• ### Short-Packet Two-Way Amplify-and-Forward Relaying(1712.03653)

Dec. 11, 2017 cs.IT, math.IT
This letter investigates an amplify-and-forward two-way relay network (TWRN) for short-packet communications. We consider a classical three-node TWRN consisting of two sources and one relay. Both two time slots (2TS) scheme and three time slots (3TS) scheme are studied under the finite blocklength regime. We derive approximate closed-form expressions of sum-block error rate (BLER) for both schemes. Simple asymptotic expressions for sum-BLER at high signal-to-noise ratio (SNR) are also derived. Based on the asymptotic expressions, we analytically compare the sum-BLER performance of 2TS and 3TS schemes, and attain an expression of critical blocklength, which can determine the performance superiority of 2TS and 3TS in terms of sum-BLER. Extensive simulations are provided to validate our theoretical analysis. Our results discover that 3TS scheme is more suitable for a system with lower relay transmission power, higher differences between the average SNR of both links and relatively lower requirements on data rate and latency.
• ### Distributed Multi-Relay Selection in Accumulate-then-Forward Energy Harvesting Relay Networks(1602.00339)

Oct. 8, 2017 cs.IT, math.IT
This paper investigates a wireless-powered cooperative network (WPCN) consisting of one source-destination pair and multiple decode-and-forward (DF) relays. We develop an energy threshold based multi-relay selection (ETMRS) scheme for the considered WPCN. The proposed ETMRS scheme can be implemented in a fully distributed manner as the relays only need local information to switch between energy harvesting and information forwarding modes. By modeling the charging/discharging behaviours of the finite-capacity battery at each relay as a finite-state Markov Chain (MC), we derive an analytical expression for the system outage probability of the proposed ETMRS scheme over mixed Nakagami-$m$ and Rayleigh fading channels. Based on the derived expression, the optimal energy thresholds for all the relays corresponding to the minimum system outage probability can be obtained via an exhaustive search. However, this approach becomes computationally prohibitive when the number of relays and the associated number of battery energy levels is large. To resolve this issue, we propose a heuristic approach to optimize the energy threshold for each relay. To gain some useful insights for practical relay design, we also derive the upper bound for system outage probability corresponding to the case that all relays are equipped with infinite-capacity batteries. Numerical results validate our theoretical analysis. It is shown that the proposed heuristic approach can achieve a near-optimal system performance and our ETMRS scheme outperforms the existing single-relay selection scheme and common energy threshold scheme.
• ### Exploiting Energy Accumulation Against Co-channel Interference in Wireless Energy Harvesting MIMO Relaying(1609.09161)

Sept. 29, 2016 cs.IT, math.IT
This paper investigates a three-node multiple-input multiple-output relay system suffering from co-channel interference (CCI) at the multi-antenna relay. Contrary to the conventional relay networks, we consider the scenario that the relay is an energy harvesting (EH) node and has no embedded energy supply. But it is equipped with a rechargeable battery such that it can harvest and accumulate the harvested energy from RF signals sent by the source and co-channel interferers to support its operation. Leveraging the inherent feature of the considered system, we develop a novel accumulate-then-forward (ATF) protocol to eliminate the harmful effect of CCI. In the proposed ATF scheme, at the beginning of each transmission block, the relay can choose either EH operation to harvest energy from source and CCI or information decoding (ID) operation to decode and forward source's information while suffering from CCI. Specifically, ID operation is activated only when the accumulated energy at the relay can support an outage-free transmission in the second hop. Otherwise, EH operation is invoked at the relay to harvest and accumulate energy. By modeling the finite-capacity battery of relay as a finite-state Markov Chain (MC), we derive a closed-form expression for the system throughput of the proposed ATF scheme over mixed Nakagami-m and Rayleigh fading channels. Numerical results validate our theoretical analysis, and show that the proposed ATF scheme with energy accumulation significantly outperforms the existing one without energy accumulation.
• ### Wireless-Powered Two-Way Relaying with Power Splitting-based Energy Accumulation(1608.01859)

