-
The gyrotron is the high power millimeter wave source in the electron
cyclotron resonance heating system for the tokamak. The cathode power supply is
one of the most important ancillary devices for gyrotron. Some interesting
transient phenomena about the cathode voltage and the cathode current was found
in the gyrotron operation in the electron cyclotron resonance heating system
for the Experimental Advanced Superconducting Tokamak. The cathode voltage
drops to about 10% of the original value by about 90 {\mu}s in the overcurrent
case, which is much longer than the 25 {\mu}s in the normal case. In order to
explain these phenomena, an equivalent circuit model of the magnetron injection
gun was proposed. The equivalent circuit is composed of parallel resistors and
capacitors, and it can explain the test results very well. Using the equivalent
circuit model to analyze gyrotrons may become an effective means of developing
and operating an electron cyclotron heating system.
-
A coupling tunable D-band directional coupler is designed based on a novel
coupling grid structure proposed in this letter. The designed directional
coupler has excellent performance with ultra-wideband. The coupling can be
tuned from -28.2 dB to -33.2 dB at 140 GHz by changing the angle of the
coupling grid, and the dynamic range of the coupling is about 5 dB. The return
loss is smaller than -15 dB in the whole D-band from 110 GHz to 170 GHz. A 3-dB
coupler use the similar coupling structure is also designed. The coupling is
3.3144 dB at the center frequency of 140 GHz.
-
In this paper, an overcurrent protection system is designed to ensure the
safety of the gyrotrons in the EAST ECRH system. Two overcurrent protection
systems were established, a fast one and a slow one. The fast one uses the
current transformers as the current sensors. The models of the current
transformers and the superconducting magnet were built to analyze the effect of
the environmental magnetic field on the current transformers using FI method.
The analysis results show that the magnetic induction at the position near the
current transformers must less than 0.002 T, i.e., the current transformers
should be placed at a distance greater than 2.2 meters from the magnet center
to ensure its normal work. The slow one uses the shunt to monitor the currents.
An anti-fuse FPGA and a timer is used to realize the signal processing in the
fast protection circuit and the slow protection circuit respectively. The
response time of the fast protection circuit is less than 100 ns, and the
response time of the slow protection circuit is less than 31 {\mu}s.
-
In this paper, the calorimetric power measurement method for electron
cyclotron resonance heating system on EAST are presented. This method requires
measurement of the water flow through the cooling circuits and the input and
output water temperatures in each cooling circuit. Usually, the inlet water
temperature is controlled to be stable to get more accurate results. The
influence of the inlet water temperature change on the measurement results is
analyzed for the first time in this paper. A novel temperature calibration
method is proposed also. This kind of calibration method is accurate and
effective, and can be easily implemented.