• ### Synthesis and Physical Properties of FeSe1/2Te1/2 Superconductor(0912.0997)

One of the most important properties of very recently reported FeSe based superconductors is the robustness of their superconductivity under applied magnetic field. The synthesis and control of superconductivity in FeSe based compounds is rather a difficult task. Synthesis and physical property characterization for optimized superconductivity of FeSe1/2Te1/2 at 13 K is reported here. The compound crystallized in a tetragonal structure with lattice parameters a = 3.8008(10) and c = 6.0187 (15) A. Magnetization measurements indicated bulk superconductivity with lower critical field (Hc1) of around 180 Oe. By applying Ginzburg Landau (GL) theory, the Hc2(0) value is estimated to be = 1840 kOe for the 90% of resistive transition. A heat capacity measurement revealed bulk superconductivity by a hump at Tc near 13 K, and an expected decrease was observed under an applied magnetic field.
• ### Superconductivity in SmFe1-xCoxAsO (x = 0.0 to 0.30)(0912.0999)

We report synthesis, structural details and magnetization of SmFe1-xCoxAsO with x ranging from 0.0 to 0.30. It is found that Co substitutes fully at Fe site in SmFeAsO in an iso-structural lattice with slightly compressed cell. The parent compound exhibited known spin density wave (SDW) character below at around 140 K. Successive doping of Co at Fe site suppressed the SDW transition for x = 0.05 and later induced superconductivity for x = 0.10, 0.15 and 0.20 respectively at 14, 15.5 and 9K. The lower critical field as seen from magnetization measurements is below 200Oe. The appearance of bulk superconductivity is established by wide open isothermal magnetization M(H) loops. Superconductivity is not observed for higher content of Co i.e. x = 0.30. Clearly the Co substitution at Fe site in SmFe1-xCoxAsO diminishes the Fe SDW character, introduces bulk superconductivity for x between 0.10 and 0.20 and finally becomes non-superconducting for x above 0.20. The Fe2+ site Co3+ substitution injects mobile electrons to the system and superconductivity appears, however direct substitution introduces simultaneous disorder in superconducting FeAs layer and thus superconductivity disappears for higher content of Co.
• ### Continuous metal-insulator transition of the antiferromagnetic perovskite NaOsO3(0910.4722)

Newly synthesized perovskite NaOsO3 shows Curie-Weiss metallic nature at high temperature and suddenly goes into an antiferromagnetically insulating state at 410 K on cooling. Electronic specific heat at the low temperature limit is absent, indicating that the band gap fully opens. In situ observation in electron microscopy undetected any lattice anomalies in the vicinity of the transition temperature. It is most likely that the antiferromagnetic correlation plays an essential role of the gap opening.
• We report on a search for pair production of first-generation scalar leptoquarks ($LQ$) in $p \bar{p}$ collisions at $\sqrt{s}$=1.96 TeV using an integrated luminosity of 203 $pb^{-1}$ collected at the Fermilab Tevatron collider by the CDF experiment. We observe no evidence for $LQ$ production in the topologies arising from $LQ \bar{LQ} \to eqeq$ and $LQ \bar{LQ} \to eq \nu q$, and derive 95% C.L. upper limits on the $LQ$ production cross section. %as a function of $\beta$, where $\beta$ is the branching fraction for $LQ \to eq$. The results are combined with those obtained from a separately reported CDF search in the topology arising from $LQ\bar{LQ} \to \nu q \nu q$ and 95% C.L. lower limits on the LQ mass as a function of $\beta = BR(LQ \to eq)$ are derived. The limits are 236, 205 and 145 GeV/c$^2$ for $\beta$ = 1, $\beta$ = 0.5 and $\beta$ = 0.1, respectively.