• ### Study of Two-Body $e^+e^- \to B_s^{(*)}\bar{B}_s^{(*)}$ Production in the Energy Range from 10.77 to 11.02 GeV(1609.08749)

Sept. 28, 2016 hep-ex
We report results on the studies of the $e^+e^-\to B_s^{(*)}\bar{B}_s^{(*)}$ processes. The results are based on a $121.4$ fb$^{-1}$ data sample collected with the Belle detector at the center-of-mass energy near the $\Upsilon(10860)$ peak and $16.4$ fb$^{-1}$ of data collected at 19 energy points in the range from 10.77 to 11.02 GeV. We observe a clear $e^+e^-\to\Upsilon(10860)\to B_s^{(*)}\bar{B}_s^{(*)}$ signal, with no statistically significant signal of $e^+e^-\to \Upsilon(11020)\to B_s^{(*)}\bar{B}_s^{(*)}$. The relative production ratio of $B_s^*\bar{B}_s^*$, $B_s\bar{B}_s^{*}$, and $B_s\bar{B}_s$ final states at $\sqrt{s}=10.866$ GeV is measured to be $7:$ $0.856\pm0.106(stat.)\pm0.053(syst.):$ $0.645\pm0.094(stat.)^{+0.030}_{-0.033}(syst.)$. An angular analysis of the $B_s^*\bar{B}_s^*$ final state produced at the $\Upsilon(10860)$ peak is also performed.
• ### A tagged low-momentum kaon test-beam exposure with a 250L LAr TPC (J-PARC T32)(1105.5818)

May 29, 2011 physics.ins-det
At the beginning of 2010, we presented at the J-PARC PAC an R$&$D program towards large (100 kton scale) liquid argon TPCs, suitable to investigate, in conjunction with the J-PARC neutrino beam, the possibility of CP violation in the neutrino sector and to search for nucleon decay. As a first step we proposed a test experiment to identify and measure charged kaons, including their decays, in liquid argon. The detector, a 250L LAr TPC, is exposed to charged kaons, in a momentum range of 540-800 MeV/c, in the K1.1BR beamline of the J-PARC slow extraction facility. This is especially important to estimate efficiency and background for nucleon decay searches in the charged kaon mode ($p \rightarrow \bar{\nu} K^+$, etc.), where the kaon momentum is expected to be in the few hundred MeV/c range. A prototype setup has been exposed in the K1.1BR beamline in the fall of 2010. This paper describes the capabilities of the beamline, the construction and setting up of the detector prototype, along with some preliminary results.
• ### Letter of Intent for KASKA: High Accuracy Neutrino Oscillation Measurements with anti-nu_es from Kashiwazaki-Kariwa Nuclear Power Station(hep-ex/0607013)

July 11, 2006 hep-ex
One of the current most-demanded experiments in neutrino physics is to measure the last mixing angle theta_13. KASKA is an experiment to detect new type of reactor neutrino oscillation and to measure sin^2 2theta_13 accurately using the world's most powerful nuclear reactor complex; Kashiwazaki-Kariwa nuclear power station. KASKA utilizes near and far detectors of identical structure at nearly optimized baselines and underground depths to cancel most of the systematics and reduce backgrounds. The expected sensitivity is sin^2 2theta_13~0.015, which is 10 times better sensitivity than the current upper limit measured by CHOOZ reactor experiment. Extension of KASKA project has potential to accurately measure other anti-nu_e oscillation parameters. Intense and precisely known neutrino flux measured by the KASKA-theta_13 phase can be used to pin down sin^2 2theta_12 at a baseline ~50km and to measure Dm^2_13 for the first time at a baseline ~5km. This Letter of Intent describes physics motivation, detector system and expected performance of the KASKA experiment.
• ### The Data Acquisition System Based on PMC Bus(physics/0305137)

May 30, 2003 physics.ins-det
High energy physics experiments in KEK/Japan rush into over KHz trigger stage. Thus, we need a successor of the data acquisition(DAQ) system that replaces the CAMAC or FASTBUS systems. To meet these needs, we have developed a DAQ system which includes a crate, base-board modules, daughter cards for front-end A/D or T/D conversion, and back-end communication cards for data transfer and timing control. The size of the crate is for the 9U Euro-cards with the standard VME32 bus and extension connectors for power supply. The base-board comprises of a local bus with the sequencer connected to the front-end daughter cards via event buffering FIFOs, and the standard PMC (PCI mezzanine card) bus to be set a PMC processor unit to reduce data size from the front-end daughter cards. A data transfer module, which is connected to the event building system, and a trigger control unit, which communicates with the central timing controller are installed on the back-end communication card connected to the rear end of the base-board. We describe the design of this DAQ system and evaluate the performance of it.