-
List of contributions from the Cherenkov Telescope Array Consortium presented
at the 35th International Cosmic Ray Conference, July 12-20 2017, Busan, Korea.
-
The SST-1M is a 4-m Davies--Cotton atmospheric Cherenkov telescope optimized
to provide gamma-ray sensitivity above a few TeV. The SST-1M is proposed as
part of the Small-Size Telescope array for the Cherenkov Telescope Array (CTA),
the first prototype has already been deployed. The SST-1M control software of
all subsystems (active mirror control, drive system, safety system,
photo-detection plane, DigiCam, CCD cameras) and the whole telescope itself
(master controller) uses the standard software design proposed for all CTA
telescopes based on the ALMA Common Software (ACS) developed to control the
Atacama Large Millimeter Array (ALMA). Each subsystem is represented by a
separate ACS component, which handles the communication to and the operation of
the subsystem. Interfacing with the actual hardware is performed via the OPC UA
communication protocol, supported either natively by dedicated industrial
standard servers (PLCs) or separate service applications developed to wrap
lower level protocols (e.g. CAN bus, camera slow control) into OPC UA. Early
operations of the telescope without the camera were already carried out. The
camera is fully assembled and is capable to perform data acquisition using
artificial light source.
-
The foreseen implementations of the Small Size Telescopes (SST) in CTA will
provide unique insights into the highest energy gamma rays offering fundamental
means to discover and under- stand the sources populating the Galaxy and our
local neighborhood. Aiming at such a goal, the SST-1M is one of the three
different implementations that are being prototyped and tested for CTA. SST-1M
is a Davies-Cotton single mirror telescope equipped with a unique camera
technology based on SiPMs with demonstrated advantages over classical
photomultipliers in terms of duty-cycle. In this contribution, we describe the
telescope components, the camera, and the trigger and readout system. The
results of the commissioning of the camera using a dedicated test setup are
then presented. The performances of the camera first prototype in terms of
expected trigger rates and trigger efficiencies for different night-sky
background conditions are presented, and the camera response is compared to
end-to-end simulations.
-
CTA will comprise a sub-array of up to 70 small size telescopes (SSTs) at the
southern array. The SST-1M project, a 4 m-diameter Davies Cotton telescope with
9 degrees FoV and a 1296 pixels SiPM camera, is designed to meet the
requirements of the next generation ground based gamma-ray observatory CTA in
the energy range above 3 TeV. Silicon photomultipliers (SiPM) cameras of
gamma-ray telescopes can achieve good performance even during high night sky
background conditions. Defining a fully automated calibration strategy of SiPM
cameras is of great importance for large scale production validation and online
calibration. The SST-1M sub-consortium developed a software compatible with CTA
pipeline software (CTApipe). The calibration of the SST-1M camera is based on
the Camera Test Setup (CTS), a set of LED boards mounted in front of the
camera. The CTS LEDs are operated in pulsed or continuous mode to emulate
signal and night sky background respectively. Continuous and pulsed light data
analysis allows us to extract single pixel calibration parameters to be used
during CTA operation.
-
List of contributions from the Cherenkov Telescope Array (CTA) Consortium
presented at the 6th International Symposium on High-Energy Gamma-Ray Astronomy
(Gamma 2016), July 11-15, 2016, in Heidelberg, Germany.
-
The Small Size Telescope with Single Mirror (SST-1M) is one of the proposed
types of Small Size Telescopes (SST) for the Cherenkov Telescope Array (CTA).
About 70 SST telescopes will be part the CTA southern array which will also
include Medium Sized Telescopes (MST) in its threshold configuration. Optimized
for the detection of gamma rays in the energy range from 5 TeV to 300 TeV, the
SST-1M uses a Davies-Cotton optics with a 4 m dish diameter with a field of
view of 9 degrees. The Cherenkov light resulting from the interaction of the
gamma-rays in the atmosphere is focused onto a 88 cm side-to-side hexagonal
photo-detection plane. The latter is composed of 1296 hollow light guides
coupled to large area hexagonal silicon photomultipliers (SiPM). The SiPM
readout is fully digital readout as for the trigger system. The compact and
lightweight design of the SST-1M camera offers very high performance ideal for
gamma-ray observation requirement. In this contribution, the concept, design,
performance and status of the first telescope prototype are presented.
-
List of contributions from the CTA Consortium presented at the 34th
International Cosmic Ray Conference, 30 July - 6 August 2015, The Hague, The
Netherlands.
