The rare decay K0(L) --> pi0 pi0 nu nu-bar was studied with the E391a detector at the KEK 12-GeV proton synchrotron. Based on 9.4 x 10^9 K0L decays, an upper limit of 8.1 x 10^{-7} was obtained for the branching fraction at 90% confidence level. We also set a limit on the K0(L) --> pi0 pi0 X (X --> invisible particles) process; the limit on the branching fraction varied from 7.0 x 10^{-7} to 4.0 x 10^{-5} for the mass of X ranging from 50 MeV/c^2 to 200 MeV/c^2.

We performed a search for the decay $K_L^0 \rightarrow 3\gamma$ with the E391a detector at KEK. In the data accumulated in 2005, no event was observed in the signal region. Based on the assumption of $K_L^0 \rightarrow 3\gamma$ proceeding via parity-violation, we obtained the single event sensitivity to be $(3.23\pm0.14)\times10^{-8}$, and set an upper limit on the branching ratio to be $7.4\times10^{-8}$ at the 90% confidence level. This is a factor of 3.2 improvement compared to the previous results. The results of $K_L^0 \rightarrow 3\gamma$ proceeding via parity-conservation were also presented in this paper.

We consider the unitary matrix model in the limit where the size of the matrices become infinite and in the critical situation when a new spectral band is about to emerge. In previous works the number of expected eigenvalues in a neighborhood of the band was fixed and finite, a situation that was termed "birth of a cut" or "first colonization". We now consider the transitional regime where this microscopic population in the new band grows without bounds but at a slower rate than the size of the matrix. The local population in the new band organizes in a "mesoscopic" regime, in between the macroscopic behavior of the full system and the previously studied microscopic one. The mesoscopic colony may form a finite number of new bands, with a maximum number dictated by the degree of criticality of the original potential. We describe the delicate scaling limit that realizes/controls the mesoscopic colony. The method we use is the steepest descent analysis of the Riemann-Hilbert problem that is satisfied by the associated orthogonal polynomials.

We performed a search for a light pseudoscalar particle $X$ in the decay $K_L^0->pi0pi0X$, $X->\gamma\gamma$ with the E391a detector at KEK. Such a particle with a mass of 214.3 MeV/$c^2$ was suggested by the HyperCP experiment. We found no evidence for $X$ and set an upper limit on the product branching ratio for $K_L^0->pi0pi0X$, $X->\gamma\gamma$ of $2.4 \times 10^{-7}$ at the 90% confidence level. Upper limits on the branching ratios in the mass region of $X$ from 194.3 to 219.3 MeV/$c^2$ are also presented.

We describe the spectral statistics of the first finite number of eigenvalues in a newly-forming band on the hard-edge of the spectrum of a random Hermitean matrix model. It is found that in a suitable scaling regime, they are described by the same spectral statistics of a finite-size Laguerre-type matrix model. The method is rigorously based on the Riemann-Hilbert analysis of the corresponding orthogonal polynomials.

We describe the distribution of the first finite number of eigenvalues in a newly-forming band of the spectrum of the random Hermitean matrix model. The method is rigorously based on the Riemann-Hilbert analysis of the corresponding orthogonal polynomials. We provide an analysis with an error term of order N^(-2 h) where 1/h = 2 nu+2 is the exponent of non-regularity of the effective potential, thus improving even in the usual case the analysis of the pertinent literature. The behavior of the first finite number of zeroes (eigenvalues) appearing in the new band is analyzed and connected with the location of the zeroes of certain Freud polynomials. In general all these newborn zeroes approach the point of nonregularity at the rate N^(-h) whereas one (a stray zero) lags behind at a slower rate of approach. The kernels for the correlator functions in the scaling coordinate near the emerging band are provided together with the subleading term: in particular the transition between K and K+1 eigenvalues is analyzed in detail.

We report the high-pressure synthesis of the electron-doped infinite-layer superconductor Sr0.9La0.1CuO2 and its superconducting properties. A Rietveld analysis of X-ray powder diffraction data showed that, within the resolution of the measurement, the sample had purely an infinite-layer structure without any discernible impurities. The superconducting volume fraction and the transition width were greatly improved compared to those in previous reports. The irreversibility field line and the intragranular critical current density were much higher than those of La1.85Sr0.15CuO4 and Nd1.85Ce0.15CuO4. The stronger pinning behaviors are consistent with the strong interlayer coupling due to the short distance between CuO2 planes.

We report the magnetic-field dependence of the irreversible magnetization of the recently discovered binary superconductor MgB$_{2}$. For the temperature region of $T< 0.9T_c$, the contribution of the bulk pinning to the magnetization overwhelms that of the surface pinning. This was evident from the fact that the magnetization curves, $M(H)$, were well described by the critical-state model without considering the surface pinning effect. It was also found that the $M(H)$ curves at various temperatures scaled when the field and the magnetization were normalized by the characteristic scaling factors $H^\ast(T)$ and $M^\ast(T)$, respectively. This feature suggests that the pinning mechanism determining the hysteresis in $M(H)$ is unique below $T=T_c$.

We report the temperature- and magnetic-field-dependent resistivity of MgB2 sintered at high temperature and high pressure condition. The superconducting transition width for the resistivity measurement was about 0.4 K, and the low-field magnetization showed a sharp superconducting transition with a transition width of about 1 K. The resistivity in the normal state roughly followed T^2 behavior with smaller residual resistivity ratio (RRR) of 3 over broad temperature region above 100 K rather than reported T^3 behavior with larger RRR value of ~ 20 in the samples made at lower pressures. Also, the resistivity did not change appreciably with the applied magnetic field, which was different from previous report. These differences were discussed with the microscopic and structural change due to the high-pressure sintering.

We report the effect of the sintering temperature on the superconductivity of MgB2 pellets prepared under a high pressure of 3 GPa. The superconducting properties of the non-heated MgB2 in this high pressure were poor. However, as the sintering temperature increased, the superconducting properties were vastly enhanced, which was shown by the narrow transition width for the resistivity and the low-field magnetizations. This shows that heat treatment under high pressure is essential to improve superconducting properties. These changes were found to be closely related to changes in the surface morphology observed using scanning electron microscopy.

The longitudinal resistivity rho_{xx} and Hall coefficient R_H were measured for MgB2 sintered under high pressure. We found that R_H is positive like cuprate high-Tc superconductors, and decreases as the temperature increases for 40 K < T < 300 K. The cotangent of the Hall angle was found to follow a+bT^2 behavior from Tc to 300 K. At T = 100 K, R_H = 4.1 x 10^{-11} m^3/C from which hole carrier density was determined to be 1.5 x 10^{23}/cm^3. This carrier density is 2 - 3 orders of magnitude larger than that of Nb3Sn superconductor and that of optimally doped YBa_2Cu_3O_y.

We report the high-pressure synthesis of the electron-doped infinite-layer superconductor Sr_{0.9}La_{0.1}CuO_{2}. A Rietveld analysis using X-ray powder diffraction data showed that, within the resolution of the measurement, the sample was purely an infinite-layer structure without any discernible impurities. The superconducting volume fraction and the transition width were greatly improved compared to those in the previous reports. Also the irreversibility field line was much higher than that of (La,Sr)_{2}CuO_{4}. The higher value seems to originate from the strong interlayer coupling due to the reduced average distance between the CuO_{2} planes.