
We discuss fundamental limits of electromagnetic searches for axion and
hiddenphoton dark matter. We begin by showing the signaltonoise advantage of
scanned resonant detectors over purely resistive broadband detectors. We
discuss why the optimal detector circuit must be driven by the darkmatter
signal through a reactance; examples of such detectors include singlepole
resonators. We develop a framework to optimize dark matter searches using prior
information about the dark matter signal (e.g. astrophysical and
directdetection constraints or preferred search ranges). We define integrated
sensitivity as a figure of merit in comparing searches over a wide frequency
range and show that the BodeFano criterion sets a limit on integrated
sensitivity. We show that when resonator thermal noise dominates amplifier
noise, substantial sensitivity is available away from the resonator bandwidth.
Additionally, we show that the optimized singlepole resonator is close to the
BodeFano limit, establishing the resonator as a nearideal method for
singlemoded darkmatter detection. We optimize time allocation in a scanned
resonator using priors and derive quantum limits on resonant search
sensitivity. We show that, in contrast to some previous work, resonant searches
benefit from quality factors above one million, the characteristic quality
factor of the darkmatter signal. We also show that the optimized resonator is
superior, in signaltonoise ratio, to the optimized reactive broadband
detector at all frequencies at which a resonator may practically be made. At
low frequencies, the application of our optimization may enhance scan rates by
a few orders of magnitude. Finally, we discuss prospects for evading the
quantum limits using backaction evasion, photon counting, squeezing and other
nonclassical approaches, as a prelude to Part II.

We present broadband parametric amplifiers based on the kinetic inductance of
superconducting NbTiN thin films in an artificial (lumpedelement) transmission
line architecture. We demonstrate two amplifier designs implementing different
phase matching techniques: periodic impedance loadings, and resonator phase
shifters placed periodically along the transmission line. Our design offers
several advantages over previous CPWbased amplifiers, including intrinsic 50
ohm characteristic impedance, natural suppression of higher pump harmonics,
lower required pump power, and shorter total trace length. Experimental
realizations of both versions of the amplifiers are demonstrated. With a
transmission line length of 20 cm, we have achieved gains of 15 dB over several
GHz of bandwidth.

We introduce the DM Radio, a dual search for axion and hidden photon dark
matter using a tunable superconducting lumpedelement resonator. We discuss the
prototype DM Radio Pathfinder experiment, which will probe hidden photons in
the 500 peV (100 kHz)50 neV (10 MHz) mass range. We detail the design of the
various components: the LC resonant detector, the resonant frequency tuning
procedure, the differential SQUID readout circuit, the shielding, and the
cryogenic mounting structure. We present the current status of the pathfinder
experiment and illustrate its potential science reach in the context of the
larger experimental program.

This report, based on the Dark Sectors workshop at SLAC in April 2016,
summarizes the scientific importance of searches for dark sector dark matter
and forces at masses beneath the weakscale, the status of this broad
international field, the important milestones motivating future exploration,
and promising experimental opportunities to reach these milestones over the
next 510 years.

Advanced ACTPol is an instrument upgrade for the sixmeter Atacama Cosmology
Telescope (ACT) designed to measure the cosmic microwave background (CMB)
temperature and polarization with arcminutescale angular resolution. To
achieve its science goals, Advanced ACTPol utilizes a larger readout
multiplexing factor than any previous CMB experiment to measure detector arrays
with approximately two thousand transitionedge sensor (TES) bolometers in each
150 mm detector wafer. We present the implementation and testing of the
Advanced ACTPol timedivision multiplexing readout architecture with a 64row
multiplexing factor. This includes testing of individual multichroic detector
pixels and superconducting quantum interference device (SQUID) multiplexing
chips as well as testing and optimizing of the integrated readout electronics.
In particular, we describe the new automated multiplexing SQUID tuning
procedure developed to select and optimize the thousands of SQUID parameters
required to readout each Advanced ACTPol array. The multichroic detector pixels
in each array use separate channels for each polarization and each of the two
frequencies, such that four TESes must be read out per pixel. Challenges
addressed include doubling the number of detectors per multiplexed readout
channel compared to ACTPol and optimizing the Nyquist inductance to minimize
detector and SQUID noise aliasing.

