge distortions of the magnet. A possible application could be the final focus magnets of the FCC-ee, where beam sizes at the entry and exit point of the magnets vary by large factors. We have then used this technique to effectively eliminate cross talk between adjacent final focus quadrupoles for the incoming and outgoing beams.
  • A beam optics scheme has been designed for the Future Circular Collider-e+e- (FCC-ee). The main characteristics of the design are: beam energy 45 to 175 GeV, 100 km circumference with two interaction points (IPs) per ring, horizontal crossing angle of 30 mrad at the IP and the crab-waist scheme [1] with local chromaticity correction. The crab-waist scheme is implemented within the local chromaticity correction system without additional sextupoles, by reducing the strength of one of the two sextupoles for vertical chromatic correction at each side of the IP. So-called "tapering" of the magnets is applied, which scales all fields of the magnets according to the local beam energy to compensate for the effect of synchrotron radiation (SR) loss along the ring. An asymmetric layout near the interaction region reduces the critical energy of SR photons on the incoming side of the IP to values below 100 keV, while matching the geometry to the beam line of the FCC proton collider (FCC-hh) [2] as closely as possible. Sufficient transverse/longitudinal dynamic aperture (DA) has been obtained, including major dynamical effects, to assure an adequate beam lifetime in the presence of beamstrahlung and top-up injection. In particular, a momentum acceptance larger than +/-2% has been obtained, which is better than the momentum acceptance of typical collider rings by about a factor of 2. The effects of the detector solenoids including their compensation elements are taken into account as well as synchrotron radiation in all magnets. The optics presented in this paper is a step toward a full conceptual design for the collider. A number of issues have been identified for further study.
  • The design of the region close to the interaction point of the FCC-ee experiments is especially challenging. The beams collide at an angle (+-15 mrad) in the high-field region of the detector solenoid. Moreover, the very low vertical beta_y* of the machine necessitates that the final focusing quadrupoles have a distance from the IP (L*) of around 2 m and therefore are inside the main detector solenoid. The beams should be screened from the effect of the detector magnetic field, and the emittance blow-up due to vertical dispersion in the interaction region should be minimized, while leaving enough space for detector components. Crosstalk between the two final focus quadrupoles, only about 6 cm apart at the tip, should also be minimized.
  • The FCC-ee accelerator is considered within the FCC design study as a possible first step towards the ultimate goal of a 100 TeV hadron collider. It is a high luminosity e+e- storage ring collider, designed to cover energies of around 90, 160, 240 and 350GeV ECM (for the Z peak, the WW threshold, the ZH and ttbar cross-section maxima respectively) leading to different operating modes. We report on the current status of the design study, on the most promising concepts and relevant challenges. The expected luminosity performance at all energies, and first studies on transverse polarization for beam energy calibrations will be presented.
  • The FCC (Future Circular Collider) study represents a vision for the next large project in high energy physics, comprising an 80-100 km tunnel that can house a future 100 TeV hadron collider. The study also includes a high luminosity e+e- collider operating in the centre-of-mass energy range of 90-350 GeV as a possible intermediate step, the FCC-ee. The FCC-ee aims at definitive electro-weak precision measurements of the Z, W, H and top particles, and search for rare phenomena. Although FCC-ee is based on known technology, the goal performance in luminosity and energy calibration make it quite challenging. During 2014 the study went through an exploration phase. The study has now entered its second year and the aim is to produce a conceptual design report during the next three to four years. We here report on progress since the last IPAC conference.
  • Renewed interest in circular e+e- colliders has spurred designs of single beam-pipe machines, like the CEPC in China, and double beam pipe ones, such as the FCC-ee effort at CERN. Single beam-pipe designs profit from lower costs but are limited by the number of bunches that can be accommodated in the machine. We analyse these performance limitations and propose a solution that can accommodate O(1000) bunches while keeping more than 90% of the ring with a single beam pipe.
  • The FCC-ee aims to improve on electroweak precision measurements, with goals of 100 keV on the Z mass and width, and a fraction of MeV on the W mass. Compared to LEP, this implies a much improved knowledge of the centre-of-mass energy when operating at the Z peak and WW threshold. This can be achieved by making systematic use of resonant depolarization. A number of issues have been identified, due in particular to the long polarization times. However the smaller emittance and energy spread of FCC-ee with respect to LEP should help achieve a much improved performance.
