-
In these mini-proceedings we review the results of the workshop `Impact of
$B\to\mu^+\mu^-$ on New Physics Searches' that took place at the Paul Scherrer
Institute (PSI) on the 18th-19th December 2017.
-
A new pixel detector for the CMS experiment was built in order to cope with
the instantaneous luminosities anticipated for the Phase~I Upgrade of the LHC.
The new CMS pixel detector provides four-hit tracking with a reduced material
budget as well as new cooling and powering schemes. A new front-end readout
chip mitigates buffering and bandwidth limitations, and allows operation at low
comparator thresholds. In this paper, comprehensive test beam studies are
presented, which have been conducted to verify the design and to quantify the
performance of the new detector assemblies in terms of tracking efficiency and
spatial resolution. Under optimal conditions, the tracking efficiency is
$99.95\pm0.05\,\%$, while the intrinsic spatial resolutions are
$4.80\pm0.25\,\mu \mathrm{m}$ and $7.99\pm0.21\,\mu \mathrm{m}$ along the
$100\,\mu \mathrm{m}$ and $150\,\mu \mathrm{m}$ pixel pitch, respectively. The
findings are compared to a detailed Monte Carlo simulation of the pixel
detector and good agreement is found.
-
This work is on the Physics of the B Factories. Part A of this book contains
a brief description of the SLAC and KEK B Factories as well as their detectors,
BaBar and Belle, and data taking related issues. Part B discusses tools and
methods used by the experiments in order to obtain results. The results
themselves can be found in Part C.
Please note that version 3 on the archive is the auxiliary version of the
Physics of the B Factories book. This uses the notation alpha, beta, gamma for
the angles of the Unitarity Triangle. The nominal version uses the notation
phi_1, phi_2 and phi_3. Please cite this work as Eur. Phys. J. C74 (2014) 3026.
-
The degradation of signal in silicon sensors is studied under conditions
expected at the CERN High-Luminosity LHC. 200 $\mu$m thick n-type silicon
sensors are irradiated with protons of different energies to fluences of up to
$3 \cdot 10^{15}$ neq/cm$^2$. Pulsed red laser light with a wavelength of 672
nm is used to generate electron-hole pairs in the sensors. The induced signals
are used to determine the charge collection efficiencies separately for
electrons and holes drifting through the sensor. The effective trapping rates
are extracted by comparing the results to simulation. The electric field is
simulated using Synopsys device simulation assuming two effective defects. The
generation and drift of charge carriers are simulated in an independent
simulation based on PixelAV. The effective trapping rates are determined from
the measured charge collection efficiencies and the simulated and measured
time-resolved current pulses are compared. The effective trapping rates
determined for both electrons and holes are about 50% smaller than those
obtained using standard extrapolations of studies at low fluences and suggests
an improved tracker performance over initial expectations.
-
Pixel detectors are used in the innermost part of multi purpose experiments
at the Large Hadron Collider (LHC) and are therefore exposed to the highest
fluences of ionising radiation, which in this part of the detectors consists
mainly of charged pions. The radiation hardness of the detectors has thoroughly
been tested up to the fluences expected at the LHC. In case of an LHC upgrade
the fluence will be much higher and it is not yet clear up to which radii the
present pixel technology can be used. In order to establish such a limit, pixel
sensors of the size of one CMS pixel readout chip (PSI46V2.1) have been bump
bonded and irradiated with positive pions up to 6E14 Neq/cm^2 at PSI and with
protons up to 5E15 Neq/cm^2. The sensors were taken from production wafers of
the CMS barrel pixel detector. They use n-type DOFZ material with a resistance
of about 3.7kOhm cm and an n-side read out. As the performance of silicon
sensors is limited by trapping, the response to a Sr-90 source was
investigated. The highly energetic beta-particles represent a good
approximation to minimum ionising particles. The bias dependence of the signal
for a wide range of fluences will be presented.
-
With the advent of the LHC, we will be able to probe New Physics (NP) up to
energy scales almost one order of magnitude larger than it has been possible
with present accelerator facilities. While direct detection of new particles
will be the main avenue to establish the presence of NP at the LHC, indirect
searches will provide precious complementary information, since most probably
it will not be possible to measure the full spectrum of new particles and their
couplings through direct production. In particular, precision measurements and
computations in the realm of flavour physics are expected to play a key role in
constraining the unknown parameters of the Lagrangian of any NP model emerging
from direct searches at the LHC. The aim of Working Group 2 was twofold: on one
hand, to provide a coherent, up-to-date picture of the status of flavour
physics before the start of the LHC; on the other hand, to initiate activities
on the path towards integrating information on NP from high-pT and flavour
data.
-
In general a decay with a missing (not detected) particle can not be fully
reconstructed apart from a few exceptions. For example, if the momentum of the
decaying particle is known or if the missing energy in an event is measured
precisely, then the missing particle 4-momentum can be determined. Here a new
method is proposed that utilizes additional information about the topology of a
decay: The direction from the primary to the secondary vertex combined with
momentum conservation allows the determination of the missing particle momentum
up to a twofold ambiguity. The semileptonic decay of the Bs mesons is
considered as an example to illustrate this method and to compare its
performance against conventional approaches.
