-
Spherical harmonic moments are well-suited for capturing anisotropy at any
scale in the flux of cosmic rays. An unambiguous measurement of the full set of
spherical harmonic coefficients requires full-sky coverage. This can be
achieved by combining data from observatories located in both the northern and
southern hemispheres. To this end, a joint analysis using data recorded at the
Telescope Array and the Pierre Auger Observatory above $10^{19}$ eV is
presented in this work. The resulting multipolar expansion of the flux of
cosmic rays allows us to perform a series of anisotropy searches, and in
particular to report on the angular power spectrum of cosmic rays above
$10^{19}$ eV. No significant deviation from isotropic expectations is found
throughout the analyses performed. Upper limits on the amplitudes of the dipole
and quadrupole moments are derived as a function of the direction in the sky,
varying between 7% and 13% for the dipole and between 7% and 10% for a
symmetric quadrupole.
-
ArDM-1t is the prototype for a next generation WIMP detector measuring both
the scintillation light and the ionization charge from nuclear recoils in a
1-ton liquid argon target. The goal is to reach a minimum recoil energy of
30\,keVr to detect recoiling nuclei. In this paper we describe the experimental
concept and present results on the light detection system, tested for the first
time in ArDM on the surface at CERN. With a preliminary and incomplete set of
PMTs, the light yield at zero electric field is found to be between 0.3-0.5
phe/keVee depending on the position within the detector volume, confirming our
expectations based on smaller detector setups.
-
The aim of the ArDM project is the development and operation of a one ton
double-phase liquid argon detector for direct Dark Matter searches. The
detector measures both the scintillation light and the ionization charge from
ionizing radiation using two independent readout systems. This paper briefly
describes the detector concept and presents preliminary results from the ArDM
R&D program, including a 3 l prototype developed to test the charge readout
system.
-
To optimise the design of the light readout in the ArDM 1-ton liquid argon
dark matter detector, a range of reflector and WLS coating combinations were
investigated in several small setups, where argon scintillation light was
generated by radioactive sources in gas at normal temperature and pressure and
shifted into the blue region by tetraphenyl butadiene (TPB). Various
thicknesses of TPB were deposited by spraying and vacuum evaporation onto
specular 3M{\small\texttrademark}-foil and diffuse
Tetratex{\small\textregistered} (TTX) substrates. Light yields of each
reflector and TPB coating combination were compared. Reflection coefficients of
TPB coated reflectors were independently measured using a spectroradiometer in
a wavelength range between 200 and 650 nm. WLS coating on the PMT window was
also studied. These measurements were used to define the parameters of the
light reflectors of the ArDM experiment. Fifteen large $120\times 25$ cm$^2$
TTX sheets were coated and assembled in the detector. Measurements in argon gas
are reported providing good evidence of fulfilling the light collection
requirements of the experiment.
-
Grand Unification of the strong, weak and electromagnetic interactions into a
single unified gauge group is an extremely appealing idea which has been
vigorously pursued theoretically and experimentally for many years. The
detection of proton or bound-neutron decays would represent its most direct
experimental evidence. In this context, we studied the physics potentialities
of very large underground Liquid Argon Time Projection Chambers (LAr TPC). We
carried out a detailed simulation of signal efficiency and background sources,
including atmospheric neutrinos and cosmogenic backgrounds. We point out that a
liquid Argon TPC, offering good granularity and energy resolution, low particle
detection threshold, and excellent background discrimination, should yield very
good signal over background ratios in many possible decay modes, allowing to
reach partial lifetime sensitivities in the range of $10^{34}-10^{35}$ years
with exposures up to 1000 kton$\times$year, often in quasi-background-free
conditions optimal for discoveries at the few events level, corresponding to
atmospheric neutrino background rejections of the order of $10^5$. Multi-prong
decay modes like e.g. $p\to \mu^- \pi^+ K^+$ or $p\to e^+\pi^+\pi^-$ and
channels involving kaons like e.g. $p\to K^+\bar\nu$, $p\to e^+K^0$ and $p\to
\mu^+K^0$ are particularly suitable, since liquid Argon imaging (...)
Spherical harmonic moments are well-suited for capturing anisotropy at any scale in the flux of cosmic rays. An unambiguous measurement of the full set of spherical harmonic coefficients requires full-sky coverage. This can be achieved by combining data from observatories located in both the northern and southern hemispheres. To this end, a joint analysis using data recorded at the Telescope Array and the Pierre Auger Observatory above $10^{19}$ eV is presented in this work. The resulting multipolar expansion of the flux of cosmic rays allows us to perform a series of anisotropy searches, and in particular to report on the angular power spectrum of cosmic rays above $10^{19}$ eV. No significant deviation from isotropic expectations is found throughout the analyses performed. Upper limits on the amplitudes of the dipole and quadrupole moments are derived as a function of the direction in the sky, varying between 7% and 13% for the dipole and between 7% and 10% for a symmetric quadrupole.
ArDM-1t is the prototype for a next generation WIMP detector measuring both the scintillation light and the ionization charge from nuclear recoils in a 1-ton liquid argon target. The goal is to reach a minimum recoil energy of 30\,keVr to detect recoiling nuclei. In this paper we describe the experimental concept and present results on the light detection system, tested for the first time in ArDM on the surface at CERN. With a preliminary and incomplete set of PMTs, the light yield at zero electric field is found to be between 0.3-0.5 phe/keVee depending on the position within the detector volume, confirming our expectations based on smaller detector setups.
The aim of the ArDM project is the development and operation of a one ton double-phase liquid argon detector for direct Dark Matter searches. The detector measures both the scintillation light and the ionization charge from ionizing radiation using two independent readout systems. This paper briefly describes the detector concept and presents preliminary results from the ArDM R&D program, including a 3 l prototype developed to test the charge readout system.
To optimise the design of the light readout in the ArDM 1-ton liquid argon dark matter detector, a range of reflector and WLS coating combinations were investigated in several small setups, where argon scintillation light was generated by radioactive sources in gas at normal temperature and pressure and shifted into the blue region by tetraphenyl butadiene (TPB). Various thicknesses of TPB were deposited by spraying and vacuum evaporation onto specular 3M{\small\texttrademark}-foil and diffuse Tetratex{\small\textregistered} (TTX) substrates. Light yields of each reflector and TPB coating combination were compared. Reflection coefficients of TPB coated reflectors were independently measured using a spectroradiometer in a wavelength range between 200 and 650 nm. WLS coating on the PMT window was also studied. These measurements were used to define the parameters of the light reflectors of the ArDM experiment. Fifteen large $120\times 25$ cm$^2$ TTX sheets were coated and assembled in the detector. Measurements in argon gas are reported providing good evidence of fulfilling the light collection requirements of the experiment.