• ### Longitudinal RF capture simulation and BPM signal estimation(1611.01721)

Nov. 16, 2016 physics.acc-ph
In this paper, the theoretical aspects behind longitudinal RF capture are reviewed and the capture process is simulated via a program based on this theory. Four kinds of cases with different initial distribution and capture curve are considered, i.e. uniform distribution with adiabatic capture, uniform distribution with non-adiabatic capture, Gaussian distribution with adiabatic capture and Gaussian distribution with non-adiabatic capture. The simulation results are compared each other and discussed, and Gaussian distribution with adiabatic capture is demonstrated having a higher capture efficiency and leading to a shorter bunch length. In addition, the BPM induced signal is simulated with high input impendence, i.e. $1M\Omega$, and low input impendence, i.e. $50\Omega$, respectively. Finally, the BPM signal of Heavy Ion Medical Machine (HIMM) is estimated and compared with measured one, and a good agreement is achieved.
• ### Calculation of the coupled betatron motion introduced by cooler's solenoids of CSRm(1508.02472)

Aug. 11, 2015 physics.acc-ph
Several solenoids are usually installed in electron cooler device to guide the motion of the electron beam in the cooler. However, the solenoids also have influence to the ion beam in the cooler storage ring. The transverse motion of the ion beam in storage ring will become coupled, if the solenoids installed in the electron cooler are not compensated perfectly. In this paper, the coupled transverse motion due to the uncompensated cooler's solenoids of CSRm (The main storage ring in the IMP, Lan Zhou, China) is studied, and the coupled beam envelopes are calculated by a new method.
• ### The Side-Effects of the Space Charge Field Introduced by Hollow Electron Beam in the Electron Cooler of CSRm(1504.06233)

April 23, 2015 physics.acc-ph
Electron cooler is used to improve the quality of the beam in synchrotron, however it also introduces nonlinear electromagnetic field, which cause tuneshift, tunespread and may drive resonances leading to beam loss. In this paper the tuneshift and the tunespread caused by nonlinear electromagnetic field of the hollow electron beam was investigated, and the resonance driving terms of the nonlinear electromagnetic field was analysed. The differences were presented comparing with the solid electron beam. The calculations were performed for $^{238}U^{32+}$ ions of energy 1.272MeV stored in CSRm, using the parameters given in table1. The conclusion is that in this situation nonlinear field caused by the hollow electron beam do not lead to serious resonances.
• ### Closed orbit correction of HIMM synchrotron(1502.01415)

Feb. 5, 2015 physics.acc-ph
The correction of closed orbit has great influence on the operation of synchrotron. The design of correction system is one significant component of lattice design. It is suggested to set BPMs at the peaks of betatron oscillation. The correctors need to be located at the positions where \b{eta} function is large or the sources of large errors. In the simulation of the closed orbit correction of HIMM synchrotron, one important reason affecting the result of horizontal correction is the longitudinal alignment error of dipole magnet. It is advisable to decrease this kind of alignment error while the deflection angle of dipole magnet is large.
• ### Simulation of the Capture and Acceleration Processes in HIAF-CRing(1410.2943)

Oct. 11, 2014 physics.acc-ph
In order to investigate the longitudinal beam dynamics during the adiabatic capture and acceleration processes of the CRing in HIAF project, a simulation of both processes above is carried out with $U^{34+}$ ions. The ions will be captured into a bucket adiabatically and accelerated from 800 MeV/u to 1130 MeV/u . Simulation of these processes by tracking appropriate distributions with the longitudinal beam dynamics code ESME has been used to find optimum parameters such as RF phase, RF voltage and RF frequency etc. An enhanced capture and acceleration efficiency can be gotten from the simulation results, with the optimized RF voltage and RF phase program.