• Spin superfluid is a novel emerging quantum matter arising from the Bose-Einstein condensate (BEC) of spin-1 bosons. We demonstrate the spin superfluid ground state in canted antiferromagnetic Cr2O3 thin film at low temperatures via nonlocal spin transport. A large enhancement of the nonlocal spin signal is observed below ~ 20 K, and it saturates from ~ 5 K down to 2 K. We show that the spins can propagate over very long distances (~ 20 micro meters) in such spin superfluid ground state and the nonlocal spin signal decreases very slowly as the spacing increases with an inverse relationship, which is consistent with theoretical prediction. Furthermore, spin superfluidity has been investigated in the canted antiferromagnetic phase of the (11-20)-oriented Cr2O3 film, where the magnetic field dependence of the associated critical temperature follows a two-thirds power law near the critical point. The experimental demonstration of the spin superfluid ground state in canted antiferromagnet will be extremely important for the fundamental physics on the BEC of spin-1 bosons and paves the way for future spin supercurrent devices, such as spin-Josephson junctions.
  • We report the critical role of La doping in the topological Hall effect observed in LaxEu1-xO thin films (~ 50 nm) grown by molecular beam epitaxy. When the La doping exceeds 0.036, topological Hall effect emerges, which we attribute to the formation of magnetic skyrmions. Besides, the La doping is found to play a critical role in determining the phases, densities, and sizes of the skyrmions in the LaxEu1-xO thin films. The maximum region of the skyrmion phase diagram is observed on the La0.1Eu0.9O thin film. As the La doping increases, the skyrmion density increases while the skyrmion size decreases. Our findings demonstrate the important role of La doping for the skyrmions in EuO films, which could be important for future studies of magnetic skyrmions in Heisenberg ferromagnets.
  • The search for long electron phase coherence length, which is the length that an electron can keep its quantum wave-like properties, has attracted considerable interest in the last several decades. Here, we report the long phase coherence length of ~ 3.7 micro meters in La-doped CdO thin films at 2 K. Systematical investigations of the La doping and the temperature dependences of the electron mobility and the electron phase coherence length reveal contrasting scattering mechanisms for these two physical properties. Furthermore, these results show that the oxygen vacancies could be the dominant scatters in CdO thin films that break the electron phase coherence, which would shed light on further investigation of phase coherence properties in oxide materials.
  • Ionic liquid gating can markedly modulate the materials' carrier density so as to induce metallization, superconductivity, and quantum phase transitions. One of the main issues is whether the mechanism of ionic liquid gating is an electrostatic field effect or an electrochemical effect, especially for oxide materials. Recent observation of the suppression of the ionic liquid gate-induced metallization in the presence of oxygen for oxide materials suggests the electrochemical effect. However, in more general scenarios, the role of oxygen in ionic liquid gating effect is still unclear. Here, we perform the ionic liquid gating experiments on a non-oxide material: two-dimensional ferromagnetic Cr2Ge2Te6. Our results demonstrate that despite the large increase of the gate leakage current in the presence of oxygen, the oxygen does not affect the ionic liquid gating effect (< 5 % difference), which suggests the electrostatic field effect as the mechanism on non-oxide materials. Moreover, our results show that the ionic liquid gating is more effective on the modulation of the channel resistances compared to the back gating across the 300 nm thick SiO2.
  • The emergence of two-dimensional (2D) materials has attracted a great deal of attention due to their fascinating physical properties and potential applications for future nanoelectronic devices. Since the first isolation of graphene, a Dirac material, a large family of new functional 2D materials have been discovered and characterized, including insulating 2D boron nitride, semiconducting 2D transition metal dichalcogenides and black phosphorus, and superconducting 2D bismuth strontium calcium copper oxide, molybdenum disulphide and niobium selenide, etc. Here, we report the identification of ferromagnetic thin flakes of Cr2Ge2Te6 (CGT) with thickness down to a few nanometers, which provides a very important piece to the van der Waals structures consisting of various 2D materials. We further demonstrate the giant modulation of the channel resistance of 2D CGT devices via electric field effect. Our results illustrate the gate voltage tunability of 2D CGT and the potential of CGT, a ferromagnetic 2D material, as a new functional quantum material for applications in future nanoelectronics and spintronics.
