-
Excitation-energy spectra of $^{11}$C nuclei near the $\eta^\prime$-meson
production threshold have been measured by missing-mass spectroscopy using the
$^{12}$C($p$,$d$) reaction. A carbon target has been irradiated with a 2.5 GeV
proton beam supplied by the synchrotron SIS-18 at GSI to produce $\eta^\prime$
meson bound states in $^{11}$C nuclei. Deuterons emitted at $0^\circ$ in the
reaction have been momentum-analyzed by the fragment separator (FRS) used as a
high-resolution spectrometer. No distinct structure due to the formation of
$\eta^\prime$-mesic states is observed although a high statistical sensitivity
is achieved in the experimental spectra. Upper limits on the formation cross
sections of $\eta^\prime$-mesic states are determined, and thereby a constraint
imposed on the $\eta^\prime$-nucleus interaction is discussed.
-
Quantum annealing machines based on superconducting qubits, which have the
potential to solve optimization problems faster than digital computers, are of
great interest not only to researchers but also to the general public. Here, we
propose a quantum annealing machine based on a semiconductor floating gate (FG)
array. We use the same device structure as that of the commercial FG NAND flash
memory except for small differences such as thinner tunneling barrier. We
theoretically derive an Ising Hamiltonian from the FG system in its
single-electron region. Recent high-density NAND flash memories are subject to
several problems that originate from their small FG cells. In order to store
information reliably, the number of electrons in each FG cell should be
sufficiently large. However, the number of electrons stored in each FG cell
becomes smaller and can be countable. So we utilize the countable electron
region to operate single-electron effects of FG cells. Second, in the
conventional NAND flash memory, the high density of FG cells induces the
problem of cell-to-cell interference through their mutual capacitive couplings.
This interference problem is usually solved by various methods using a software
of error-correcting codes. We derive the Ising interaction from this natural
capacitive coupling. Considering the size of the cell, 10 nm, the operation
temperature is expected to be approximately that of a liquid nitrogen. If a
commercial 64 Gbit NAND flash memory is used, ideally we expect it to be
possible to construct 2 megabytes (MB) entangled qubits by using the
conventional fabrication processes in the same factory as is used for
manufacture of NAND flash memory. A qubit system of highest density will be
obtained as a natural extension of the miniaturization of commonly used
memories in this society.
-
Excitation spectra of $^{11}$C were measured in the $^{12}$C$(p,d)$ reaction
near the $\eta'$ emission threshold. A proton beam extracted from the
synchrotron SIS-18 at GSI with an incident energy of 2.5 GeV impinged on a
carbon target. The momenta of deuterons emitted at 0 degrees were precisely
measured with the fragment separator FRS operated as a spectrometer. In
contrast to theoretical predictions on the possible existence of deeply bound
$\eta'$ mesic states in carbon nuclei, no distinct structures were observed
associated with the formation of bound states. The spectra were analyzed to set
stringent constraints on the formation cross section and on the hitherto
barely-known $\eta'$-nucleus interaction.
-
We report the successful commissioning and testing of a dedicated
field-ioniser chamber for measuring principal quantum number distributions in
antihydrogen as part of the ASACUSA hyperfine spectroscopy apparatus. The new
chamber is combined with a beam normalisation detector that consists of plastic
scintillators and a retractable passivated implanted planar silicon (PIPS)
detector.
-
This work is on the Physics of the B Factories. Part A of this book contains
a brief description of the SLAC and KEK B Factories as well as their detectors,
BaBar and Belle, and data taking related issues. Part B discusses tools and
methods used by the experiments in order to obtain results. The results
themselves can be found in Part C.
Please note that version 3 on the archive is the auxiliary version of the
Physics of the B Factories book. This uses the notation alpha, beta, gamma for
the angles of the Unitarity Triangle. The nominal version uses the notation
phi_1, phi_2 and phi_3. Please cite this work as Eur. Phys. J. C74 (2014) 3026.
-
The possible existence of \eta'-nucleus bound states has been put forward
through theoretical and experimental studies. It is strongly related to the
\eta' mass at finite density, which is expected to be reduced because of the
interplay between the $U_A(1)$ anomaly and partial restoration of chiral
symmetry. The investigation of the C(p,d) reaction at GSI and FAIR, as well as
an overview of the experimental program at GSI and future plans at FAIR are
discussed.
-
The mass of the {\eta}' meson is theoretically expected to be reduced at
finite density, which indicates the existence of {\eta}'-nucleus bound states.
To investigate these states, we perform missing-mass spectroscopy for the (p,
d) reaction near the {\eta}' production threshold. The overview of the
experimental situation is given and the current status is discussed.
-
Technological advancements are strongly required to fulfill the demands of
new accelerator devices with the highest accelerating gradients and operation
reliability for the future colliders. To this purpose an extensive R&D
regarding molybdenum coatings on copper is in progress. In this contribution we
describe chemical composition, deposition quality and resistivity properties of
different molybdenum coatings obtained via sputtering. The deposited films are
thick metallic disorder layers with different resistivity values above and
below the molibdenum dioxide reference value. Chemical and electrical
properties of these sputtered coatings have been characterized by Rutherford
backscattering, XANES and photoemission spectroscopy. We will also present a
three cells standing wave section coated by a molybdenum layer $\sim$ 500 nm
thick designed to improve the performance of X-Band accelerating systems.
