Laser Plasma Acceleration (LPA) [1] is an emerging concept enabling to generate electron beams with high energy, high peak current and small transverse emittance within a very short distance. The use of LPA can be applied to the Free Electron Laser (FEL) [2] case in order to investigate whether it is suitable for the light amplification in the undulator. However, capturing and guiding of such beams to the undulator is very challenging, because of the large divergence and high energy spread of the electron beams at the plasma exit, leading to large chromatic emittances. A specific beam manipulation scheme was recently proposed for the COXINEL (Coherent X-ray source inferred from electrons accelerated by laser) setup, which makes an advantage from the intrinsically large chromatic emittance of such beams [3]. The electron beam transport is studied using two simulation codes: a SOLEIL in-house one and ASTRA [4]. The influence of the collective effects on the electron beam performance is also examined.

Emission of light by a single electron moving on a curved trajectory (synchrotron radiation) is one of the most well-known fundamental radiation phenomena. However experimental situations are more complex as they involve many electrons, each being exposed to the radiation of its neighbors. This interaction has dramatic consequences, one of the most spectacular being the spontaneous formation of spatial structures inside electrons bunches. This fundamental effect is actively studied as it represents one of the most fundamental limitations in electron accelerators, and at the same time a source of intense terahertz radiation (Coherent Synchrotron Radiation, or CSR). Here we demonstrate the possibility to directly observe the electron bunch microstructures with subpicosecond resolution, in a storage ring accelerator. The principle is to monitor the terahertz pulses emitted by the structures, using a strategy from photonics, time-stretch, consisting in slowing-down the phenomena before recording. This opens the way to unpreceeded possibilities for analyzing and mastering new generation high power coherent synchrotron sources.

We discuss the conditions required for an optimal SASE FEL operation when bunch compression techniques are exploited to enhance the bunch peak current. We discuss the case of velocity bunching and magnetic bunch compression. With the reference to the latter technique we provide a quantitative estimate of the amount of laser heater power necessary to suppress the micro-bunching instability without creating any problem to the SASE dynamics

This report is a primer introduction on the sources of coherent syncrotron radiation from FELs compared to conventional lasers. Even though the underlying mechanisms are different, FELs can be considered a laser source to all effects. In fact FEL is based on the stimulated emission of virtual photons by a relativistic electron beam, passing through an undulator/wiggler, much like conventional lasers exploit the stimulated emission by an atomic/molecular system on which a population inversion has been realized. FEL operation is illustrated by means of the usual set of parameters (gain, saturation intensity...) used to describe the functioning of conventional lasers.