• We report ultrafast time-resolved optical reflectivity investigation of the dynamic densities and relaxations of pseudogap (PG) and superconducting (SC) quasiparticles (QPs) in the underdoped $\rm{Bi_2Sr_2CaCu_2O_{8+\delta}}$ ($T_c$ = 82 K). We find evidence of two distinct PG components in the positive reflectivity changes in the PG state, characterized by relaxation timescales of $\tau_{fast}$ $\approx$ 0.2 ps and $\tau_{slow}$ $\approx$ 2 ps with abrupt changes in both amplitudes $A_{fast}$ and $A_{slow}$ at $T^*$. The former presents no obvious change at $T_c$ and coexists with the SC QP. The latter's amplitude starts decreasing at the SC phase fluctuation $T_p$ and vanishes at $T_c$ followed by a negative amplitude signifying the emergence of the SC QP, therefore suggesting a competition with superconductivity.
  • The iron-based superconductors are characterized by multiple-orbital physics where all the five Fe 3$d$ orbitals get involved. The multiple-orbital nature gives rise to various novel phenomena like orbital-selective Mott transition, nematicity and orbital fluctuation that provide a new route for realizing superconductivity. The complexity of multiple-orbital also asks to disentangle the relationship between orbital, spin and nematicity, and to identify dominant orbital ingredients that dictate superconductivity. The bulk FeSe superconductor provides an ideal platform to address these issues because of its simple crystal structure and unique coexistence of superconductivity and nematicity. However, the orbital nature of the low energy electronic excitations and its relation to the superconducting gap remain controversial. Here we report direct observation of highly anisotropic Fermi surface and extremely anisotropic superconducting gap in the nematic state of FeSe superconductor by high resolution laser-based angle-resolved photoemission measurements. We find that the low energy excitations of the entire hole pocket at the Brillouin zone center are dominated by the single $d_{xz}$ orbital. The superconducting gap exhibits an anti-correlation relation with the $d_{xz}$ spectral weight near the Fermi level, i.e., the gap size minimum (maximum) corresponds to the maximum (minimum) of the $d_{xz}$ spectral weight along the Fermi surface. These observations provide new insights in understanding the orbital origin of the extremely anisotropic superconducting gap in FeSe superconductor and the relation between nematicity and superconductivity in the iron-based superconductors.
  • We report comprehensive angle-resolved photoemission investigations on the electronic structure of single crystal multiple-layer FeSe films grown on CaF2 substrate by pulsed laser deposition (PLD) method. Measurements on FeSe/CaF2 samples with different superconducting transition temperatures Tc of 4 K, 9 K and 14 K reveal electronic difference in their Fermi surface and band structure. Indication of the nematic phase transition is observed from temperature-dependent measurements of these samples; the nematic transition temperature is 140-160 K, much higher than 90 K for the bulk FeSe. Potassium deposition is applied onto the surface of these samples; the nematic phase is suppressed by potassium deposition which introduces electrons to these FeSe films and causes a pronounced electronic structure change. We compared and discussed the electronic structure and superconductivity of the FeSe/CaF2 films by PLD method with the FeSe/SrTiO3 films by molecular beam epitaxy (MBE) method and bulk FeSe. The PLD-grown multilayer FeSe/CaF2 is more hole-doped than that in MBE-grown multiple-layer FeSe films. Our results on FeSe/CaF2 films by PLD method establish a link between bulk FeSe single crystal and FeSe/SrTiO3 films by MBE method, and provide important information to understand superconductivity in FeSe-related systems.
  • We have carried out high-resolution angle-resolved photoemission measurements on the Cebased heavy fermion compound CePt2In7 that exhibits stronger two-dimensional character than the prototypical heavy fermion system CeCoIn5. Multiple Fermi surface sheets and a complex band structure are clearly resolved. We have also performed detailed band structure calculations on CePt2In7. The good agreement found between our measurements and the calculations suggests that the band renormalization effect is rather weak in CePt2In7. A comparison of the common features of the electronic structure of CePt2In7 and CeCoIn5 indicates that CeCoIn5 shows a much stronger band renormalization effect than CePt2In7. These results provide new information for understanding the heavy fermion behaviors and unconventional superconductivity in Ce-based heavy fermion systems.
