• ### Effect of Cleaving Temperature on the Surface and Bulk Fermi Surface of Sr2RuO4 Investigated by High Resolution Angle-Resolved Photoemission(1205.4963)

May 22, 2012 cond-mat.supr-con
High resolution angle-resolved photoemission measurements are carried out to systematically investigate the effect of cleaving temperature on the electronic structure and Fermi surface of Sr$_2$RuO$_4$. Different from previous reports that high cleaving temperature can suppress surface Fermi surface, we find that the surface Fermi surface remains obvious and strong in Sr$_2$RuO$_4$ cleaved at high temperature, even at room temperature. This indicates that cleaving temperature is not a key effective factor in suppressing the surface bands. On the other hand, in the aged surface of Sr$_2$RuO$_4$ that is cleaved and held for a long time, the bulk bands can be enhanced. We have also carried out laser ARPES measurements on Sr$_2$RuO$_4$ by using vacuum ultra-violet laser (photon energy at 6.994 eV) and found an obvious enhancement of bulk bands even for samples cleaved at low temperature. These information are important in realizing an effective approach in manipulating and detecting the surface and bulk electronic structure of Sr$_2$RuO$_4$. In particular, the enhancement of bulk sensitivity, together with its super-high instrumental resolution of VUV laser ARPES, will be advantageous in investigating fine electronic structure and superconducting properties of Sr$_2$RuO$_4$ in the future.
• ### Unusual Fermi Surface Sheet-Dependent Band Splitting in Sr2RuO4 Revealed by High Resolution Angle-Resolved Photoemission(1205.4970)

High resolution angle-resolved photoemission measurements have been carried out on Sr2RuO4. We observe clearly two sets of Fermi surface sheets near the (\pi,0)-(0,\pi) line which are most likely attributed to the surface and bulk Fermi surface splitting of the \beta band. This is in strong contrast to the nearly null surface and bulk Fermi surface splitting of the \alpha band although both have identical orbital components. Extensive band structure calculations are performed by considering various scenarios, including structural distortion, spin-orbit coupling and surface ferromagnetism. However, none of them can explain such a qualitative difference of the surface and bulk Fermi surface splitting between the \alpha and \beta sheets. This unusual behavior points to an unknown order on the surface of Sr2RuO4 that remains to be uncovered. Its revelation will be important for studying and utilizing novel quantum phenomena associated with the surface of Sr2RuO4 as a result of its being a possible p-wave chiral superconductor and a topological superconductor.
• ### Persistence of Topological Order and Formation of Quantum Well States in Topological Insulators Bi2(Se,Te)3 under Ambient Conditions(1107.5784)

July 28, 2011 cond-mat.mtrl-sci
The topological insulators represent a unique state of matter where the bulk is insulating with an energy gap while the surface is metallic with a Dirac cone protected by the time reversal symmetry. These characteristics provide a venue to explore novel quantum phenomena in fundamental physics and show potential applications in spintronics and quantum computing. One critical issue directly related with the applications as well as the fundamental studies is how the topological surface state will behave under ambient conditions (1 atmosphere air and room temperature). In this paper, we report high resolution angle-resolved photoemission measurements on the surface state of the prototypical topological insulators, Bi2Se3, Bi2Te3 and Bi2(Se0.4Te2.6), upon exposing to ambient conditions. We find that the topological order persists even when the surface is exposed to air at room temperature. However, the surface state is strongly modified after such an exposure. Particularly, we have observed the formation of two-dimensional quantum well states near the surface of the topological insulators after the exposure which depends sensitively on the original composition, x, in Bi2(Se3-xTex). These rich information are crucial in utilizing the surface state and in probing its physical properties under ambient conditions.
• ### Extraction of Electron Self-Energy and Gap Function in the Superconducting State of Bi_2Sr_2CaCu_2O_8 Superconductor via Laser-Based Angle-Resolved Photoemission(1103.3629)

Super-high resolution laser-based angle-resolved photoemission measurements have been performed on a high temperature superconductor Bi_2Sr_2CaCu_2O_8. The band back-bending characteristic of the Bogoliubov-like quasiparticle dispersion is clearly revealed at low temperature in the superconducting state. This makes it possible for the first time to experimentally extract the complex electron self-energy and the complex gap function in the superconducting state. The resultant electron self-energy and gap function exhibit features at ~54 meV and ~40 meV, in addition to the superconducting gap-induced structure at lower binding energy and a broad featureless structure at higher binding energy. These information will provide key insight and constraints on the origin of electron pairing in high temperature superconductors.
• ### Common Fermi Surface Topology and Nodeless Superconducting Gap in K0.68Fe1.79Se2 and (Tl0.45K0.34)Fe1.84Se2 Superconductors Revealed from Angle-Resolved Photoemission Spectroscopy(1102.1057)

