We report the results of a low-latency beam phase feed-forward system built
to stabilize the arrival time of a relativistic electron beam. The system was
operated at the Compact Linear Collider (CLIC) Test Facility (CTF3) at CERN
where the beam arrival time was stabilized to approximately 50 fs. The system
latency was 350 ns and the correction bandwidth >23 MHz. The system meets the
requirements for CLIC.
Discharge capillary-based active plasma lenses are a promising new technology
for strongly focusing charged particle beams, especially when combined with
novel high gradient acceleration methods. Still, many questions remain
concerning such lenses, including their transverse field uniformity,
limitations due to plasma wakefields and whether they can be combined in
multi-lens lattices in a way to cancel chromaticity. These questions will be
addressed in a new plasma lens experiment at the CLEAR User Facility at CERN.
All the subsystems have been constructed, tested and integrated into the CLEAR
beam line, and are ready for experiments starting late 2017.
On the wake of the results obtained so far at the SPARC\_LAB test-facility at
the Laboratori Nazionali di Frascati (Italy), we are currently investigating
the possibility to design and build a new multi-disciplinary user-facility,
equipped with a soft X-ray Free Electron Laser (FEL) driven by a $\sim$1 GeV
high brightness linac based on plasma accelerator modules. This design study is
performed in synergy with the EuPRAXIA design study. In this paper we report
about the recent progresses in the on going design study of the new facility.
The Compact Linear Collider (CLIC) is a multi-TeV high-luminosity linear e+e-
collider under development. For an optimal exploitation of its physics
potential, CLIC is foreseen to be built and operated in a staged approach with
three centre-of-mass energy stages ranging from a few hundred GeV up to 3 TeV.
The first stage will focus on precision Standard Model physics, in particular
Higgs and top-quark measurements. Subsequent stages will focus on measurements
of rare Higgs processes, as well as searches for new physics processes and
precision measurements of new states, e.g. states previously discovered at LHC
or at CLIC itself. In the 2012 CLIC Conceptual Design Report, a fully optimised
3 TeV collider was presented, while the proposed lower energy stages were not
studied to the same level of detail. This report presents an updated baseline
staging scenario for CLIC. The scenario is the result of a comprehensive study
addressing the performance, cost and power of the CLIC accelerator complex as a
function of centre-of-mass energy and it targets optimal physics output based
on the current physics landscape. The optimised staging scenario foresees three
main centre-of-mass energy stages at 380 GeV, 1.5 TeV and 3 TeV for a full CLIC
programme spanning 22 years. For the first stage, an alternative to the CLIC
drive beam scheme is presented in which the main linac power is produced using
The CLIC (Compact Linear Collider) RF power source is based on a new scheme
of electron pulse compression and bunch frequency multiplication using
injection by transverse RF deflectors into an isochronous ring. In this paper,
we describe the modifications needed in the present LEP Pre-Injector (LPI)
complex at CERN in order to perform a low-charge test of the scheme. The design
of the injector (including the new thermionic gun), of the modified linac, of
the matched injection line, and of the isochronous ring lattice, are presented.
The results of preliminary isochronicity measurements made on the present
installation are also discussed.
Bunches of high charge (up to 10 nC) are compressed in length in the CTF II
magnetic chicane to less than 0.2 mm rms. The short bunches radiate coherently
in the chicane magnetic field, and the horizontal and longitudinal phase space
density distributions are affected. This paper reports the results of beam
emittance and momentum measurements. Horizontal and vertical emittances and
momentum spectra were measured for different bunch compression factors and
bunch charges. In particular, for 10 nC bunches, the mean beam momentum
decreased by about 5% while the FWHM momentum spread increased from 5% to 19%.
The experimental results are compared with simulations made with the code