  • The first-principle study on double perovskite compound Ba$_2$PrVO$_6$ has been presented in this paper. By analysing band structures and integrated density of states, it is found that Ba$_2$PrVO$_6$ is ferromagnetic metallic within LSDA and compensated half metallic whithin LSDA+U. According to the total and partial density of states, the anti-ferromagnetism of Ba$_2$PrVO$_6$ is originated from the spin down state Pr$^{4+}$ ($4f_{-2}$) and the spin up hybridized state between the partially filled $t_{2g}$ state of V and the partially filled triple-degeneration state $4f_{-1}$, $4f_{+1}$, $4f_{+3}$ of Pr. We have investigated the magnetic evaluation of Ba$_2$PrVO$_6$ through fixed spin moment calculations, and the results indicate that the compensated half-metallic state is the ground state. The thermodynamic properties of Ba$_2$PrVO$_6$ are also studied by employing the quasi-harmonic Debye model.
  • Topological quantum materials, including topological insulators and superconductors, Dirac semimetals and Weyl semimetals, have attracted much attention recently for their unique electronic structure, spin texture and physical properties. Very lately, a new type of Weyl semimetals has been proposed where the Weyl Fermions emerge at the boundary between electron and hole pockets in a new phase of matter, which is distinct from the standard type I Weyl semimetals with a point-like Fermi surface. The Weyl cone in this type II semimetals is strongly tilted and the related Fermi surface undergos a Lifshitz transition, giving rise to a new kind of chiral anomaly and other new physics. MoTe2 is proposed to be a candidate of a type II Weyl semimetal; the sensitivity of its topological state to lattice constants and correlation also makes it an ideal platform to explore possible topological phase transitions. By performing laser-based angle-resolved photoemission (ARPES) measurements with unprecedentedly high resolution, we have uncovered electronic evidence of type II semimetal state in MoTe2. We have established a full picture of the bulk electronic states and surface state for MoTe2 that are consistent with the band structure calculations. A single branch of surface state is identified that connects bulk hole pockets and bulk electron pockets. Detailed temperature-dependent ARPES measurements show high intensity spot-like features that is ~40 meV above the Fermi level and is close to the momentum space consistent with the theoretical expectation of the type II Weyl points. Our results constitute electronic evidence on the nature of the Weyl semimetal state that favors the presence of two sets of type II Weyl points in MoTe2.
  • In this paper, we consider the product space for two processes with independent increments under nonlinear expectations. By introducing a discretization method, we construct a nonlinear expectation under which the given two processes can be seen as a new process with independent increments.
  • We investigate the dynamics of high aspect ratio nanowires trapped axially in a single gradient force optical tweezers. A power spectrum analysis of the Brownian dynamics reveals a broad spectral resonance of the order of a kHz with peak properties that are strongly dependent on the input trapping power. Modelling of the dynamical equations of motion of the trapped nanowire that incorporate non-conservative effects through asymmetric coupling between translational and rotational degrees of freedom provides excellent agreement with the experimental observations. An associated observation of persistent cyclical motion around the equilibrium trapping position using winding analysis provides further evidence for the influence of non-conservative forces.
  • The structural, electronic, and magnetic properties of half-Heusler alloys CKMg and SiKMg are studied by using first-principle density functional theory. The calculations reveal the SiKMg alloy is a half-metallic ferromagnet with the magnetic moment of 1 $\mu_B$ per formula unit at equilibrium lattice constant. The magnetic moment mainly originates from the strong spin-polarization of $p$ electrons of Si atom and partial involvement of $d$ electrons of K atom. The half-metallic gap is 0.105 eV. The robustness of half-metallic against the lattice constants for SiKMg is also calculated. CKMg alloy is nearly half-metallic with a spin polarization of 99.99 \%\ at equilibrium lattice constant, but it is a good half-metallic alloy when a low pressure is applied. This shows CKMg is a very promising spintronic functional material.
  • We investigate the electronic structures and magnetic properties of RbSe and CsTe compounds in CsCl, RS and ZB structures by using first-principles calculation. It is shown that these two compounds exhibit half-metallic ferromagnetism with an integer magnetic moment of 1.00 $\mu_B$ per formula in all the three structures. Total energy calculations indicate the CsCl phase is more stable than the other two phases. We investigate these two compounds with CsCl structure in detail. The ferromagnetism results mainly from the spin-polarization of p states of anion Se (Te) for the two compounds. The half-metallicities of RbSe and CsTe compounds can be preserved up to 2.5\% and 0.8\% compression of lattice constants with respect to their equilibrium lattices, respectively.
