• Hybrid beamforming for frequency-selective channels is a challenging problem as the phase shifters provide the same phase shift to all of the subcarriers. The existing approaches solely rely on the channel's frequency response and the hybrid beamformers maximize the average spectral efficiency over the whole frequency band. Compared to state-of-the-art, we show that substantial sum-rate gains can be achieved, both for rich and sparse scattering channels, by jointly exploiting the frequency and time domain characteristics of the massive multiple-input multiple-output (MIMO) channels. In our proposed approach, the radio frequency (RF) beamformer coherently combines the received symbols in the time domain and, thus, it concentrates signal's power on a specific time sample. As a result, the RF beamformer flattens the frequency response of the "effective" transmission channel and reduces its root mean square delay spread. Then, a baseband combiner mitigates the residual interference in the frequency domain. We present the closed-form expressions of the proposed beamformer and its performance by leveraging the favorable propagation condition of massive MIMO channels and we prove that our proposed scheme can achieve the performance of fully-digital zero-forcing when number of employed phase shifter networks is twice the resolvable multipath components in the time domain.
  • In this correspondence, two novel hybrid beamforming methods are proposed to reduce the cost and power consumption of hybrid beamformers with subconnected phase shifter network structure in massive multiple-input multiple-output (MIMO) systems. This is achieved by replacing some of the phase shifters with switches which, in general, are cheaper and have lower power consumption compared to phase shifters. The proposed methods and the closed-form expressions of their performance are derived according to the properties of the elements of the singular vectors of the channel matrix. In the first approach, it is shown that by combining the subconnected phase shifter network with a fully-connected switch architecture, the number of the phase shifters can be reduced up to 50% while the spectral efficiency is preserved. Then, in order to simplify the structure of the switch network, the fully-connected structure is replaced by subconnected switch network, e.g. binary switches. The analytical and simulation results indicate that the number of the phase shifters can be reduced to 25% while 90% of the spectral efficiency is achieved.
  • This paper proposes an asymptotically optimal hybrid beamforming solution for large antenna arrays by exploiting the properties of the singular vectors of the channel matrix. It is shown that the elements of the channel matrix with Rayleigh fading follow a normal distribution when large antenna arrays are employed. The proposed beamforming algorithm is effective in both sparse and rich propagation environments, and is applicable for both point-to-point and multiuser scenarios. In addition, a closed-form expression and a lower-bound for the achievable rates are derived when analog and digital phase shifters are employed. It is shown that the performance of the hybrid beamformers using phase shifters with more than 2-bits resolution is comparable with analog phase shifting. A novel phase shifter selection scheme that reduces the power consumption at the phase shifter network is proposed when the wireless channel is modeled by Rayleigh fading. Using this selection scheme, the spectral efficiency can be increased as the power consumption in the phase shifter network reduces. Compared to the scenario that all of the phase shifters are in operation, the simulation results indicate that the spectral efficiency increases when up to 50% of phase shifters are turned off.