  • In this paper I will commend on the early CEPC design as of October 2014. In particular I will comment on the choice of circumference, minimum and maximum energy, number of collision points and target luminosity. I will finish with suggestions to increase performance with minimum incremental cost.
  • In this paper we deal with aspects of transverse polarization for the purpose of energy calibration of proposed circular colliders like the FCC-ee and the CEPC. The main issues of such a measurement will be discussed. The possibility of using this method to accurately determine the energy at the WW threshold as well as the Z peak will be addressed. The use of wigglers for reducing long polarization times will be discussed and a possible strategy will be presented for minimising the energy uncertainty error in these large machines.
  • CERN has recently launched the Future Circular Collider (FCC) study to deal with all aspects of an ambitious post-LHC possible programme. The emphasis of the study is on a 100 TeV proton collider to be housed in a 80-100 km new ring in the Geneva region. An electron machine will also be considered as a possible intermediate first step (FCC-ee). The study benefits from earlier work done in the context of TLEP and has already published a parameter table, to serve as the basis for the work to be done. The study aims to publish a conceptual design report at around 2018. The recent discovery of a light Higgs boson has opened up considerable interest in circular e+e- Higgs factories around the world. FCC-ee is capable of very high luminosities in a wide centre-of-mass (ECM) spectrum from 90 to 350 GeV. This allows the very precise study of the Z, W and H bosons as well as the top quark, allowing for meaningful precision tests of the closure of the Standard Model.
  • The discovery of a relatively light Higgs opens up the possibility of circular e+e- Higgs factories. LEP3 is such a machine with emphasis on low cost, since it re-uses most of the LHC infrastructure, including the tunnel, cryogenics, and the two general-purpose LHC experiments Atlas and CMS, with some modifications. The energy reach of LEP3 is 240GeV in the centre of mass, close to the ZH production maximum. Alternative tunnel diameters and locations are possible, including a Higgs factory housed in the UNK tunnel, UNK-L, and a machine located in a new 80 km tunnel in the Geneva region, TLEP, than can further house a very high energy pp collider. The design merits further consideration and a detailed study should be performed, so that LEP3 can be one more option available to the community for the next step in High Energy Physics.
  • We review the different performance limitations of circular colliders, namely the limitations of energy reach, maximum attainable luminosity and beam lifetime. This paper considers only head-on collisions. We consider the range of beam energies from 45GeV to 250 GeV and collider circumferences from 20 to 100kms.
  • M. Bicer, H. Duran Yildiz, I. Yildiz, G. Coignet, M. Delmastro, T. Alexopoulos, C. Grojean, S. Antusch, T. Sen, H.-J. He, K. Potamianos, S. Haug, A. Moreno, A. Heister, V. Sanz, G. Gomez-Ceballos, M. Klute, M. Zanetti, L.-T. Wang, M. Dam, C. Boehm, N. Glover, F. Krauss, A. Lenz, M. Syphers, C. Leonidopoulos, V. Ciulli, P. Lenzi, G. Sguazzoni, M. Antonelli, M. Boscolo, U. Dosselli, O. Frasciello, C. Milardi, G. Venanzoni, M. Zobov, J. van der Bij, M. de Gruttola, D.-W. Kim, M. Bachtis, A. Butterworth, C.Bernet, C. Botta, F. Carminati, A. David, D. d'Enterria, L. Deniau, G. Ganis, B. Goddard, G. Giudice, P. Janot, J. M. Jowett, C. Lourenco, L. Malgeri, E. Meschi, F. Moortgat, P. Musella, J. A. Osborne, L. Perrozzi, M. Pierini, L. Rinolfi, A. de Roeck, J. Rojo, G. Roy, A. Sciaba, A. Valassi, C. S. Waaijer, J. Wenninger, H. Woehri, F. Zimmermann, A. Blondel, M. Koratzinos, P. Mermod, Y. Onel, R. Talman, E. Castaneda Miranda, E. Bulyak, D. Porsuk, D. Kovalskyi, S. Padhi, P. Faccioli, J. R. Ellis, M. Campanelli, Y. Bai, M. Chamizo, R. B. Appleby, H. Owen, H. Maury Cuna, C. Gracios, G. A. Munoz-Hernandez, L. Trentadue, E. Torrente-Lujan, S. Wang, D. Bertsche, A. Gramolin, V. Telnov, M. Kado, P. Petroff, P. Azzi, O. Nicrosini, F. Piccinini, G. Montagna, F. Kapusta, S. Laplace, W. da Silva, N. Gizani, N. Craig, T. Han, C. Luci, B. Mele, L. Silvestrini, M. Ciuchini, R. Cakir, R. Aleksan, F. Couderc, S. Ganjour, E. Lancon, E. Locci, P. Schwemling, M. Spiro, C. Tanguy, J. Zinn-Justin, S. Moretti, M. Kikuchi, H. Koiso, K. Ohmi, K. Oide, G. Pauletta, R. Ruiz de Austri, M. Gouzevitch, S. Chattopadhyay