We propose a resonant electromagnetic detector to search for hiddenphoton
dark matter over an extensive range of masses. Hiddenphoton dark matter can be
described as a weakly coupled "hidden electric field," oscillating at a
frequency fixed by the mass, and able to penetrate any shielding. At low
frequencies (compared to the inverse size of the shielding), we find that
observable effect of the hidden photon inside any shielding is a real,
oscillating magnetic field. We outline experimental setups designed to search
for hiddenphoton dark matter, using a tunable, resonant LC circuit designed to
couple to this magnetic field. Our "straw man" setups take into consideration
resonator design, readout architecture and noise estimates. At high
frequencies,there is an upper limit to the useful size of a single resonator
set by $1/\nu$. However, many resonators may be multiplexed within a
hiddenphoton coherence length to increase the sensitivity in this regime.
Hiddenphoton dark matter has an enormous range of possible frequencies, but
current experiments search only over a few narrow pieces of that range. We find
the potential sensitivity of our proposal is many orders of magnitude beyond
current limits over an extensive range of frequencies, from 100 Hz up to 700
GHz and potentially higher.

We have designed, fabricated and tested a frequencytunable highQ
superconducting resonator made from a niobium titanium nitride film. The
frequency tunability is achieved by injecting a DC current through a
currentdirecting circuit into the nonlinear inductor whose kinetic inductance
is currentdependent. We have demonstrated continuous tuning of the resonance
frequency in a 180 MHz frequency range around 4.5 GHz while maintaining the
high internal quality factor $Q_i> 180,000$. This device may serve as a tunable
filter and find applications in superconducting quantum computing and
measurement. It also provides a useful tool to study the nonlinear response of
a superconductor. In addition, it may be developed into techniques for
measurement of the complex impedance of a superconductor at its transition
temperature and for readout of transitionedge sensors.

Superconducting parametric amplifiers have great promise for quantumlimited
readout of superconducting qubits and detectors. Until recently, most
superconducting parametric amplifiers had been based on resonant structures,
limiting their bandwidth and dynamic range. Broadband travelingwave parametric
amplifiers based both on the nonlinear kinetic inductance of superconducting
thin films and on Josephson junctions are in development. By modifying the
dispersion property of the amplifier circuit, referred to as dispersion
engineering, the gain can be greatly enhanced and the size can be reduced. We
present two theoretical frameworks for analyzing and understanding such
parametric amplifiers: (1) generalized coupledmode equations and (2) a finite
difference time domain (FDTD) model combined with a small signal analysis. We
show how these analytical and numerical tools may be used to understand device
performance.

Recently Yaakobi and coworkers [Phys. Rev. B 87, 144301 (2013)]
theoretically studied fourwave mixing and parametric amplification in a
nonlinear transmission line consisting of capacitively shunted Josephson
junctions. By deriving and solving the coupledmode equations, they have
arrived at the conclusion that in a wide frequency range around the pump
frequency exponential parametric gain (in which the signal grows exponentially
with distance) can be achieved. However, we have found a mathematical error in
their derivation of the coupledmode equations (Equation (A13)), which leads to
the wrong expression of the gain factor and invalidates their conclusions on
the gain and bandwidth. In this comment, we present the correct expression for
the parametric gain. We show that for a transmission line with weak dispersion
or positive dispersion ($\Delta k>0 $), as is the case discussed by Yaakobi et
al, while quadratic (power) gain can occur around the pump frequency,
exponential gain is impossible. Furthermore, for a transmission line with
proper intrinsic or engineered dispersion, exponential gain occurs at
frequencies where the phase matching condition is met, while around the pump
frequency the gain is still quadratic.