• We have demonstrated selective gas sensing with molybdenum disulfide (MoS2) thin films transistors capped with a thin layer of hexagonal boron nitride (h-BN). The resistance change was used as a sensing parameter to detect chemical vapors such as ethanol, acetonitrile, toluene, chloroform and methanol. It was found that h-BN dielectric passivation layer does not prevent gas detection via changes in the source-drain current in the active MoS2 thin film channel. The use of h-BN cap layers (thickness H=10 nm) in the design of MoS2 thin film gas sensors improves device stability and prevents device degradation due to environmental and chemical exposure. The obtained results are important for applications of van der Waals materials in chemical and biological sensing.
  • We report on the low-frequency current fluctuations and electronic noise in thin-films made of bismuth selenide topological insulators. The films were prepared via the graphene-like mechanical exfoliation and used as the current conducting channels in the four- and two-contact devices. Analysis of the resistance dependence on the film thickness indicates that the surface contribution to conductance is dominant in our samples. It was established that the current fluctuations have the noise spectrum close to the pure 1/f in the frequency range from 1 to 10 kHz (f is the frequency). The relative noise amplitude S/I^2 for the examined films was increasing from ~5x10^-8 to 5x10^-6 (1/Hz) as the resistance of the channels varied from ~10^3 to 10^5 Ohms. The obtained noise data is important for understanding electron transport through the surface and volume of topological insulators, and proposed applications of this class of materials.