
This contribution presents a novel bunch current measurement system based on
an ultrafast photodetector and a highspeed digitizer at Hefei Light Source II
(HLS II). In order to achieve bunchbybunch resolution, the sampling rate of
the system is nearly 225 GS/s via a dedicated equivalent sampling algorithm.
According to preliminary tests of daily operation mode and singlebunch mode,
the rootmeansquare (rms) of current relative error distribution is 1.03%,
which illustrates the new system satisfies requirements for highprecision
bunch current measurement. In addition, experiment results of "HLS" Morse code
fill pattern mode demonstrate this system also could be a convenient and robust
tool for beam topup mode in the future.

A new bunch length measurement method based on high order mode cavity was
proposed. Operating the harmonic cavity at mode TM0n0 so that its radius could
be chosen, in order to break the limitation of beam pipe radius. A twocavity
bunch length monitor for linac of positron source was designed. Operating
frequency selection for different bunch time structure was discussed and
calculation formula of bunch length was deducted. Fundamental harmonic cavity
resonates at 2.856 GHz with mode TM010. Fifth harmonic cavity resonates at
14.28 GHz (fifth harmonic of the linac fundamental frequency 2.856 GHz) with
mode TM020, which could provide larger radius. Each cavity equipped with a
filter to suppress unwanted signal. A simulation measurement was conducted in
CST Particle Studio for beam current from 100300mA, bunch length from 510ps,
calculation results shows a fairly high accuracy (better than 3%). Several
cases were discussed.

A logarithm processing algorithm to measure beam transverse size and position
is proposed and preliminary experimental results in Hefei Light Source II (HLS
II) are given. The algorithm is based on only 4 successive channels of 16 anode
channels of multianode photomultiplier tube (MAPMT) R5900U00L16 which has
typical rise time of 0.6 ns and effective area of 0.8x16 mm for a single anode
channel. In the paper, we firstly elaborate the simulation results of the
algorithm with and without channel inconsistency. Then we calibrate the channel
inconsistency and verify the algorithm using general current signal processor
Libera Photon in lowspeed scheme. Finally we get turnbyturn beam size and
position and calculate the vertical tune in highspeed scheme. The experimental
results show that measured values fit well with simulation results after
channel differences are calibrated and the fractional part of the tune in
vertical direction is 0.3628 which is very close to the nominal value 0.3621.

Following the discovery of the Higgs boson at LHC, new large colliders are
being studied by the international highenergy community to explore Higgs
physics in detail and new physics beyond the Standard Model. In China, a
twostage circular collider project CEPCSPPC is proposed, with the first stage
CEPC (Circular Electron Positron Collier, a socalled Higgs factory) focused on
Higgs physics, and the second stage SPPC (Super ProtonProton Collider) focused
on new physics beyond the Standard Model. This paper discusses this second
stage.

In this paper, we consider the relation between $p > 1$ and critical
dimension of the extremal solution of the semilinear equation
$$\{\begin{array}{lllllll} \beta \Delta^{2}u\tau \Delta
u=\frac{\lambda}{(1u)^{p}} & in\ \ B, 0<u\leq 1 & in\ \ B, u=\Delta u=0 & on\
\ \partial B, \end{array} . $$ where $B$ is the unit ball in $R^{n}$,
$\lambda>0$ is a parameter, $\tau>0, \beta>0,p>1$ are fixed constants. By
HardyRellich inequality, we find that when $p$ is large enough, the critical
dimension is 13.}

We will investigate the asymptotic behavior of positive solutions of the
elliptic equation \Delta u+x^{l_{1}}u^{p}+x^{l_{2}}u^{q}=0 {in} R^{n}. We
establish that for $n\geq 3$ and $q>p>1$, any positive radial solution of (0.1)
has the following property: $\lim_{r\to\infty}r^{\frac{2+l_{1}}{p1}}u$ and
$\lim_{r\to0}r^{\frac{2+l_{2}}{q1}}u$ always exist if
$\frac{n+l_{1}}{n2}<p<q, p\neq\frac{n+2+2l_{1}}{n2}, q
\neq\frac{n+2+2l_{2}}{n2}.$ In addition, we prove that the singular solution
of (0.1) is unique under a certain condition