• In this paper, the theoretical aspects behind longitudinal RF capture are reviewed and the capture process is simulated via a program based on this theory. Four kinds of cases with different initial distribution and capture curve are considered, i.e. uniform distribution with adiabatic capture, uniform distribution with non-adiabatic capture, Gaussian distribution with adiabatic capture and Gaussian distribution with non-adiabatic capture. The simulation results are compared each other and discussed, and Gaussian distribution with adiabatic capture is demonstrated having a higher capture efficiency and leading to a shorter bunch length. In addition, the BPM induced signal is simulated with high input impendence, i.e. $1M\Omega$, and low input impendence, i.e. $50\Omega$, respectively. Finally, the BPM signal of Heavy Ion Medical Machine (HIMM) is estimated and compared with measured one, and a good agreement is achieved.
  • To improve the control efficiency of Superconducting Electron Cyclotron Resonance Ion source(SECRAL) for Heavy Ion Research Facility in Lanzhou(HIRFL), a upgrade version of control system for SECRAL is designed and set up. The control software package is developed by Visual C++, which is able to control and monitor all of the equipment for the SECRAL system about 130 parameters. The previous analog power supplies are replaced by four digital power units at High Voltage(HV) platform, The old slow speed of AC motors are upgraded to servo motors newly for higher precision, stability and linearity. Meanwhile, some control strategy and user interface are optimized. In order to prevent the incorrect operation which may cause the quench of the superconducting magnet, alarm and interlock protection functions are added to the software and hardware. Since the upgraded SECRAL control system is online, it has been running smoothly.
  • The kicker control system was used for beam extraction and injection between two cooling storage rings (CSRs) at the Heavy Ion Research Facility in Lanzhou (HIRFL). To meet the requirements of special physics experiments, the kicker controller was upgraded. The new controller was designed based on ARM+DSP+FPGA technology and monolithic circuit architecture, which can achieve a precision time delay of 2.5 ns. In September 2014, the new kicker control system was installed in the kicker field, and the test experiment using the system was completed. In addition, a pre-trigger signal was provided by the controller, which was designed to synchronize the beam diagnostic system and physics experiments. Experimental results indicate that the phenomena of "missed kick" and "inefficient kick" were not observed, and the multichannel trigger signals' delay could be adjusted individually for kick power supplies in digitization; thus, the beam transport efficiency was improved compared with that of the original system. The fast extraction and injection experiment was successfully completed based on the new kicker control systems for HIRFL-CSR.