• The oxygen dopants are essential in tuning electronic properties of Bi$_2$Sr$_2$Ca$_{n-1}$Cu$_n$O$_{2n+4+\delta}$ superconductors. Here we apply the technique of scanning tunneling microscopy and spectroscopy to study the influence of oxygen dopants in an optimally doped Bi$_2$Sr$_{2-x}$La$_x$CuO$_{6+\delta}$ and an overdoped Bi$_{2-y}$Pb$_y$Sr$_2$CuO$_{6+\delta}$. In both samples, we find that interstitial oxygen atoms on the SrO layers dominate over the other two forms of oxygen dopants, oxygen vacancies on the SrO layers and interstitial oxygen atoms on the BiO layers. The hole doping is estimated from the oxygen concentration, as compared to the result extracted from the measured Fermi surface. The precise spatial location is employed to obtain a negative correlation between the oxygen dopants and the inhomogeneous pseudogap.
  • The pseudogap (PG) state and its related intra-unit-cell symmetry breaking remain the focus in the research of cuprate superconductors. Although the nematicity has been studied in Bi$_2$Sr$_2$CaCu$_2$O$_{8+\delta}$, especially underdoped samples, its behavior in other cuprates and different doping regions is still unclear. Here we apply a scanning tunneling microscope to explore an overdoped (Bi, Pb)$_2$Sr$_2$CuO$_{6+\delta}$ with a large Fermi surface (FS). The establishment of a nematic order and its real-space distribution is visualized as the energy scale approaches the PG.
  • As emerging topological nodal-line semimetals, the family of ZrSiX (X = O, S, Se, Te) has attracted broad interests in condensed matter physics due to their future applications in spintonics. Here, we apply a scanning tunneling microscopy (STM) to study the structural symmetry and electronic topology of ZrSiSe. The glide mirror symmetry is verified by quantifying the lattice structure of the ZrSe bilayer based on bias selective topographies. The quasiparticle interference analysis is used to identify the band structure of ZrSiSe. The nodal line is experimentally determined at $\sim$ 250 meV above the Fermi level. An extra surface state Dirac point at $\sim$ 400 meV below the Fermi level is also determined. Our STM measurement provides a direct experimental evidence of the nodal-line state in the family of ZrSiX.
  • The discovery of high-temperature superconductivity in FeSe/STO has trigged great research interest to reveal a range of exotic physical phenomena in this novel material. Here we present a temperature dependent magnetotransport measurement for ultrathin FeSe/STO films with different thickness and protection layers. Remarkably, a surprising linear magnetoresistance (LMR) is observed around the superconducting transition temperatures but absent otherwise. The experimental LMR can be reproduced by magnetotransport calculations based on a model of magnetic field dependent disorder induced by spin fluctuation. Thus, the observed LMR in coexistence with superconductivity provides the first magnetotransport signature for spin fluctuation around the superconducting transition region in ultrathin FeSe/STO films.
  • Skin cancer, the most common human malignancy, is primarily diagnosed visually by physicians [1]. Classification with an automated method like CNN [2, 3] shows potential for challenging tasks [1]. By now, the deep convolutional neural networks are on par with human dermatologist [1]. This abstract is dedicated on developing a Deep Learning method for ISIC [5] 2017 Skin Lesion Detection Competition hosted at [6] to classify the dermatology pictures, which is aimed at improving the diagnostic accuracy rate and general level of the human health. The challenge falls into three sub-challenges, including Lesion Segmentation, Lesion Dermoscopic Feature Extraction and Lesion Classification. This project only participates in the Lesion Classification part. This algorithm is comprised of three steps: (1) original images preprocessing, (2) modelling the processed images using CNN [2, 3] in Caffe [4] framework, (3) predicting the test images and calculating the scores that represent the likelihood of corresponding classification. The models are built on the source images are using the Caffe [4] framework. The scores in prediction step are obtained by two different models from the source images.
