-
Background:The design of new nuclear reactors and transmutation devices
requires to reduce the present neutron cross section uncertainties of minor
actinides. Purpose: Reduce the $^{243}$Am(n,$\gamma$) cross section
uncertainty. Method: The $^{243}$Am(n,$\gamma$) cross section has been measured
at the n_TOF facility at CERN with a BaF$_{2}$ Total Absorption Calorimeter, in
the energy range between 0.7 eV and 2.5 keV. Results: The
$^{243}$Am(n,$\gamma$) cross section has been successfully measured in the
mentioned energy range. The resolved resonance region has been extended from
250 eV up to 400 eV. In the unresolved resonance region our results are
compatible with one of the two incompatible capture data sets available below
2.5 keV. The data available in EXFOR and in the literature has been used to
perform a simple analysis above 2.5 keV. Conclusions: The results of this
measurement contribute to reduce the $^{243}$Am(n,$\gamma$) cross section
uncertainty and suggest that this cross section is underestimated up to 25% in
the neutron energy range between 50 eV and a few keV in the present evaluated
data libraries.
-
Production cross sections of medium-mass neutron-rich nuclei obtained in the
fragmentation of 136Xe projectiles at 1 A GeV have been measured with the
FRagment Separator (FRS) at GSI. 125Pd was identified for the first time. The
measured cross sections are compared to 238U fission yields and model
calculations in order to determine the optimum reaction mechanism to extend the
limits of the chart of the nuclides around the r-process waiting point at N=82.
-
This paper presents the nuclide cross sections and the longitudinal velocity
distributions of residues produced in the reactions of 136Xe and 124Xe at 1 A
GeV in a lead target, measured at the high-resolution magnetic spectrometer,
the Fragment Separator (FRS) of GSI. The data cover a broad range of isotopes
of the elements between Z = 3 and Z = 56 for 136Xe and between Z = 5 and Z = 55
for 124Xe, reaching down to cross sections of a few microbarns. The velocity
distributions exhibit a Gaussian shape for masses above A = 20, while more
complex behaviour is observed for lighter masses. The isotopic distributions
for both reactions preserve a memory on the projectile N/Z ratio over the whole
residue mass range.
-
The structures observed in the sub-threshold neutron-induced fission of
^{232}Th were investigated employing a recent developed model. Theoretical
single-particle excitations of a phenomenological two-humped barrier are
determined by solving a system of coupled differential equations for the motion
along the optimal fission path. A rather good agreement with experimental data
was obtained using a small number of independent parameters. It is predicted
that the structure at 1.4 and 1.6 MeV is mainly dominated by spin 3/2 partial
cross-section with small admixture of spin 1/2, while the structure at 1.7 MeV
is given by a large partial cross section of spin 5/2.
-
The spallation residues produced in the bombardment of 56}Fe at 1.5, 1.0,
0.75, 0.5 and 0.3 A GeV on a liquid-hydrogen target have been measured using
the reverse kinematics technique and the Fragment Separator at GSI (Darmstadt).
This technique has permitted the full identification in charge and mass of all
isotopes produced with cross-sections larger than 10^{-2} mb down to Z=8. Their
individual production cross-sections and recoil velocities at the five energies
are presented. Production cross-sections are compared to previously existing
data and to empirical parametric formulas, often used in cosmic-ray
astrophysics. The experimental data are also extensively compared to different
combinations of intra-nuclear cascade and de-excitation models. It is shown
that the yields of the lightest isotopes cannot be accounted for by standard
evaporation models. The GEMINI model, which includes an asymmetric fission
decay mode, gives an overall good agreement with the data. These experimental
data can be directly used for the estimation of composition modifications and
damages in materials containing iron in spallation sources. They are also
useful for improving high precision cosmic-ray measurements.
-
The production cross sections of fragmentation-evaporation residues in the
reaction Pb+p at 500A MeV have been measured using the inverse-kinematics
method and the FRS spectrometer (GSI). Fragments were identified in nuclear
charge using ionisation chambers. The mass identification was performed
event-by-event using the B-rho - TOF - Delta-E technique. Although
partially-unresolved ionic charge states induced an ambiguity on the mass of
some heavy fragments, production rates could be obtained with a high accuracy
by systematically accounting for the polluting ionic charge states. The
contribution of multiple reactions in the target was subtracted using a new,
partly self-consistent code. The isobaric distributions are found to have a
shape very close to the one observed in experiments at higher energy. Kinematic
properties of the fragments were also measured. The total and the isotopic
cross sections, including charge-pickup cross sections, are in good agreement
with previous measurements. The data are discussed in the light of previous
spallation measurements, especially on lead at 1 GeV.
-
The fine structure of the 0.7 MeV resonance in the 230Th neutron-induced
cross section is investigated within the hybrid model. A very good agreement
with experimental data is obtained. It is suggested that fine structure of the
cross section quantify the changes of the intrinsic states of the nucleus
during the disintegration process.
-
The production of light and intermediate-mass nuclides formed in the reaction
1H+238U at 1 GeV was measured at the Fragment Separator (FRS) at GSI,
Darmstadt. The experiment was performed in inverse kinematics, shooting a 1 A
GeV 238U beam on a thin liquid-hydrogen target. 254 isotopes of all elements in
the range from Z=7 to Z=37 were unambiguously identified, and the velocity
distributions of the produced nuclides were determined with high precision. The
results show that the nuclides are produced in a very asymmetric binary decay
of heavy nuclei originating from the spallation of uranium. All the features of
the produced nuclides merge with the characteristics of the fission products as
their mass increases.
-
Isotopically resolved cross sections and velocity distributions have been
measured in charge-pickup reactions of 1 A GeV 208Pb with proton, deuterium and
titanium target. The total and partial charge-pickup cross sections in the
reactions 208Pb + 1H and 208Pb + 2H are measured to be the same in the limits
of the error bars. A weak increase in the total charge-pickup cross section is
seen in the reaction of 208Pb with the titanium target. The measured velocity
distributions show different contributions - quasi-elastic scattering and
Delta-resonance excitation - to the charge-pickup production. Data on total and
partial charge-pickup cross sections from these three reactions are compared
with other existing data and also with model calculations based on the coupling
of different intra-nuclear cascade codes and an evaporation code.
-
Spallation residues and fission fragments from 1A GeV 238U projectiles
irradiating a liquid hydrogen target were investigated by using the FRagment
Separator at GSI for magnetic selection of reaction products including
ray-tracing, energy-loss and time-of-flight techniques. The
longitudinal-momentum spectra of identified fragments were analysed, and
evaporation residues and fission fragments could be separated. For 1385
nuclides, production cross-sections covering 3 orders of magnitude with a mean
accuracy of 15%, velocities in the U-rest frame and kinetic energies were
determined. In the reaction all elements from uranium to nitrogen were found,
each with a large number of isotopes.
-
The production of heavy nuclides from the spallation-evaporation reaction of
238U induced by 1 GeV protons was studied in inverse kinematics. The
evaporation residues from tungsten to uranium were identified in-flight in mass
and atomic number. Their production cross-sections and their momentum
distributions were determined. The data are compared with empirical
systematics. A comparison with previous results from the spallation of 208Pb
and 197Au reveals the strong influence of fission in the spallation of 238U.