• The problem of user scheduling with reduced overhead of channel estimation in the uplink of Massive multiple-input multiple-output (MIMO) systems has been considered. A geometry-based stochastic channel model (GSCM), called the COST 2100 channel model has been used for realistic analysis of channels. In this paper, we propose a new user selection algorithm based on knowledge of the geometry of the service area and location of clusters, without having full channel state information (CSI) at the base station (BS). The multi-user link correlation in the GSCMs arises from the common clusters in the area. The throughput depends on the position of clusters in the GSCMs and users in the system. Simulation results show that although the BS does not require the channel information of all users, by the proposed geometry-based user scheduling algorithm the sum-rate of the system is only slightly less than the well-known greedy weight clique scheme. Finally, the robustness of the proposed algorithm to the inaccuracy of cluster localization is verified by the simulation results.
  • Wireless capsule endoscopy (WCE) systems are used to capture images of the human digestive tract for medical applications. The antenna is one of the most important components in a WCE system. In this paper, we provide novel small antenna solutions for a WCE system operating at the 433 MHz ISM band. The in-body capsule transmitter uses an ultrawideband outer-wall conformal loop antenna, whereas the on-body receiver uses a printed monopole antenna with a partial ground plane. A colon-equivalent tissue phantom and CST Gustav voxel human body model were used for the numerical studies of the capsule antenna. The simulation results in the colon-tissue phantom were validated through in-vitro measurements using a liquid phantom. According to the phantom simulations, the capsule antenna has -10 dB impedance matching from 309 to 1104 MHz. The ultrawideband characteristic enables the capsule antenna to tolerate the detuning effects due to electronic modules in the capsule and due to the proximity of various different tissues in gastrointestinal tracts. The on-body antenna was numerically evaluated on the colon-tissue phantom and the CST Gustav voxel human body model, followed by in-vitro and ex-vivo measurements for validation. The on-body antenna exceeds -10 dB impedance matching from 390 MHz to 500 MHz both in simulations and measurements. Finally, this paper reports numerical and experimental studies of the path loss for the radio link between an in-body capsule transmitter and an on-body receiver using our antenna solutions. The path loss both in simulations and measurements is less than 50 dB for any capsule orientation and location.
  • In this paper, we parameterize an excess loss-based multipath component (MPC) cross-polarization ratio (XPR) model in indoor and outdoor environments for above-6 GHz frequency bands. The results are based on 28 measurement campaigns in several frequency bands ranging from 15 to 80 GHz. A conventional XPR model of an MPC assuming a constant mean value fits our measurements very poorly and moreover overestimates the depolarization effect. Our measurements revealed a clear trend that the MPC XPR is inversely proportional to an excess loss in reference to the free-space path loss. The model is physically sound as a higher excess loss is attributed to more lossy interactions or to a greater number of interactions with objects, leading to a greater chance of depolarization. The measurements furthermore showed that the MPC XPR is not strongly frequency or environment dependent. In our MPC XPR model, an MPC with zero-dB excess loss has a mean XPR of 28 dB. The mean XPR decreases half-a-dB as the excess loss increases by every dB and the standard deviation around the mean is 6 dB. The model is applicable to existing channel models to reproduce realistic MPC XPRs for the above 6-GHz radio links.
  • In this paper, we propose a new technique for the future fifth generation cellular network wireless backhauling. We show that hundreds of bits per second per Hertz (bits per second per Hz) of spectral efficiency can be attained at a high carrier frequency (such as 26 GHz) between large antenna arrays deployed along structures (such as lamp posts) that are close and roughly parallel to each other. Hundreds of data streams are spatially multiplexed through a short range and line of sight massive multiple input massive multiple output propagation channel thanks to a new low complexity spatial multiplexing scheme, called block discrete Fourier transform based spatial multiplexing with maximum ratio transmission. Its performance in real and existing environments is assessed using accurate ray-tracing tools and antenna models. In the best simulated scenario, 1.6 kbits per second per Hz of spectral efficiency is attained, corresponding to 80% of Singular Value Decomposition performance, with a transmitter and a receiver that are 200 and 10,000 times less complex, respectively.
  • This paper studies a gain of an antenna array embedded on a mobile device operating at a millimeter-wave radio frequency. Assuming that mobile phones at millimeter-wave range operate with a single baseband unit and analog beamforming like phased arrays, we define a total array gain denoting a path gain of the phased antenna array in excess to the omni-directional path gain. The total array gain circumvents the ambiguity of conventional array gain which cannot be uniquely defined as there are multiple choices of a reference single-element antenna in an array. Two types of 8-element patch antenna arrays implemented on a mobile phone chassis, i.e., uniform linear array (ULA) and distributed array (DA) both operating at 60 GHz, are studied. The gain evaluated in a small-cell scenario in an airport shows that DA achieves higher median and outage gain by up to 8 and 6 dB than ULA when different orientations of the mobile phone are considered along with body torso and finger shadowing. There are always postures of the mobile phone where ULA cannot see the line-of-sight due to directionality of the patch antenna and of body and finger shadowing, leading to outage gain of -15 dB in the worst case. The DA has much smaller variation of the gain across different orientations of the phone, even when the human torso shadowing and user's finger effects are considered.