  • Interface-enhanced high-temperature superconductivity in one unit-cell (UC) FeSe films on SrTiO3(001) (STO) substrate has recently attracted much attention in condensed matter physics and material science. By combined in-situ scanning tunneling microscopy/spectroscopy (STM/STS) and ex-situ scanning transmission electron microscopy (STEM) studies, we report on atomically resolved structure including both lattice constants and actual atomic positions of the FeSe/STO interface under both non-superconducting and superconducting states. We observed TiO2 double layers (DLs) and significant atomic displacements in the top two layers of STO, lattice compression of the Se-Fe-Se triple layer, and relative shift between bottom Se and topmost Ti atoms. By imaging the interface structures under various superconducting states, we unveil a close correlation between interface structure and superconductivity. Our atomic-scale identification of FeSe/STO interface structure provides useful information on investigating the pairing mechanism of this interface-enhanced high-temperature superconducting system.
  • Interface-enhanced high-temperature superconductivity in one unit-cell (UC) FeSe film on SrTiO3(001) (STO) substrate has recently attracted much attention in condensed matter physics and material science. Here, by ex situ transport measurements, we report on the superconductivity in FeSe ultra-thin films with different thickness on STO substrate. We find that the onset superconducting transition temperature (Tc) decreases with increasing film thickness of FeSe, which is opposite to the behavior usually observed in traditional superconductor films. By systematic post-annealing of 5 UC FeSe films, we observe an insulator to superconductor transition, which is accompanied with a sign change of the dominated charge carriers from holes to electrons at low temperatures according to the corresponding Hall measurement.
  • Interface enhanced superconductivity at two dimensional limit has become one of most intriguing research directions in condensed matter physics. Here, we report the superconducting properties of ultra-thin FeSe films with the thickness of one unit cell (1-UC) grown on conductive and insulating SrTiO3 (STO) substrates. For the 1-UC FeSe on conductive STO substrate (Nb-STO), the magnetization versus temperature (M-T) measurement shows a diamagnetic signal at 85 K, suggesting the possibility of superconductivity appears at this high temperature. For the FeSe films on insulating STO substrate, systematic transport measurements were carried out and the sheet resistance of FeSe films exhibits Arrhenius TAFF behavior with a crossover from a single-vortex pinning region to a collective creep region. More intriguing, sign reversal of Hall resistance with temperature is observed, demonstrating a crossover from hole conduction to electron conduction above Tc in 1-UC FeSe films.
  • The latest discovery of possible high temperature superconductivity in the single-layer FeSe film grown on a SrTiO3 substrate, together with the observation of its unique electronic structure and nodeless superconducting gap, has generated much attention. Initial work also found that, while the single-layer FeSe/SrTiO3 film exhibits a clear signature of superconductivity, the double-layer FeSe/SrTiO3 film shows an insulating behavior. Such a dramatic difference between the single-layer and double-layer FeSe/SrTiO3 films is surprising and the underlying origin remains unclear. Here we report our comparative study between the single-layer and double-layer FeSe/SrTiO3 films by performing a systematic angle-resolved photoemission study on the samples annealed in vacuum. We find that, like the single-layer FeSe/SrTiO3 film, the as-prepared double-layer FeSe/SrTiO3 film is insulating and possibly magnetic, thus establishing a universal existence of the magnetic phase in the FeSe/SrTiO3 films. In particular, the double-layer FeSe/SrTiO3 film shows a quite different doping behavior from the single-layer film in that it is hard to get doped and remains in the insulating state under an extensive annealing condition. The difference originates from the much reduced doping efficiency in the bottom FeSe layer of the double-layer FeSe/SrTiO3 film from the FeSe-SrTiO3 interface. These observations provide key insights in understanding the origin of superconductivity and the doping mechanism in the FeSe/SrTiO3 films. The property disparity between the single-layer and double-layer FeSe/SrTiO3 films may facilitate to fabricate electronic devices by making superconducting and insulating components on the same substrate under the same condition.
