• Many use cases of unmanned aerial vehicles (UAVs) require beyond visual line-of-sight (LOS) communications. Mobile networks offer wide area, high speed, and secure wireless connectivity, which can enhance control and safety of UAV operations and enable beyond visual LOS use cases. In this article, we share some of our experience in Long-Term Evolution (LTE) connectivity for low altitude small UAVs. We first identify the typical airborne connectivity requirements and characteristics, highlight the different propagation conditions for UAVs and mobiles on the ground with measurement and ray tracing results, and present simulation results to shed light on the feasibility of providing LTE connectivity for UAVs. We also present several ideas on potential enhancements for improving LTE connectivity performance and identify fruitful avenues for future research.
  • A main challenge in providing connectivity to the low altitude unmanned aerial vehicles (UAVs) through existing cellular network arises due to the increased interference in the network. The increased altitude and favourable propagation condition cause UAVs to generate more interference to the neighbouring cells, and at the same time experience more interference from the downlink transmissions of the neighbouring base stations. The uplink interference problem may result in terrestrial UEs having degraded performance, whereas the downlink interference problem may make it challenging for a UAV to maintain connection with the network. In this paper, we propose several uplink and downlink interference mitigation techniques to address these issues. The results indicate that the proposed solutions can reduce the uplink throughput degradation of terrestrial UEs and ensure UAVs to remain in LTE coverage under the worst case scenarios when all the base stations transmit at full power.
  • Drones are becoming increasingly used in a wide variety of industries and services and are delivering profound socioeconomic benefits. Technology needs to be in place to ensure safe operation and management of the growing fleet of drones. Mobile networks have connected tens of billions of devices on the ground in the past decades and are now ready to connect the flying drones in the sky. In this article, we share some of our findings in cellular connectivity for low altitude drones. We first present and analyze field measurement data collected during drone flights in a commercial Long-Term Evolution (LTE) network. We then present simulation results to shed light on the performance of a network when the network is serving many drones simultaneously over a wide area. The results, analysis, and design insights presented in this article help enhance the understanding of the applicability and performance of mobile network connectivity to low altitude drones.
  • The multiple access scheduling decides how the channel is shared among the nodes in the network. Typical scheduling algorithms aims at increasing the channel utilization and thereby throughput of the network. This paper describes several algorithms for generating an optimal schedule in terms of channel utilization for multiple access by utilizing range information in a fully connected network. We also provide detailed analysis for the proposed algorithms performance in terms of their complexity, convergence, and effect of non-idealities in the network. The performance of the proposed schemes are compared with non-aided methods to quantify the benefits of using the range information in the communication. The proposed methods have several favorable properties for the scalable systems. We show that the proposed techniques yields better channel utilization and throughput as the number of nodes in the network increases. We provide simulation results in support of this claim. The proposed methods indicate that the throughput can be increased on average by 3-10 times for typical network configurations.
  • This paper proposes two compressive sampling based time of arrival (TOA) estimation algorithms using a sub-Nyquist rate receiver. We also describe a novel compressive sampling dictionary design for the compact representation of the received UWB signal. One of the proposed algorithm exploits the a-priori information with regard to the channel and range of the target. The performance of the algorithms are compared against the maximum likelihood (ML) based receiver using IEEE 802.15.4a CM1 line of sight (LOS) UWB channel model. The proposed algorithm yields performance similar to the ML TOA estimation at high SNRs. However, the computational complexity and the sampling rate requirements are lesser compared to the ML estimator. Simulation results show that the proposed algorithms can match ML estimator performance with only 1/4-th the sampling rate at 25 dB SNR. We analyze the performance of the algorithm with respect to practical constraints like size of the holographic dictionary and sampling rates. We also propose a new algorithm which can exploit the a-priori information regarding the UWB channel and the geographical constraints on the target that may be available at the receiver. This algorithm can substantially boost the performance compared to the algorithm without a-priori information at low SNRs.
  • Optimal detection of ultra wideband (UWB) pulses in a UWB transceiver employing multiple detector types is proposed and analyzed in this paper. We propose several fusion techniques for fusing decisions made by individual IR-UWB detectors. We assess the performance of these fusion techniques for commonly used detector types like matched filter, energy detector and amplitude detector. In order to perform this, we derive the detection performance equation for each of the detectors in terms of false alarm rate, shape of the pulse and number of UWB pulses used in the detection and apply these in the fusion algorithms. We show that the performance can be improved approximately by 4 dB in terms of signal to noise ratio (SNR) for perfect detectability of a UWB signal in a practical scenario by fusing the decisions from individual detectors.
  • In this paper, we propose fusion of dynamic TOA (time of arrival) from multiple non-coherent detectors like energy detectors operating at sub-Nyquist rate through Kalman filtering. We also show that by using multiple of these energy detectors, we can achieve the performance of a digital matched filter implementation in the AWGN (additive white Gaussian noise) setting. We derive analytical expression for number of energy detectors needed to achieve the matched filter performance. We demonstrate in simulation the validity of our analytical approach. Results indicate that number of energy detectors needed will be high at low SNRs and converge to a constant number as the SNR increases. We also study the performance of the strategy proposed using IEEE 802.15.4a CM1 channel model and show in simulation that two sub-Nyquist detectors are sufficient to match the performance of digital matched filter.