  • This paper analyzes the frequency dependency of the radio propagation channel's root mean square (rms) delay spread (DS), based on the multi-frequency measurement campaigns in the mmMAGIC project. The campaigns cover indoor, outdoor, and outdoor-to-indoor (O2I) scenarios and a wide frequency range from 2 to 86 GHz. Several requirements have been identified that define the parameters which need to be aligned in order to make a reasonable comparison among the different channel sounders employed for this study. A new modelling approach enabling the evaluation of the statistical significance of the model parameters from different measurements and the establishment of a unified model is proposed. After careful analysis, the conclusion is that any frequency trend of the DS is small considering its confidence intervals. There is statistically significant difference from the 3GPP New Radio (NR) model TR 38.901, except for the O2I scenario.
  • In this paper, we compare the radio propagation channels characteristics between 28 and 140 GHz bands based on the wideband (several GHz) and directional channel sounding in a shopping mall environment. The measurements and data processing are conducted in such a way to meet requirements for a fair comparison of large- and small- scale channel parameters between the two bands. Our results reveal that there is high spatial-temporal correlation between 28 and 140 GHz channels, similar numbers of strong multipath components, and only small variations in the large-scale parameters between the two bands. Furthermore, when including the weak paths there are higher total numbers of clusters and paths in 28 GHz as compared to those in 140 GHz bands. With these similarities, it would be very interesting to investigate the potentials of using 140 GHz band in the future mobile radio communications.
  • Hybrid multiple-antenna transceivers, which combine large-dimensional analog pre/postprocessing with lower-dimensional digital processing, are the most promising approach for reducing the hardware cost and training overhead in massive MIMO systems. This paper provides a comprehensive survey of the various incarnations of such structures that have been proposed in the literature. We provide a taxonomy in terms of the required channel state information (CSI), namely whether the processing adapts to the instantaneous or the average (second-order) CSI; while the former provides somewhat better signal-to-noise and interference ratio (SNIR), the latter has much lower overhead for CSI acquisition. We furthermore distinguish hardware structures of different complexities. Finally, we point out the special design aspects for operation at millimeter-wave frequencies.
  • Future mobile communications systems are likely to be very different to those of today with new service innovations driven by increasing data traffic demand, increasing processing power of smart devices and new innovative applications. To meet these service demands the telecommunications industry is converging on a common set of 5G requirements which includes network speeds as high as 10 Gbps, cell edge rate greater than 100 Mbps, and latency of less than 1 msec. To reach these 5G requirements the industry is looking at new spectrum bands in the range up to 100 GHz where there is spectrum availability for wide bandwidth channels. For the development of new 5G systems to operate in bands up to 100 GHz there is a need for accurate radio propagation models which are not addressed by existing channel models developed for bands below 6 GHz. This paper presents a preliminary overview of the 5G channel models for bands up to 100 GHz in indoor offices and shopping malls, derived from extensive measurements across a multitude of bands. These studies have found some extensibility of the existing 3GPP models to the higher frequency bands up to 100 GHz. The measurements indicate that the smaller wavelengths introduce an increased sensitivity of the propagation models to the scale of the environment and show some frequency dependence of the path loss as well as increased occurrence of blockage. Further, the penetration loss is highly dependent on the material and tends to increase with frequency. The small-scale characteristics of the channel such as delay spread and angular spread and the multipath richness is somewhat similar over the frequency range, which is encouraging for extending the existing 3GPP models to the wider frequency range. Further work will be carried out to complete these models, but this paper presents the first steps for an initial basis for the model development.
  • For the development of new 5G systems to operate in bands up to 100 GHz, there is a need for accurate radio propagation models at these bands that currently are not addressed by existing channel models developed for bands below 6 GHz. This document presents a preliminary overview of 5G channel models for bands up to 100 GHz. These have been derived based on extensive measurement and ray tracing results across a multitude of frequencies from 6 GHz to 100 GHz, and this document describes an initial 3D channel model which includes: 1) typical deployment scenarios for urban microcells (UMi) and urban macrocells (UMa), and 2) a baseline model for incorporating path loss, shadow fading, line of sight probability, penetration and blockage models for the typical scenarios. Various processing methodologies such as clustering and antenna decoupling algorithms are also presented.
  • In an in-band full-duplex system, radios transmit and receive simultaneously in the same frequency band at the same time, providing a radical improvement in spectral efficiency over a half-duplex system. However, in order to design such a system, it is necessary to mitigate the self-interference due to simultaneous transmission and reception, which seriously limits the maximum transmit power of the full-duplex device. Especially, large differences in power levels in the receiver front-end sets stringent requirements for the linearity of the transceiver electronics. We present an advanced architecture for a compact full-duplex multiantenna transceiver combining antenna design with analog and digital cancellation, including both linear and nonlinear signal processing.