-
We theoretically investigate a non-magnetic impurity effect on the
temperature dependence of the vortex core shrinkage (Kramer-Pesch effect) in a
single-band s-wave superconductor. The Born limit and the unitary limit
scattering are compared within the framework of the quasiclassical theory of
superconductivity. We find that the impurity effect inside a vortex core in the
unitary limit is weaker than in the Born one when a system is in the moderately
clean regime, which results in a stronger core shrinkage in the unitary limit
than in the Born one.
-
Because accretion and merger shocks in clusters of galaxies may accelerate
particles to high energies, clusters are candidate sites for the origin of
ultra-high-energy (UHE) cosmic-rays. A prediction was presented for gamma-ray
emission from a cluster of galaxies at a detectable level with the current
generation of imaging atmospheric Cherenkov telescopes. The gamma-ray emission
was produced via inverse Compton upscattering of cosmic microwave background
(CMB) photons by electron-positron pairs generated by collisions of UHE cosmic
rays in the cluster. We observed two clusters of galaxies, Abell 3667 and Abell
4038, searching for very-high-energy gamma-ray emission with the CANGAROO-III
atmospheric Cherenkov telescope system in 2006. The analysis showed no
significant excess around these clusters, yielding upper limits on the
gamma-ray emission. From a comparison of the upper limit for the north-west
radio relic region of Abell 3667 with a model prediction, we derive a lower
limit for the magnetic field of the region of ~0.1 micro G. This shows the
potential of gamma-ray observations in studies of the cluster environment. We
also discuss the flux upper limit from cluster center regions using a model of
gamma-ray emission from neutral pions produced in hadronic collisions of
cosmic-ray protons with the intra-cluster medium (ICM). The derived upper limit
of the cosmic-ray energy density within this framework is an order of magnitude
higher than that of our Galaxy.
-
We observed the unidentified TeV gamma-ray source HESS J1804-216 with the
CANGAROO-III atmospheric Cerenkov telescopes from May to July in 2006. We
detected very high energy gamma rays above 600 GeV at the 10 sigma level in an
effective exposure of 76 hr. We obtained a differential flux of
(5.0+/-1.5_{stat}+/-1.6_{sys})\times 10^{-12}(E/1 TeV)^{-\alpha}
cm^{-2}s^{-1}TeV^{-1} with a photon index \alpha of 2.69 +/- 0.30_{stat} +/-
0.34_{sys}, which is consistent with that of the H.E.S.S. observation in 2004.
We also confirm the extended morphology of the source. By combining our result
with multi-wavelength observations, we discuss the possible counterparts of
HESS J1804-216 and the radiation mechanism based on leptonic and hadronic
processes for a supernova remnant and a pulsar wind nebula.
-
We describe a scheme for producing polarised positrons at the ILC from
polarised X-rays created by Compton scattering of a few-GeV electron beam off a
CO2 or YAG laser. This scheme is very energy effective using high finesse laser
cavities in conjunction with an electron storage ring.
-
As a joint effort in the JLC/NLC research program, we have developed a new
type of damped detuned accelerator structure with optimized round-shaped
cavities (RDDS). This paper discusses some important R&D aspects of the first
structure in this series (RDDS1). The design aspects covered are the cell
design with sub-MHz precision, HOM detuning, coupling and damping technique and
wakefield simulation. The fabrication issues covered are ultra-precision cell
machining with micron accuracy, assembly and diffusion bonding technologies to
satisfactorily meet bookshelf, straightness and cell rotational alignment
requirements. The measurements described are the RF properties of single
cavities and complete accelerator section, as well as wakefields from the ASSET
tests at SLAC. Finally, future improvements are also discussed.
-
In fabricating the first X-Band RDDS (Rounded Damped Detuned Structure)
accelerator structure, microwave measurements are made on short groups of discs
prior to bonding the discs of the entire structure. The design dispersion
curves are compared with the frequency measurements. The theory utilised is
based on a circuit model adapted to a short stack of slowly varying non-uniform
discs. The model reveals the nature of the modes in the structure and may also
be used to refit the experimental data to the parameters in a model of the
wakefield given earlier [1]. This method allows a more faithful determination
of the wakefield that a beam will experience as it traverses the structure.
Results obtained on the frequencies are compared to the original design.
[1] R.M.Jones, et al, EPAC96 (also SLAC-PUB-7187)
-
Following the successful design and fabrication of Damped Detuned Structures
(DDS), the JLC/NLC linear collider project advanced to Rounded Damped Detuned
Structures (RDDS) with curved cross section of the cavity shape for increased
shunt impedance. Various advanced techniques for fabricating RDDS1 disks
comparing to those for DDS were established to satisfy the dimension accuracy
of +-1 micron over the entire surface made by ultra-precision turning. These
disks were assembled with almost the same stacking and bonding jigs and
processes as those of DDS3 assembly. In consequence, the assembly showed little
disk-to-disk misalignment within 1 micron before and after the process. Though,
it had 200 micron smooth bowing, which was subsequently corrected as DDS3, and
flares at both ends.
-
Following successful design and fabrication of damped detuned structures, the
R&D for the accelerating structures of the NLC/JLC linear collider project
proceeded to studies of Rounded Damped Detuned Structure with curved cross
section of the cavity shape for increased shunt impedance. The important
features of the structure are the accurately tuned accelerating mode frequency
and the distribution of the first dipole modes smooth and close to the design
distribution. These requirements were met based on the high-accuracy diamond
turning with its capability to realize the periphery tolerance of two microns.
The lowest dipole mode frequencies scattered by 0.6 MHz RMS. The error in the
accelerating mode frequency averaged over a structure was 0.1 MHz by applying a
feed-forward method.