Earlier RDDS (Rounded Damped Detuned Structures) [1,2], designed, fabricated and tested at SLAC, in collaboration with KEK, have been shown to damp wakefields successfully. However, electrical breakdown has been found to occur in these structures and this makes them inoperable at the desired gradient. Recent results [3] indicate that lowering the group velocity of the accelerating mode reduces electrical breakdown events. In order to preserve the filling time of each structure a high synchronous phase advance (150 degrees as opposed to 120 used in previous NLC designs) has been chosen. Here, damping of the wakefield is analyzed. Manifold damping and interleaving of structure cell frequencies is discussed. These wakefields impose alignment tolerances on the cells and on the structure as a whole. Tolerance calculations are performed and these are compared with analytic estimations.

The complexity of the Round Damped Detuned Structue (RDDS) for the JLC/NLC main linac is driven by the considerations of rf efficiency and dipole wakefield suppression. As a time and cost saving measure for the JLC/NLC, the dimensions of the 3D RDDS cell are being determined through computer modeling to within fabrication precision so that no tuning may be needed once the structures are assembled. The tolerances on the frequency errors for the RDDS structure are about one MHz for the fundamental mode and a few MHz for the dipole modes. At the X-band frequency, these correspond to errors of a micron level on the major cell dimensions. Such a level of resolution requires highly accurate field solvers and vast amount of computer resources. A parallel finite-element eigensolver Omega3P was developed at SLAC that runs on massively parallel computers such as the Cray T3E at NERSC. The code was applied in the design of the RDDS cell dimensions that are accurate to within fabrication precision. We will present the numerical approach of using these codes to determine the RDDS dimensions and compare the numerical predictions with the cold test measurements on RDDS prototypes that are diamond-turned using these dimensions.

As a joint effort in the JLC/NLC research program, we have developed a new type of damped detuned accelerator structure with optimized round-shaped cavities (RDDS). This paper discusses some important R&D aspects of the first structure in this series (RDDS1). The design aspects covered are the cell design with sub-MHz precision, HOM detuning, coupling and damping technique and wakefield simulation. The fabrication issues covered are ultra-precision cell machining with micron accuracy, assembly and diffusion bonding technologies to satisfactorily meet bookshelf, straightness and cell rotational alignment requirements. The measurements described are the RF properties of single cavities and complete accelerator section, as well as wakefields from the ASSET tests at SLAC. Finally, future improvements are also discussed.