-
We measure the energy emitted by extensive air showers in the form of radio
emission in the frequency range from 30 to 80 MHz. Exploiting the accurate
energy scale of the Pierre Auger Observatory, we obtain a radiation energy of
15.8 \pm 0.7 (stat) \pm 6.7 (sys) MeV for cosmic rays with an energy of 1 EeV
arriving perpendicularly to a geomagnetic field of 0.24 G, scaling
quadratically with the cosmic-ray energy. A comparison with predictions from
state-of-the-art first-principle calculations shows agreement with our
measurement. The radiation energy provides direct access to the calorimetric
energy in the electromagnetic cascade of extensive air showers. Comparison with
our result thus allows the direct calibration of any cosmic-ray radio detector
against the well-established energy scale of the Pierre Auger Observatory.
-
The Auger Engineering Radio Array (AERA) is part of the Pierre Auger
Observatory and is used to detect the radio emission of cosmic-ray air showers.
These observations are compared to the data of the surface detector stations of
the Observatory, which provide well-calibrated information on the cosmic-ray
energies and arrival directions. The response of the radio stations in the 30
to 80 MHz regime has been thoroughly calibrated to enable the reconstruction of
the incoming electric field. For the latter, the energy deposit per area is
determined from the radio pulses at each observer position and is interpolated
using a two-dimensional function that takes into account signal asymmetries due
to interference between the geomagnetic and charge-excess emission components.
The spatial integral over the signal distribution gives a direct measurement of
the energy transferred from the primary cosmic ray into radio emission in the
AERA frequency range. We measure 15.8 MeV of radiation energy for a 1 EeV air
shower arriving perpendicularly to the geomagnetic field. This radiation energy
-- corrected for geometrical effects -- is used as a cosmic-ray energy
estimator. Performing an absolute energy calibration against the
surface-detector information, we observe that this radio-energy estimator
scales quadratically with the cosmic-ray energy as expected for coherent
emission. We find an energy resolution of the radio reconstruction of 22% for
the data set and 17% for a high-quality subset containing only events with at
least five radio stations with signal.
-
Neutrinos in the cosmic ray flux with energies near 1 EeV and above are
detectable with the Surface Detector array of the Pierre Auger Observatory. We
report here on searches through Auger data from 1 January 2004 until 20 June
2013. No neutrino candidates were found, yielding a limit to the diffuse flux
of ultra-high energy neutrinos that challenges the Waxman-Bahcall bound
predictions. Neutrino identification is attempted using the broad
time-structure of the signals expected in the SD stations, and is efficiently
done for neutrinos of all flavors interacting in the atmosphere at large zenith
angles, as well as for "Earth-skimming" neutrino interactions in the case of
tau neutrinos. In this paper the searches for downward-going neutrinos in the
zenith angle bins $60^\circ-75^\circ$ and $75^\circ-90^\circ$ as well as for
upward-going neutrinos, are combined to give a single limit. The $90\%$ C.L.
single-flavor limit to the diffuse flux of ultra-high energy neutrinos with an
$E^{-2}$ spectrum in the energy range $1.0 \times 10^{17}$ eV - $2.5 \times
10^{19}$ eV is $E_\nu^2 dN_\nu/dE_\nu < 6.4 \times 10^{-9}~ {\rm GeV~ cm^{-2}~
s^{-1}~ sr^{-1}}$.
-
A measurement of the cosmic-ray spectrum for energies exceeding
$4{\times}10^{18}$ eV is presented, which is based on the analysis of showers
with zenith angles greater than $60^{\circ}$ detected with the Pierre Auger
Observatory between 1 January 2004 and 31 December 2013. The measured spectrum
confirms a flux suppression at the highest energies. Above $5.3{\times}10^{18}$
eV, the "ankle", the flux can be described by a power law $E^{-\gamma}$ with
index $\gamma=2.70 \pm 0.02 \,\text{(stat)} \pm 0.1\,\text{(sys)}$ followed by
a smooth suppression region. For the energy ($E_\text{s}$) at which the
spectral flux has fallen to one-half of its extrapolated value in the absence
of suppression, we find
$E_\text{s}=(5.12\pm0.25\,\text{(stat)}^{+1.0}_{-1.2}\,\text{(sys)}){\times}10^{19}$
eV.
-
Contributions of the Pierre Auger Collaboration to the 33rd International
Cosmic Ray Conference, Rio de Janeiro, Brazil, July 2013
-
The Cosmic Ray Observatory Project (CROP) at University of Nebraska/Lincoln
and the Washington Area Large-scale Time coincidence Array (WALTA) at
University of Washington/Seattle are among several outreach projects siting
cosmic-ray detectors at local high schools in cities around North America, to
study the origins and interactions of high-energy cosmic rays. In a
collaboration between QuarkNet, the outreach program based at Fermilab, CROP,
and WALTA, a low-cost data acquisition electronics card has been developed to
collect and synchronize the data from each detector site. The cost for each
card is under US$500 for parts, functionally replacing much more expensive
electronics crates and modules at each high school site. The card has 4 analog
discriminator inputs for photo-multiplier tube signals, a 4-channel
Time-to-Digital converter for local coincidence and time-over-threshold
measurements at 0.75 ns resolution, programmable trigger logic via a CPLD and
microcontroller, and a built-in low-cost GPS receiver/antenna module (via
external cable) to provide event trigger time stamps at better than 100 ns
accuracy. Temperature sensors and a barometer are also integrated to record
environmental data along with the counter data. The card connects to any PC or
laptop via a standard RS-232 serial port for data output and control. The
microcontroller and CPLD are field programmable and therefore make the card
functionality flexible and easy to upgrade.
-
A low-cost DAQ card has been developed for school-network cosmic ray detector
projects, providing digitized data from photomultiplier tubes via a standard
serial interface. To facilitate analysis of these data and to provide students
with a starting point for custom readout systems, a model interface has been
developed using the National Instruments LabVIEW(R) system. This user-friendly
interface allows one to initialize the trigger coincidence conditions for
data-taking runs and to monitor incoming or pre-recorded data sets with
updating singles- and coincidence-rate plots and other user-selectable
histograms.