We carried out high resolution angle-resolved photoemission measurements on the electronic structure and superconducting gap of K_0.68Fe_1.79Se_2 (T_c=32 K) and (Tl_0.45K_0.34)Fe_1.84Se_2 (T_c=28 K) superconductors. In addition to the electron-like Fermi surface near M(\pi,\pi), two electron-like Fermi pockets are revealed around the zone center \Gamma(0,0) in K0.68Fe1.79Se_2. This observation makes the Fermi surface topology of K_0.68Fe_1.79Se_2 consistent with that of (Tl,Rb)_xFe_{2-y}Se_2 and (Tl,K)_xFe_{2-y}Se_2 compounds. A nearly isotropic superconducting gap (\Delta) is observed along the electron-like Fermi pocket near the M point in K_0.68Fe_1.79Se_2 (\Delta\sim 9 meV) and (Tl_0.45K_0.34)Fe_1.84Se_2 (\Delta\sim 8 meV). The establishment of a universal picture on the Fermi surface topology and superconducting gap in the A_xFe_2-ySe_2 (A=K, Tl, Cs, Rb and etc.) superconductors will provide important information in understanding the superconductivity mechanism of the iron-based superconductors.
• ### Distinct Fermi Surface Topology and Nodeless Superconducting Gap in (Tl0.58Rb0.42)Fe1.72Se2 Superconductor(1101.4556)

High resolution angle-resolved photoemission measurements have been carried out to study the electronic structure and superconducting gap of the (Tl$_{0.58}$Rb$_{0.42}$)Fe$_{1.72}$Se$_2$ superconductor with a T$_c$=32 K. The Fermi surface topology consists of two electron-like Fermi surface sheets around $\Gamma$ point which is distinct from that in all other iron-based compounds reported so far. The Fermi surface around the M point shows a nearly isotropic superconducting gap of $\sim$12 meV. The large Fermi surface near the $\Gamma$ point also shows a nearly isotropic superconducting gap of $\sim$15 meV while no superconducting gap opening is clearly observed for the inner tiny Fermi surface. Our observed new Fermi surface topology and its associated superconducting gap will provide key insights and constraints in understanding superconductivity mechanism in the iron-based superconductors.
• ### Unusual Electronic Structure and Observation of Dispersion Kink in CeFeAsO Parent Compound of FeAs-Based Superconductors(0912.2838)

We report the first comprehensive high-resolution angle-resolved photoemission measurements on CeFeAsO, a parent compound of FeAs-based high temperature superconductors with a mangetic/structural transition at $\sim$150 K. In the magnetic ordering state, four hole-like Fermi surface sheets are observed near $\Gamma$(0,0) and the Fermi surface near M(+/-$\pi$,+/-$\pi$) shows a tiny electron-like pocket at M surrounded by four Dirac cone-like strong spots. The unusual Fermi surface topology deviates strongly from the band structure calculations. The electronic signature of the magnetic/structural transition shows up in the dramatic change of the quasiparticle scattering rate. A dispersion kink at $\sim$ 25meV is for the first time observed in the parent compound of Fe-based superconductors.
• ### Coexistence of Fermi arcs and Fermi pockets in a high Tc copper oxide superconductor(0906.2682)

In the pseudogap state of the high-Tc copper-oxide (cuprate) superconductors, angle-resolved photoemission (ARPES) measurements have seen an Fermi arc, i.e., an open-ended gapless section in the large Fermi surface, rather than a closed loop expected of an ordinary metal. This is all the more puzzling because Fermi pockets (small closed Fermi surface features) have been suggested from recent quantum oscillation measurements. The Fermi arcs have worried the high-Tc community for many years because they cannot be understood in terms of existing theories. Theorists came up with a way out in the form of conventional Fermi surface pockets associated with competing order, with a back side that is for detailed reasons invisible by photoemission. Here we report ARPES measurements of La-Bi2201 that give direct evidence of the Fermi pocket. The charge carriers in the pocket are holes and the pockets show an unusual dependence upon doping, namely, they exist in underdoped but not overdoped samples. A big surprise is that these Fermi pockets appear to coexist with the Fermi arcs. This coexistence has not been expected theoretically and the understanding of the mysterious pseudogap state in the high-Tc cuprate superconductors will rely critically on understanding such a new finding.