• With increasing temperature, ${\rm Sr}_2{\rm ScSbO}_6$ undergoes three structural phase transitions at approximately ${\rm 400K}$, ${\rm 560K}$ and ${\rm 650K}$, leading to the following sequence of phases: $P2_1/n \rightarrow I2/m \rightarrow I4/m \rightarrow Fm\bar{3}m$, making it an ideal candidate to study the effects of octahedral tilting keeping other parameters fixed. To ascertain the isolated effects of octahedral distortions, the electronic and optical properties of the monoclinic $P2_1/n$ (at room temperature), monoclinic $I2/m$ (at ${\rm 430K}$), tetragonal $I4/m$ (at ${\rm 613K}$) and the cubic $Fm\bar{3}m$ (at ${\rm 660K}$) phases have been studied in terms of the electronic structure, dielectric constant, optical conductivity and electron energy loss spectroscopy using density functional theory. ${\rm Ca}_2{\rm ScSbO}_6$, on the other hand, shows only a $P2_1/n$ phase at room temperature and its properties have been been compared with the corresponding ${\rm Sr}$ compound. UV-Vis spectroscopic studies of the optical properties of the room-temperature phase of these $d^0$ double perovskite have been performed and presence of large direct bandgap for both the compounds have been reported. The electronic bandgaps for the room temperature phases is found to be in good agreement with the corresponding experimental values obtained using the Kubelka-Munk function. Interestingly, in contrast to other Sc-based $d^0$ double perovskites, with increasing octahedral distortions, the effective $t_{\rm 2g}$ bandwidth remains unaffected while the states forming the band change due to changes in unit cell orientation, leading to small effects on the electronic and optical properties.
  • Ba2ScSbO6 (BSS) has been synthesized in polycrystalline form by solid state reaction. Structural characterization of the compound was done through X-ray diffraction (XRD) followed by Riedvelt analysis of the XRD pattern. The crystal structure is cubic, space group Fm-3m (No. 225. Optical band-gap of the present system has been calculated using the UV-Vis Spectroscopy to be 4.2eV. A detailed study of the electronic properties has also been carried out using the Full-Potential Linear Augmented Plane Wave (FPLAPW) as implemented in WIEN2k. BSS is found to be a large band-gap insulator with potential technological applications, such as dielectric resonators and filers in microwave applications
  • Raman spectroscopy has been employed to distinguish between the Raman spectrum of pristine hydrogenated diamond like carbon (PHDLC) and that of electrochemically hydrogenated diamond like carbon (ECHDLC). The enhancement of the background photoluminescence (PL) in the Raman spectrum and broadening of PL spectrum of ECHDLC are identified to be due to increase of sp3 C-H density onto the PHDLC surface, during novel electrochemical process of hydrogenation of sp2 C=C into sp3 C-H.
  • Ba2CoWO6 (BCoW) has been synthesized in polycrystalline form by solid state reaction at 1200C. Structural characterization of the compound was done through X-ray diffraction (XRD) followed by Rietveld analysis of the XRD pattern. The crystal structure is cubic, space group Fm-3m (No 225) with the lattice parameter, a=8.210A. Optical band-gap of the present system has been calculated using the UV-Vis Spectroscopy and Kubelka-Munk function, its value being 2.45 eV. A detailed study of the electronic properties has also been carried out using the density functional theory (DFT) techniques implemented on WIEN2k. Importance of electron-electron interaction between the Co ions leading to half-metallic behavior, crystal and exchange splitting together with the hybridization between O and Co, W has been investigated using the total and partial density of states.
  • Remarkably high values of polarization as well as a significant magnetic susceptibility have been observed in multiferroic Bismuth Ferrite (BFO) in the form of nanorods protruding out. These were developed on porous Anodised Alumina (AAO) templates using wet chemical technique. Diameters of nanorods are in the range of 20-100 nm. The high values of polarization and magnetic susceptibility are attributed to the BFO nanorod structures giving rise to the directionality. There is no leakage current in P-E loop examined at various frequencies. Magnetocapacitance measurements reflect a significant enhancement in magnetoelectric coupling also.