Aug. 5, 2016 cs.IT, math.IT
This paper investigates a wireless-powered two-way relay network (WP-TWRN), in which two sources exchange information with the aid of one amplify-and-forward (AF) relay. Contrary to the conventional two-way relay networks, we consider the scenario that the AF relay has no embedded energy supply, and it is equipped with an energy harvesting unit and rechargeable battery. As such, it can accumulate the energy harvested from both sources' signals before helping forwarding their information. In this paper, we develop a power splitting-based energy accumulation (PS-EA) scheme for the considered WP-TWRN. To determine whether the relay has accumulated sufficient energy, we set a predefined energy threshold for the relay. When the accumulated energy reaches the threshold, relay splits the received signal power into two parts, one for energy harvesting and the other for information forwarding. If the stored energy at the relay is below the threshold, all the received signal power will be accumulated at the relay's battery. By modeling the finite-capacity battery of relay as a finite-state Markov Chain (MC), we derive a closed-form expression for the system throughput of the proposed PS-EA scheme over Nakagami-m fading channels. Numerical results validate our theoretical analysis and show that the proposed PS-EA scheme outperforms the conventional time switching-based energy accumulation (TS-EA) scheme and the existing power splitting schemes without energy accumulation.
• ### Accumulate then Forward: An Opportunistic Relaying Protocol for Wireless-Powered Cooperative Communications(1606.05057)

June 16, 2016 cs.IT, math.IT
This paper investigates a wireless-powered cooperative communication network consisting of a source, a destination and a multi-antenna decode-and-forward relay. We consider the relay as a wireless-powered node that has no external power supply; but it is equipped with an energy harvesting (EH) unit and a rechargeable battery such that it can harvest and accumulate energy from radio-frequency signals broadcast by the source. By fully incorporating the EH feature of the relay, we develop an opportunistic relaying protocol, termed accumulate-then-forward (ATF), for the considered WPCCN. We then adopt the discrete Markov chain to model the dynamic charging and discharging behaviors of the relay battery. Based on this, we derive a closed-form expression for the exact outage probability of the proposed ATF protocol. Numerical results show that the ATF scheme can outperform the direct transmission one, especially when the amount of energy consumed by relay for information forwarding is optimized.
• ### A Discrete Time-Switching Protocol for Wireless-Powered Communications with Energy Accumulation(1512.03221)

Dec. 10, 2015 cs.IT, math.IT
This paper investigates a wireless-powered communication network (WPCN) setup with one multi-antenna access point (AP) and one single-antenna source. It is assumed that the AP is connected to an external power supply, while the source does not have an embedded energy supply. But the source could harvest energy from radio frequency (RF) signals sent by the AP and store it for future information transmission. We develop a discrete time-switching (DTS) protocol for the considered WPCN. In the proposed protocol, either energy harvesting (EH) or information transmission (IT) operation is performed during each transmission block. Specifically, based on the channel state information (CSI) between source and AP, the source can determine the minimum energy required for an outage-free IT operation. If the residual energy of the source is sufficient, the source will start the IT phase. Otherwise, EH phase is invoked and the source accumulates the harvested energy. To characterize the performance of the proposed protocol, we adopt a discrete Markov chain (MC) to model the energy accumulation process at the source battery. A closed-form expression for the average throughput of the DTS protocol is derived. Numerical results validate our theoretical analysis and show that the proposed DTS protocol considerably outperforms the existing harvest-then-transmit protocol when the battery capacity at the source is large.
• ### An Adaptive Transmission Protocol for Wireless-Powered Cooperative Communications(1508.01892)

Aug. 8, 2015 cs.IT, math.IT
In this paper, we consider a wireless-powered cooperative communication network, which consists of one hybrid access point (AP), one source and one relay to assist information transmission. Unlike conventional cooperative networks, the source and relay are assumed to have no embedded energy supplies in the considered system. Hence, they need to first harvest energy from the radio-frequency (RF) signals radiated by the AP in the downlink (DL) before information transmission in the uplink (UL). Inspired by the recently proposed harvest-then-transmit (HTT) and harvest-then-cooperate (HTC) protocols, we develop a new adaptive transmission (AT) protocol. In the proposed protocol, at the beginning of each transmission block, the AP charges the source. AP and source then perform channel estimation to acquire the channel state information (CSI) between them. Based on the CSI estimate, the AP adaptively chooses the source to perform UL information transmission either directly or cooperatively with the relay. We derive an approximate closed-form expression for the average throughput of the proposed AT protocol over Nakagami-m fading channels. The analysis is then verified by Monte Carlo simulations. Results show that the proposed AT protocol considerably outperforms both the HTT and HTC protocols.