-
A single-mirror small-size (SST-1M) Davies-Cotton telescope with a dish
diameter of 4 m has been built by a consortium of Polish and Swiss institutions
as a prototype for one of the proposed small-size telescopes for the southern
observatory of the Cherenkov Telescope Array (CTA). The design represents a
very simple, reliable, and cheap solution. The mechanical structure prototype
with its drive system is now being tested at the Institute of Nuclear Physics
PAS in Krakow. Here we present the design of the prototype and results of the
performance tests of the structure and the drive and control system.
-
Imaging Atmospheric Cherenkov Telescopes (IACTs) are ground-based instruments
devoted to the study of very high energy gamma-rays coming from space. The
detection technique consists of observing images created by the Cherenkov light
emitted when gamma rays, or more generally cosmic rays, propagate through the
atmosphere. While in the case of protons or gamma-rays the images present a
filled and more or less elongated shape, energetic muons penetrating the
atmosphere are visualised as characteristic circular rings or arcs. A
relatively simple analysis of the ring images allows the reconstruction of all
the relevant parameters of the detected muons, such as the energy, the impact
parameter, and the incoming direction, with the final aim to use them to
calibrate the total optical throughput of the given IACT telescope. We present
the results of preliminary studies on the use of images created by muons as
optical throughput calibrators of the single mirror small size telescope
prototype SST-1M proposed for the Cherenkov Telescope Array.
-
The Small-Size Telescope with single-mirror (SST-1M) is a 4 m Davies-Cotton
telescope and is among the proposed telescope designs for the Cherenkov
Telescope Array (CTA). It is conceived to provide the high-energy ($>$ few TeV)
coverage. The SST-1M contains proven technology for the telescope structure and
innovative electronics and photosensors for the camera. Its design is meant to
be simple, low-budget and easy-to-build industrially.
Each device subsystem of an SST-1M telescope is made visible to CTA through a
dedicated industrial standard server. The software is being developed in
collaboration with the CTA Medium-Size Telescopes to ensure compatibility and
uniformity of the array control. Early operations of the SST-1M prototype will
be performed with a subset of the CTA central array control system based on the
Alma Common Software (ACS). The triggered event data are time stamped,
formatted and finally transmitted to the CTA data acquisition.
The software system developed to control the devices of an SST-1M telescope
is described, as well as the interface between the telescope abstraction to the
CTA central control and the data acquisition system.
-
The prototype of a Davies-Cotton small size telescope (SST-1M) has been
designed and developed by a consortium of Polish and Swiss institutions and
proposed for the Cherenkov Telescope Array (CTA) observatory. The main purpose
of the optical system is to focus the Cherenkov light emitted by extensive air
showers in the atmosphere onto the focal plane detectors. The main component of
the system is a dish consisting of 18 hexagonal mirrors with a total effective
collection area of 6.47 m2 (including the shadowing and estimated mirror
reflectivity). Such a solution was chosen taking into account the analysis of
the Cherenkov light propagation and based on optical simulations. The proper
curvature and stability of the dish is ensured by the mirror alignment system
and the isostatic interface to the telescope structure. Here we present the
design of the optical subsystem together with the performance measurements of
its components.
-
The SST-1M telescope is one of the prototypes under construction proposed to
be part of the future Cherenkov Telescope Array. It uses a standard
Davis-Cotton design for the optics and telescope structure, with a dish
diameter of 4 meters and a large field-of-view of 9 degrees.
The innovative camera design is composed of a photo-detection plane with 1296
pixels including entrance window, light concentrators, Silicon Photomultipliers
(SiPMs), and pre-amplifier stages together with a fully digital readout and
trigger electronics, DigiCam.
In this contribution we give a general description of the analysis chain
designed for the SST-1M prototype. In particular we focus on the calibration
strategy used to convert the SiPM signals registered by DigiCam to the
quantities needed for Cherenkov image analysis. The calibration is based on an
online feedback system to stabilize the gain of the SiPMs, as well as dedicated
events (dark count, pedestal, and light flasher events) to be taken during the
normal operation of the prototype.
-
The single mirror small-size telescope (SST-1M) is one of the telescope
projects being proposed for the Cherenkov Telescope Array observatory by a
sub-consortium of Polish and Swiss institutions. The SST-1M prototype structure
is currently being constructed at the Institute of Nuclear Physics in Cracow,
Poland, while the camera will be assembled at the University of Geneva,
Switzerland. This prototype enables measurements of parameters having a
decisive influence on the telescope performance. We present results of
numerical simulations of the SST-1M performance based on such measurements. The
telescope effective area, the expected trigger rates and the optical point
spread function are calculated.