    Dec. 11, 2013 hep-ph, hep-ex
    The discovery by the ATLAS and CMS experiments of a new boson with mass around 125 GeV and with measured properties compatible with those of a Standard-Model Higgs boson, coupled with the absence of discoveries of phenomena beyond the Standard Model at the TeV scale, has triggered interest in ideas for future Higgs factories. A new circular e+e- collider hosted in a 80 to 100 km tunnel, TLEP, is among the most attractive solutions proposed so far. It has a clean experimental environment, produces high luminosity for top-quark, Higgs boson, W and Z studies, accommodates multiple detectors, and can reach energies up to the t-tbar threshold and beyond. It will enable measurements of the Higgs boson properties and of Electroweak Symmetry-Breaking (EWSB) parameters with unequalled precision, offering exploration of physics beyond the Standard Model in the multi-TeV range. Moreover, being the natural precursor of the VHE-LHC, a 100 TeV hadron machine in the same tunnel, it builds up a long-term vision for particle physics. Altogether, the combination of TLEP and the VHE-LHC offers, for a great cost effectiveness, the best precision and the best search reach of all options presently on the market. This paper presents a first appraisal of the salient features of the TLEP physics potential, to serve as a baseline for a more extensive design study.
  • The paper arXiv:1308.0735 questions some of the technical assumptions made by the TLEP Steering Group when estimating in arXiv:1305.6498 the power requirement for the very high energy e+e- storage ring collider TLEP. We show that our assumptions are based solidly on CERN experience with LEP and the LHC, as well accelerators elsewhere, and confirm our earlier baseline estimate of the TLEP power consumption.
  • The discovery of H(126) has renewed interest in circular e+e- colliders that can operate as Higgs factories, which benefit from three unique characteristics: i) high luminosity and reliability, ii) the availability of several interaction points, iii) superior beam energy accuracy. TLEP is an e+e- storage ring of 80-km circumference that can operate with very high luminosity from the Z peak (90 GeV) to the top quark pair threshold (350 GeV). It can achieve transverse beam polarization at the Z peak and WW threshold, giving it unparalleled accuracy on the beam energy. A preliminary study indicates that an 80 km tunnel could be constructed around CERN. Such a tunnel would allow a 100 TeV proton-proton collider to be established in the same ring (VHE-LHC), offering a long term vision.
  • The recent discovery of a light Higgs boson has opened up considerable interest in circular e+e- Higgs factories around the world. We report on the progress of the TLEP concept since last year. TLEP is an e+e- circular collider capable of very high luminosities in a wide centre-of-mass (ECM) spectrum from 90 to 350 GeV. TLEP could be housed in a new 80 to 100 km tunnel in the Geneva region. The design can be adapted to different ring circumference (e.g. LEP3 in the 27 km LHC tunnel). TLEP is an ideal complementary machine to the LHC thanks to high luminosity, exquisite determination of ECM and the possibility of four interaction points, both for precision measurements of the Higgs boson properties and for precision tests of the closure of the Standard Model from the Z pole to the top threshold.