• Cell-free massive multiple-input multiple-output (MIMO) is a potential key technology for fifth generation wireless communication networks. A mixed quality-of-service (QoS) problem is investigated in the uplink of a cell-free massive MIMO system where the minimum rate of non-real time users is maximized with per user power constraints whilst the rate of the real-time users (RTUs) meet their target rates. First an approximated uplink user rate is derived based on available channel statistics. Next, the original mixed QoS problem is formulated in terms of receiver filter coefficients and user power allocations which can iteratively be solved through two sub-problems, namely, receiver filter coefficient design and power allocation, which are dealt with using a generalized eigenvalue problem and geometric programming, respectively. Numerical results show that with the proposed scheme, while the rates of RTUs meet the QoS constraints, the $90\%$-likely throughput improves significantly, compared to a simple benchmark scheme.
  • The problem of user scheduling with reduced overhead of channel estimation in the uplink of Massive multiple-input multiple-output (MIMO) systems has been considered. A geometry-based stochastic channel model (GSCM), called the COST 2100 channel model has been used for realistic analysis of channels. In this paper, we propose a new user selection algorithm based on knowledge of the geometry of the service area and location of clusters, without having full channel state information (CSI) at the base station (BS). The multi-user link correlation in the GSCMs arises from the common clusters in the area. The throughput depends on the position of clusters in the GSCMs and users in the system. Simulation results show that although the BS does not require the channel information of all users, by the proposed geometry-based user scheduling algorithm the sum-rate of the system is only slightly less than the well-known greedy weight clique scheme. Finally, the robustness of the proposed algorithm to the inaccuracy of cluster localization is verified by the simulation results.
  • This paper considers a Massive multiple-input multiple-output (MIMO) network, where the base station (BS) with a large number of antennas communicates with a smaller number of users. The signals are transmitted using frequency division duplex (FDD) mode. The problem of user scheduling with reduced overhead of channel estimation in the uplink of Massive MIMO systems has been investigated. We consider the COST 2100 channel model. In this paper, we first propose a new user selection algorithm based on knowledge of the geometry of the service area and of location of clusters, without having full channel state information (CSI) at the BS. We then show that the correlation in geometry-based stochastic channel models (GSCMs) arises from the common clusters in the area. In addition, exploiting the closed-form Cramer-Rao lower bounds (CRLB)s, the analysis for the robustness of the proposed scheme to cluster position errors is presented. It is shown by analysing the capacity upper-bound that the capacity strongly depends on the position of clusters in the GSCMs and users in the system. Simulation results show that although the BS receiver does not require the channel information of all users, by the proposed geometry-based user scheduling (GUS) algorithm the sum-rate of the system is only slightly less than the well-known greedy weight clique (GWC) scheme \cite{SUSGoldsmithGlobcom,ITC09_Userselection_GWC}. {Finally, the robustness of the proposed algorithm to cluster localization is verified by the simulation results.
  • The recently proposed Cell-Free massive MIMO architecture is studied for the uplink. In contrast to previous works, joint detection is performed using global CSI. Therefore, we study strategies for transferring CSI to the CPU taking into account the fronthaul capacity which limits CSI quantization. Two strategies for pilot-based CSI acquisition are considered: estimate-and-quantize and quantize-and-estimate. These are analysed using the Bussgang decomposition. For a given quantization constraint for the data and CSI the achievable rate per user with Zero-Forcing is determined. Numerical results show that quantize-and-estimate (the simpler strategy) is similar to or better than estimate-and-quantize, especially for 1-bit resolution.
  • In this paper, we consider the max-min signal-to-interference plus noise ratio (SINR) problem for the uplink transmission of a cell-free Massive multiple-input multiple-output (MIMO) system. Assuming that the central processing unit (CPU) and the users exploit only the knowledge of the channel statistics, we first derive a closed-form expression for uplink rate. In particular, we enhance (or maximize) user fairness by solving the max-min optimization problem for user rate, by power allocation and choice of receiver coefficients, where the minimum uplink rate of the users is maximized with available transmit power at the particular user. Based on the derived closed-form expression for the uplink rate, we formulate the original user max-min problem to design the optimal receiver coefficients and user power allocations. However, this max-min SINR problem is not jointly convex in terms of design variables and therefore we decompose this original problem into two sub-problems, namely, receiver coefficient design and user power allocation. By iteratively solving these sub-problems, we develop an iterative algorithm to obtain the optimal receiver coefficient and user power allocations. In particular, the receiver coefficients design for a fixed user power allocation is formulated as generalized eigenvalue problem whereas a geometric programming (GP) approach is utilized to solve the power allocation problem for a given set of receiver coefficients. Numerical results confirm a three-fold increase in system rate over existing schemes in the literature.
  • We consider a cell-free Massive multiple-input multiple-output (MIMO) system and investigate the system performance for the case when the quantized version of the estimated channel and the quantized received signal are available at the central processing unit (CPU), and the case when only the quantized version of the combined signal with maximum ratio combining (MRC) detector is available at the CPU. Next, we study the max-min optimization problem, where the minimum user uplink rate is maximized with backhaul capacity constraints. To deal with the max-min non-convex problem, we propose to decompose the original problem into two sub-problems. Based on these sub-problems, we develop an iterative scheme which solves the original max-min user uplink rate. Moreover, we present a user assignment algorithm to further improve the performance of cell-free Massive MIMO with limited backhaul links.