-
A new pixel detector for the CMS experiment was built in order to cope with
the instantaneous luminosities anticipated for the Phase~I Upgrade of the LHC.
The new CMS pixel detector provides four-hit tracking with a reduced material
budget as well as new cooling and powering schemes. A new front-end readout
chip mitigates buffering and bandwidth limitations, and allows operation at low
comparator thresholds. In this paper, comprehensive test beam studies are
presented, which have been conducted to verify the design and to quantify the
performance of the new detector assemblies in terms of tracking efficiency and
spatial resolution. Under optimal conditions, the tracking efficiency is
$99.95\pm0.05\,\%$, while the intrinsic spatial resolutions are
$4.80\pm0.25\,\mu \mathrm{m}$ and $7.99\pm0.21\,\mu \mathrm{m}$ along the
$100\,\mu \mathrm{m}$ and $150\,\mu \mathrm{m}$ pixel pitch, respectively. The
findings are compared to a detailed Monte Carlo simulation of the pixel
detector and good agreement is found.
-
We have prepared the oxyhydrate Na03RhO206H2O by extracting Na+ cations from
NaRhO2 and intercalating water molecules using an aqueous solution of Na2S2O8.
Synchrotron X-ray powder diffraction, thermogravimetric analysis (TGA), and
energy-dispersive x-ray analysis (EDX) reveal that a non-stoichiometric
Na03(H2O)06 network separates layers of edge-sharing RhO6 octahedra containing
Rh3+(4d6, S=0) and Rh4+ (4d5, S=1/2). The resistivities of NaRhO2 and
Na03RhO206H2O (T < 300) reveal insulating and semi-conducting behavior with
activation gaps of 134 meV and 7.8 meV, respectively. Both Na03RhO206H2O and
NaRhO2 show paramagnetism at room temperature, however, the sodium-deficient
sample exhibits simultaneously a weak but experimentally reproducible
ferromagnetic component. Both samples exhibit a temperature-independent Pauli
paramagnetism, for NaRhO2 at T > 50 K and for Na03RhO206H2O at T > 25 K. The
relative magnitudes of the temperature-independent magnetic susceptibilities,
that of the oxide sample being half that of the oxyhydrate, is consistent with
a higher density of thermally accessible electron states at the Fermi level in
the hydrated sample. At low temperatures the magnetic moments rise sharply,
providing evidence of localized and weakl -ordered electronic spins.
-
The monolayer hydrate (MLH) K03CoO2 x 04H2O was synthesized from K06CoO2 by
extracting K+ cations using K2S2O8 as an oxidant and the subsequent
intercalation of water between the layers of edge-sharing CoO6 octahedra. A
hexagonal structure (space group P63/mmc) with lattice parameters a = 2.8262(1)
Angstrom, c = 13.8269(6) Angstrom similar to the MLH Na036CoO2 x 07H2O was
established using high-resolution synchrotron X-ray powder diffraction data.
The K/H2O layer in the K-MLH is disordered, which is in contrast to the Na-MLH.
At low temperatures metallic and paramagnetic behavior was found.
-
The cubic perovskite-related ceramic CaCu3Ti4O12 has a very high static
dielectric constant ~10000 at room temperature (RT), which drops to about 100
below about 100 K. Substituting Cd for Ca reduces the RT value of the
dielectric constant by over an order of magnitude. The large the dielectric
constant may be due to an internal barrier layer capacitance (IBLC) effect.
Infrared optical properties show a low-frequency mode that increases
dramatically in strength at low temperature, suggesting a change in the
effective charges and a breakdown of the IBLC model due to a
semiconductor-to-insulator transition.
-
Pulsed-laser deposition has been used to grow epitaxial thin films of the
giant-dielectric-constant material CaCu_3Ti_4O_{12} on LaAlO_3 and SrTiO_3
substrates with or without various conducting buffer layers. The latter include
YBa_2Cu_3O_7, La_{1.85}Sr_{0.15}CuO_{4+\delta} and LaNiO_3. Above 100K - 150K
the thin films have a temperature independent dielectric constant as do single
crystals. The value of the dielectric constant is of the order of 1500 over a
wide temperature region, potentially making it a good candidate for many
applications. The frequency dependence of its dielectric properties below 100K
- 150K indicates an activated relaxation process.
A new pixel detector for the CMS experiment was built in order to cope with the instantaneous luminosities anticipated for the Phase~I Upgrade of the LHC. The new CMS pixel detector provides four-hit tracking with a reduced material budget as well as new cooling and powering schemes. A new front-end readout chip mitigates buffering and bandwidth limitations, and allows operation at low comparator thresholds. In this paper, comprehensive test beam studies are presented, which have been conducted to verify the design and to quantify the performance of the new detector assemblies in terms of tracking efficiency and spatial resolution. Under optimal conditions, the tracking efficiency is $99.95\pm0.05\,\%$, while the intrinsic spatial resolutions are $4.80\pm0.25\,\mu \mathrm{m}$ and $7.99\pm0.21\,\mu \mathrm{m}$ along the $100\,\mu \mathrm{m}$ and $150\,\mu \mathrm{m}$ pixel pitch, respectively. The findings are compared to a detailed Monte Carlo simulation of the pixel detector and good agreement is found.