  • A remarkably high value of specific capacitance of 450 F/g has been observed through electrochemical measurements in the electrode made of multiferroic Bismuth Ferrite (BFO) in the form of nanorods protruding out. These BFO nanorods were developed on porous Anodised Alumina (AAO) templates using wet chemical technique. Diameters of nanorods were in the range of 20-100 nm. The high capacitance is attributed to the nanostructure. The active surface charge has been evaluated electrochemically by cyclic voltammetry (CV) at different scanning rates and charge-discharge studies. The specific capacitances were constant after several cycles of charge-discharge leading to their useful application in devices. The mechanism of accumulation of charge on the electrode surface has been studied.
  • We report the magnetic properties of magnetic nano-composite, consisting of different quantity of NiFe2O4 nanoparticles in polymer matrix. The nanoparticles exhibited a typical magnetization blocking, which is sensitive on the variation of magnetic field, mode of zero field cooled/field cooled experiments and particle quantity in the matrix. The samples with lower particle quantity showed an upturn of magnetization down to 5 K, whereas the blocking of magnetization dominates at lower temperatures as the particle quantity increases in the polymer. We examine such magnetic behaviour in terms of the competitive magnetic ordering between core and surface spins of nanoparticles, taking into account the effect of inter-particle (dipole-dipole) interactions on nanoparticle magnetic dynamics.
  • Measurements of the critical current density (Jc) by magnetization and the upper critical field (Hc2) by magnetoresistance have been performed for hafnium-doped MgB2. There has been a remarkable enhancement of Jc as compared to that by ion irradiation without any appreciable decrease in Tc, which is beneficial from the point of view of applications. The irreversibility line extracted from Jc shows an upward shift. In addition, there has been an increase in the upper critical field which indicates that Hf partially substitutes for Mg. Hyperfine interaction parameters obtained from time differential perturbed angular correlation (TDPAC) measurements revealed the formation of HfB and HfB2 phases along with the substitution of Hf. A possible explanation is given for the role of these species in the enhancement of Jc in MgB2 superconductor.
  • Core level X-ray Photoelectron Spectroscopy (XPS) studies have been carried out on polycrystalline MgB_2 pellets over the whole binding energy range with a view to having an idea of the charge state of Magnesium (Mg). We observe 3 distinct peaks in Mg 2p spectra at 49.3 eV (trace), 51.3 eV (major) and 54.0 eV (trace), corresponding to metallic Mg, MgB_2 and MgCO_3 or, divalent Mg species respectively. Similar trend has been noticed in Mg 2s spectra. The binding energy of Mg in MgB_2 is lower than that corresponding to Mg(2+), indicative of the fact that the charge state of Mg in MgB2 is less than (2+). Lowering of the formal charge of Mg promotes the sigma to pi electron transfer in Boron (B) giving rise to holes on the top of the sigma-band which are involved in coupling with B E_2g phonons for superconductivity. Through this charge transfer, Mg plays a positive role in hole superconductivity. B 1s spectra consist of 3 peaks corresponding to MgB_2, boron and B_2O_3. There is also evidence of MgO due to surface oxidation as seen from O 1s spectra.
  • 160 MeV Neon ion irradiation has been carried out on MgB2 polycrystalline pellets at various doses. There has not been any significant change in Tc except at the highest dose of 1x10^15 ions/cm^2. Increase in resistivity has been noticed. Resistivity data has been fitted with Bloch-Gruneisen function and the values of Debye temperature, residual resistivity and temperature coefficient of resistivity have been extracted for irradiated as well as unirradiated samples. The increase in the resistivity of irradiated samples has been explained in the light of damage in the 3D pi bonding network of B.