-
The SST-1M is one of three prototype small-sized telescope designs proposed
for the Cherenkov Telescope Array, and is built by a consortium of Polish and
Swiss institutions. The SST-1M will operate with DigiCam - an innovative,
compact camera with fully digital read-out and trigger electronics. A high
level of integration will be achieved by massively deploying state-of-the-art
multi-gigabit transmission channels, beginning from the ADC flash converters,
through the internal data and trigger signals transmission over backplanes and
cables, to the camera's server link. Such an approach makes it possible to
design the camera to fit the size and weight requirements of the SST-1M
exactly, and provide low power consumption, high reliability and long lifetime.
The structure of the digital electronics will be presented, along with main
physical building blocks and the internal architecture of FPGA functional
subsystems.
The Small Size Telescope with Single Mirror (SST-1M) is one of the proposed types of Small Size Telescopes (SST) for the Cherenkov Telescope Array (CTA). About 70 SST telescopes will be part the CTA southern array which will also include Medium Sized Telescopes (MST) in its threshold configuration. Optimized for the detection of gamma rays in the energy range from 5 TeV to 300 TeV, the SST-1M uses a Davies-Cotton optics with a 4 m dish diameter with a field of view of 9 degrees. The Cherenkov light resulting from the interaction of the gamma-rays in the atmosphere is focused onto a 88 cm side-to-side hexagonal photo-detection plane. The latter is composed of 1296 hollow light guides coupled to large area hexagonal silicon photomultipliers (SiPM). The SiPM readout is fully digital readout as for the trigger system. The compact and lightweight design of the SST-1M camera offers very high performance ideal for gamma-ray observation requirement. In this contribution, the concept, design, performance and status of the first telescope prototype are presented.
Imaging Atmospheric Cherenkov Telescopes (IACTs) are ground-based instruments devoted to the study of very high energy gamma-rays coming from space. The detection technique consists of observing images created by the Cherenkov light emitted when gamma rays, or more generally cosmic rays, propagate through the atmosphere. While in the case of protons or gamma-rays the images present a filled and more or less elongated shape, energetic muons penetrating the atmosphere are visualised as characteristic circular rings or arcs. A relatively simple analysis of the ring images allows the reconstruction of all the relevant parameters of the detected muons, such as the energy, the impact parameter, and the incoming direction, with the final aim to use them to calibrate the total optical throughput of the given IACT telescope. We present the results of preliminary studies on the use of images created by muons as optical throughput calibrators of the single mirror small size telescope prototype SST-1M proposed for the Cherenkov Telescope Array.
The Small-Size Telescope with single-mirror (SST-1M) is a 4 m Davies-Cotton telescope and is among the proposed telescope designs for the Cherenkov Telescope Array (CTA). It is conceived to provide the high-energy ($>$ few TeV) coverage. The SST-1M contains proven technology for the telescope structure and innovative electronics and photosensors for the camera. Its design is meant to be simple, low-budget and easy-to-build industrially. Each device subsystem of an SST-1M telescope is made visible to CTA through a dedicated industrial standard server. The software is being developed in collaboration with the CTA Medium-Size Telescopes to ensure compatibility and uniformity of the array control. Early operations of the SST-1M prototype will be performed with a subset of the CTA central array control system based on the Alma Common Software (ACS). The triggered event data are time stamped, formatted and finally transmitted to the CTA data acquisition. The software system developed to control the devices of an SST-1M telescope is described, as well as the interface between the telescope abstraction to the CTA central control and the data acquisition system.
The SST-1M telescope is one of the prototypes under construction proposed to be part of the future Cherenkov Telescope Array. It uses a standard Davis-Cotton design for the optics and telescope structure, with a dish diameter of 4 meters and a large field-of-view of 9 degrees. The innovative camera design is composed of a photo-detection plane with 1296 pixels including entrance window, light concentrators, Silicon Photomultipliers (SiPMs), and pre-amplifier stages together with a fully digital readout and trigger electronics, DigiCam. In this contribution we give a general description of the analysis chain designed for the SST-1M prototype. In particular we focus on the calibration strategy used to convert the SiPM signals registered by DigiCam to the quantities needed for Cherenkov image analysis. The calibration is based on an online feedback system to stabilize the gain of the SiPMs, as well as dedicated events (dark count, pedestal, and light flasher events) to be taken during the normal operation of the prototype.
The single mirror small-size telescope (SST-1M) is one of the telescope projects being proposed for the Cherenkov Telescope Array observatory by a sub-consortium of Polish and Swiss institutions. The SST-1M prototype structure is currently being constructed at the Institute of Nuclear Physics in Cracow, Poland, while the camera will be assembled at the University of Geneva, Switzerland. This prototype enables measurements of parameters having a decisive influence on the telescope performance. We present results of numerical simulations of the SST-1M performance based on such measurements. The telescope effective area, the expected trigger rates and the optical point spread function are calculated.