-
Strategies for Higgs boson searches require the knowledge of the total
production cross section and the transverse momentum spectrum. The large
transverse momentum spectrum of the Higgs boson produced in gluon fusion can be
quite different in the Standard Model and the Minimal Supersymmetric Standard
Model. In this paper we present a comparison of the Higgs transverse momentum
spectrum obtained using the PYTHIA event generator and the HIGLU program as
well as the program HQT, which includes NLO corrections and a soft gluon
resummation for the region of small transverse momenta. While the shapes of the
spectra are similar for the Standard Model, significant differences are
observed in the spectra of Minimal Supersymmetric Standard Model benchmark
scenarios with large tan(beta).
-
The CMS pixel barrel system will consist of three layers built of about 800
modules. One module contains 66560 readout channels and the full pixel barrel
system about 48 million channels. It is mandatory to test each channel for
functionality, noise level, trimming mechanism, and bump bonding quality.
Different methods to determine the bump bonding yield with electrical
measurements have been developed. Measurements of several operational
parameters are also included in the qualification procedure. Among them are
pixel noise, gains and pedestals. Test and qualification procedures of the
pixel barrel modules are described and some results are presented.
-
The Proceedings of the 2003 SLAC Workshops on flavor physics with a high
luminosity asymmetric e+e- collider. The sensitivity of flavor physics to
physics beyond the Standard Model is addressed in detail, in the context of the
improvement of experimental measurements and theoretical calculations.
A new pixel detector for the CMS experiment was built in order to cope with the instantaneous luminosities anticipated for the Phase~I Upgrade of the LHC. The new CMS pixel detector provides four-hit tracking with a reduced material budget as well as new cooling and powering schemes. A new front-end readout chip mitigates buffering and bandwidth limitations, and allows operation at low comparator thresholds. In this paper, comprehensive test beam studies are presented, which have been conducted to verify the design and to quantify the performance of the new detector assemblies in terms of tracking efficiency and spatial resolution. Under optimal conditions, the tracking efficiency is $99.95\pm0.05\,\%$, while the intrinsic spatial resolutions are $4.80\pm0.25\,\mu \mathrm{m}$ and $7.99\pm0.21\,\mu \mathrm{m}$ along the $100\,\mu \mathrm{m}$ and $150\,\mu \mathrm{m}$ pixel pitch, respectively. The findings are compared to a detailed Monte Carlo simulation of the pixel detector and good agreement is found.
The degradation of signal in silicon sensors is studied under conditions expected at the CERN High-Luminosity LHC. 200 $\mu$m thick n-type silicon sensors are irradiated with protons of different energies to fluences of up to $3 \cdot 10^{15}$ neq/cm$^2$. Pulsed red laser light with a wavelength of 672 nm is used to generate electron-hole pairs in the sensors. The induced signals are used to determine the charge collection efficiencies separately for electrons and holes drifting through the sensor. The effective trapping rates are extracted by comparing the results to simulation. The electric field is simulated using Synopsys device simulation assuming two effective defects. The generation and drift of charge carriers are simulated in an independent simulation based on PixelAV. The effective trapping rates are determined from the measured charge collection efficiencies and the simulated and measured time-resolved current pulses are compared. The effective trapping rates determined for both electrons and holes are about 50% smaller than those obtained using standard extrapolations of studies at low fluences and suggests an improved tracker performance over initial expectations.
Pixel detectors are used in the innermost part of multi purpose experiments at the Large Hadron Collider (LHC) and are therefore exposed to the highest fluences of ionising radiation, which in this part of the detectors consists mainly of charged pions. The radiation hardness of the detectors has thoroughly been tested up to the fluences expected at the LHC. In case of an LHC upgrade the fluence will be much higher and it is not yet clear up to which radii the present pixel technology can be used. In order to establish such a limit, pixel sensors of the size of one CMS pixel readout chip (PSI46V2.1) have been bump bonded and irradiated with positive pions up to 6E14 Neq/cm^2 at PSI and with protons up to 5E15 Neq/cm^2. The sensors were taken from production wafers of the CMS barrel pixel detector. They use n-type DOFZ material with a resistance of about 3.7kOhm cm and an n-side read out. As the performance of silicon sensors is limited by trapping, the response to a Sr-90 source was investigated. The highly energetic beta-particles represent a good approximation to minimum ionising particles. The bias dependence of the signal for a wide range of fluences will be presented.
With the advent of the LHC, we will be able to probe New Physics (NP) up to energy scales almost one order of magnitude larger than it has been possible with present accelerator facilities. While direct detection of new particles will be the main avenue to establish the presence of NP at the LHC, indirect searches will provide precious complementary information, since most probably it will not be possible to measure the full spectrum of new particles and their couplings through direct production. In particular, precision measurements and computations in the realm of flavour physics are expected to play a key role in constraining the unknown parameters of the Lagrangian of any NP model emerging from direct searches at the LHC. The aim of Working Group 2 was twofold: on one hand, to provide a coherent, up-to-date picture of the status of flavour physics before the start of the LHC; on the other hand, to initiate activities on the path towards integrating information on NP from high-pT and flavour data.