-
Chapter 2 in High-Luminosity Large Hadron Collider (HL-LHC) : Preliminary
Design Report. The Large Hadron Collider (LHC) is one of the largest scientific
instruments ever built. Since opening up a new energy frontier for exploration
in 2010, it has gathered a global user community of about 7,000 scientists
working in fundamental particle physics and the physics of hadronic matter at
extreme temperature and density. To sustain and extend its discovery potential,
the LHC will need a major upgrade in the 2020s. This will increase its
luminosity (rate of collisions) by a factor of five beyond the original design
value and the integrated luminosity (total collisions created) by a factor ten.
The LHC is already a highly complex and exquisitely optimised machine so this
upgrade must be carefully conceived and will require about ten years to
implement. The new configuration, known as High Luminosity LHC (HL-LHC), will
rely on a number of key innovations that push accelerator technology beyond its
present limits. Among these are cutting-edge 11-12 tesla superconducting
magnets, compact superconducting cavities for beam rotation with ultra-precise
phase control, new technology and physical processes for beam collimation and
300 metre-long high-power superconducting links with negligible energy
dissipation. The present document describes the technologies and components
that will be used to realise the project and is intended to serve as the basis
for the detailed engineering design of HL-LHC.
-
The TOTEM experiment has been designed to measure the total proton-proton
cross section and to study the elastic and diffractive scattering at the LHC
energy. The measurement requires detecting protons at distances as small as 1
mm from the beam center: TOTEM uses Roman Pots, movable beam pipe insertions,
hosting silicon detectors. In the first period of LHC operation no relevant
problems were detected with Roman Pots retracted or inserted during special
runs. However, when operating the LHC with high intensity beams, impedance
induced heating has been observed during the Roman Pots insertion. In order to
be compatible with the higher LHC beam current foreseen after the LS1, a new
version of the Roman Pot has been proposed and optimized with respect to the
beam coupling impedance. In this work we present the bench impedance
measurements carried out on the new Roman Pot prototype. Single and double wire
measurements, as well as probe measurements, were performed in order to detect
possible harmful resonant modes. The laboratory setup has been as well
simulated with the help of CST Particle Studio in order to benchmark the
measurement results. Measurements and simulations are in close agreement
confirming the equipment compatibility with the LHC requirements for safe
operation.
-
The demanding beam performance requirements of the High Luminosity (HL-) LHC
project translate into a set of requirements and upgrade paths for the LHC
injector complex. In this paper the performance requirements for the SPS and
the known limitations are reviewed in the light of the 2012 operational
experience. The various SPS upgrades in progress and still under consideration
are described, in addition to the machine studies and simulations performed in
2012. The expected machine performance reach is estimated on the basis of the
present knowledge, and the remaining decisions that still need to be made
concerning upgrade options are detailed.