  • The electronic and magnetic properties of bulk and (1 1 1) surfaces for MP (M=K ans Rb) in rocksalt structure have been investigated by employing first-principle calculations. The results reveal that the compounds are half-metallic ferromagnets at the equilibrium lattice constants with large half-metallic band gaps of 0.46 and 0.74 eV. The (111) surfaces of KP and RbP keep their bulk half-metallic property. We study the stabilities of the bulk compounds and their (1 1 1) surfaces as well.
  • Employing $ab$ $intito$ electronic structure calculations, we have investigated electronic and magnetic properties of the Zr-based quanternary Heusler alloys: ZrCoVIn, ZrFeVGe, ZrCoFeP, ZrCoCrBe and ZrFeCrZ (Z=In and Ga). Our $ab$ $intito$ calculation results show that all the alloys are (or nearly) spin-gapless semiconductors. All the alloys have large band gaps, indicating the stability of them at room temperature. The Slater-Pauling behaviours of these alloys are discussed as well. The values of Curie temperature of all the alloys are estimated. And it is found that the values of the Curie temperature for all our calculated quanternary Heusler alloys are higher than that of room temperature.
  • In this letter, we investigate the magnetic properties, electronic structures, Slater-Pauling behaviours of some quanternary Heusler alloys with 4d and 3d transition metal elements. The energy levels of the minority-spin electronic band structures for all our calculated alloys are discussed. We have summaried 21 quanternary Heusler alloys. Our calculations indicate that the half metals ZrCoCrSi, ZrCoCrIn, ZrCoFeSi, ZrFeVAl, ZrFeVGa and NbFeCrAl have large spin-flip gaps.
  • We investigate the electronic structure and magnetic properties of four quaternary Heusler alloys ZrMnVZ and ZrCoFeZ (Z=Si, Ge) by using first-principle calculations. It is shown that ZrMnVSi, ZrMnVGe and ZrCoFeSi are half-metallic ferromagnets with considerable half-metallic gaps of 0.14, 0.18 and 0.22 eV, respectively. ZrCoFeGe is a nearly half-metallic, the changes of properties for this alloy under pressure is investigated, the spin polarization of this alloy is 98.99\% at equilibrium lattice constant.
  • Using transient Rayleigh scattering (TRS) measurements, we obtain photoexcited carrier thermalization dynamics for both zincblende (ZB) and wurtzite (WZ) InP single nanowires (NW) with picosecond resolution. A phenomenological fitting model based on direct band to band transition theory is developed to extract the electron-hole-plasma density and temperature as a function of time from TRS measurements of single nanowires which have complex valence band structures. We find that the thermalization dynamics of hot carriers depends strongly on material (GaAs NW vs. InP NW) and less strongly on crystal structure (ZB vs. WZ). The thermalization dynamics of ZB and WZ InP NWs are similar. But a comparison of the thermalization dynamics in ZB and WZ InP NWs with ZB GaAs NW reveals more than an order of magnitude slower relaxation for the InP NWs. We interpret these results as reflecting their distinctive phonon band structures which lead to different hot phonon effects. Knowledge of hot carrier thermalization dynamics is an essential component for effective incorporation of nanowire materials into electronic devices.
  • When a material is subjected to an applied stress, the material will experience recoverable elastic deformation followed by permanent plastic deformation at the point when the applied stress exceeds the yield stress of the material. Microscopically, the onset of the plasticity usually indicates the activation of dislocation motion, which is considered to be the primary mechanism of plastic deformation. Once plastic deformation is initiated, further elastic deformation is negligible owing to the limited increase in the flow stress caused by work hardening. Here we present experimental evidence and quantitative analysis of simultaneous development of significant elastic deformation and dislocation-based plastic deformation in single crystal GaAs nanowires (NWs) under bending deformation up to a total strain of ~ 6%. The observation is in sharp contrast to the previous notions regarding the deformation modes. Most of the plastic deformation recovers spontaneously when the external stress is released, and therefore resembles an elastic deformation process.