  • In high temperature cuprate superconductors, it is now generally agreed that the parent compound is a Mott insulator and superconductivity is realized by doping the antiferromagnetic Mott insulator. In the iron-based superconductors, however, the parent compound is mostly antiferromagnetic metal, raising a debate on whether an appropriate starting point should go with an itinerant picture or a localized picture. It has been proposed theoretically that the parent compound of the iron-based superconductors may be on the verge of a Mott insulator, but so far no clear experimental evidence of doping-induced Mott transition has been available. Here we report an electronic evidence of an insulator-superconductor transition observed in the single-layer FeSe films grown on the SrTiO3 substrate. By taking angle-resolved photoemission measurements on the electronic structure and energy gap, we have identified a clear evolution of an insulator to a superconductor with the increasing doping. This observation represents the first example of an insulator-superconductor transition via doping observed in the iron-based superconductors. It indicates that the parent compound of the iron-based superconductors is in proximity of a Mott insulator and strong electron correlation should be considered in describing the iron-based superconductors.
  • Heterostructure based interface engineering has been proved an effective method for finding new superconducting systems and raising superconductivity transition temperature (TC). In previous work on one unit-cell (UC) thick FeSe films on SrTiO3 (STO) substrate, a superconducting-like energy gap as large as 20 meV, was revealed by in situ scanning tunneling microscopy/spectroscopy (STM/STS). Angle resolved photoemission spectroscopy (ARPES) further revealed a nearly isotropic gap of above 15 meV, which closes at a temperature of ~ 65 K. If this transition is indeed the superconducting transition, then the 1-UC FeSe represents the thinnest high TC superconductor discovered so far. However, up to date direct transport measurement of the 1-UC FeSe films has not been reported, mainly because growth of large scale 1-UC FeSe films is challenging and the 1-UC FeSe films are too thin to survive in atmosphere. In this work, we successfully prepared 1-UC FeSe films on insulating STO substrates with non-superconducting FeTe protection layers. By direct transport and magnetic measurements, we provide definitive evidence for high temperature superconductivity in the 1-UC FeSe films with an onset TC above 40 K and a extremely large critical current density JC ~ 1.7*106 A/cm2 at 2 K. Our work may pave the way to enhancing and tailoring superconductivity by interface engineering.
  • Superconductivity in the cuprate superconductors and the Fe-based superconductors is realized by doping the parent compound with charge carriers, or by application of high pressure, to suppress the antiferromagnetic state. Such a rich phase diagram is important in understanding superconductivity mechanism and other physics in the Cu- and Fe-based high temperature superconductors. In this paper, we report a phase diagram in the single-layer FeSe films grown on SrTiO3 substrate by an annealing procedure to tune the charge carrier concentration over a wide range. A dramatic change of the band structure and Fermi surface is observed, with two distinct phases identified that are competing during the annealing process. Superconductivity with a record high transition temperature (Tc) at ~65 K is realized by optimizing the annealing process. The wide tunability of the system across different phases, and its high-Tc, make the single-layer FeSe film ideal not only to investigate the superconductivity physics and mechanism, but also to study novel quantum phenomena and for potential applications.
  • The latest discovery of high temperature superconductivity signature in single-layer FeSe is significant because it is possible to break the superconducting critical temperature ceiling (maximum Tc~55 K) that has been stagnant since the discovery of Fe-based superconductivity in 2008. It also blows the superconductivity community by surprise because such a high Tc is unexpected in FeSe system with the bulk FeSe exhibiting a Tc at only 8 K at ambient pressure which can be enhanced to 38 K under high pressure. The Tc is still unusually high even considering the newly-discovered intercalated FeSe system A_xFe_{2-y}Se_2 (A=K, Cs, Rb and Tl) with a Tc at 32 K at ambient pressure and possible Tc near 48 K under high pressure. Particularly interesting is that such a high temperature superconductivity occurs in a single-layer FeSe system that is considered as a key building block of the Fe-based superconductors. Understanding the origin of high temperature superconductivity in such a strictly two-dimensional FeSe system is crucial to understanding the superconductivity mechanism in Fe-based superconductors in particular, and providing key insights on how to achieve high temperature superconductivity in general. Here we report distinct electronic structure associated with the single-layer FeSe superconductor. Its Fermi surface topology is different from other Fe-based superconductors; it consists only of electron pockets near the zone corner without indication of any Fermi surface around the zone center. Our observation of large and nearly isotropic superconducting gap in this strictly two-dimensional system rules out existence of node in the superconducting gap. These results have provided an unambiguous case that such a unique electronic structure is favorable for realizing high temperature superconductivity.
  • This paper has been withdrawn by the author