ProtoDUNE-SP is the single-phase DUNE Far Detector prototype that is under
construction and will be operated at the CERN Neutrino Platform (NP) starting
in 2018. ProtoDUNE-SP, a crucial part of the DUNE effort towards the
construction of the first DUNE 10-kt fiducial mass far detector module (17 kt
total LAr mass), is a significant experiment in its own right. With a total
liquid argon (LAr) mass of 0.77 kt, it represents the largest monolithic
single-phase LArTPC detector to be built to date. It's technical design is
given in this report.
This document presents the Conceptual Design Report (CDR) put forward by an
international neutrino community to pursue the Deep Underground Neutrino
Experiment at the Long-Baseline Neutrino Facility (LBNF/DUNE), a groundbreaking
science experiment for long-baseline neutrino oscillation studies and for
neutrino astrophysics and nucleon decay searches. The DUNE far detector will be
a very large modular liquid argon time-projection chamber (LArTPC) located deep
underground, coupled to the LBNF multi-megawatt wide-band neutrino beam. DUNE
will also have a high-resolution and high-precision near detector.
The second workshop to discuss the development of liquid argon time
projection chambers (LArTPCs) in the United States was held at Fermilab on July
8-9, 2014. The workshop was organized under the auspices of the Coordinating
Panel for Advanced Detectors, a body that was initiated by the American
Physical Society Division of Particles and Fields. All presentations at the
workshop were made in six topical plenary sessions: $i)$ Argon Purity and
Cryogenics, $ii)$ TPC and High Voltage, $iii)$ Electronics, Data Acquisition
and Triggering, $iv)$ Scintillation Light Detection, $v)$ Calibration and Test
Beams, and $vi)$ Software. This document summarizes the current efforts in each
of these areas. It primarily focuses on the work in the US, but also highlights
work done elsewhere in the world.
The Liquid Argon Purity Demonstrator was an R&D test stand designed to
determine if electron drift lifetimes adequate for large neutrino detectors
could be achieved without first evacuating the cryostat. We describe here the
cryogenic system, its operations, and the apparatus used to determine the
contaminant levels in the argon and to measure the electron drift lifetime. The
liquid purity obtained by this system was facilitated by a gaseous argon purge.
Additionally, gaseous impurities from the ullage were prevented from entering
the liquid at the gas-liquid interface by condensing the gas and filtering the
resulting liquid before returning to the cryostat. The measured electron drift
lifetime in this test was greater than 6 ms, sustained over several periods of
many weeks. Measurements of the temperature profile in the argon, to assess
convective flow and boiling, were also made and are compared to simulation.