  • The Rashba physics has been intensively studied in the field of spin orbitronics, for the purpose of searching novel physical properties and the FM magnetization switching for technology applications. Here, we report the observation of the inverse Edelstein effect up to room temperature in the Rashba-split 2DEG between two insulating oxides SrTiO3 and LaAlO3 with the LaAlO3 layer thickness from 3 to 40 unit cells (UC). We further demonstrate that the spin voltage could be dramatically manipulated by electric field effect for the 2DEG between SrTiO3 and 3 UC LaAlO3. These results demonstrate that the Rashba-split 2DEG at the complex oxide interface can be used for room temperature efficient charge-and-spin conversion for the generation and detection of spin current.
  • There has been considerable interest in exploiting the spin degrees of freedom of electrons for potential information storage and computing technologies. Topological insulators (TI), a class of quantum materials, have special gapless edge/surface states, where the spin polarization of the Dirac fermions is locked to the momentum direction. This spin-momentum locking property gives rise to very interesting spin-dependent physical phenomena such as the Edelstein and inverse Edelstein effects. However, the spin injection in pure surface states of TI is very challenging because of the coexistence of the highly conducting bulk states. Here, we experimentally demonstrate the spin injection and observe the inverse Edelstein effect in the surface states of a topological Kondo insulator, SmB6. At low temperatures when only surface carriers are present, a clear spin signal is observed. Furthermore, the magnetic field angle dependence of the spin signal is consistent with spin-momentum locking property of surface states of SmB6.
  • We report the discovery of a positive exchange bias between Ni80Fe20 (Py) and twined (10-10)-Cr2O3 film near its blocking temperature (TB) when it is cooled in an in-plane magnetic field applied along 45 degrees from the two spin configurations of the Cr atoms. This is an abnormal behavior compared to the negative exchange bias at all temperatures below TB when the cooling and measuring magnetic fields are applied along one of the two spin configurations of the Cr atoms. We speculate these results could be related to the exchange interactions between the twined structure of the (10-10)-Cr2O3 film epitaxially grown on the rutile (001)-TiO2 substrate.
  • Exchange bias is one of the most extensively studied phenomena in magnetism, since it exerts a unidirectional anisotropy to a ferromagnet (FM) when coupled to an antiferromagnet (AFM) and the control of the exchange bias is therefore very important for technological applications, such as magnetic random access memory and giant magnetoresistance sensors. In this letter, we report the crystal structure manipulation of the exchange bias in epitaxial hcp Cr2O3 films. By epitaxially growing twined (10-10) oriented Cr2O3 thin films, of which the c axis and spins of the Cr atoms lie in the film plane, we demonstrate that the exchange bias between Cr2O3 and an adjacent permalloy layer is tuned to in-plane from out-of-plane that has been observed in (0001) oriented Cr2O3 films. This is owing to the collinear exchange coupling between the spins of the Cr atoms and the adjacent FM layer. Such a highly anisotropic exchange bias phenomenon is not possible in polycrystalline films.
  • A nonlinear analysis of high-frequency thickness-shear vibrations of AT-cut quartz crystal plates is presented with the two-dimensional finite element method. We expanded both kinematic and constitutive nonlinear Mindlin plate equations and then truncated them to the first-order equations as an approximation, which is used later for the formulation of nonlinear finite element analysis with all zeroth- and first-order displacements and electric potentials. The matrix equation of motion is established with the first-order harmonic approximation and the generalized nonlinear eigensystem is solved by a direct iterative procedure. A backbone curve and corresponding mode shapes are obtained and analyzed. The nonlinear finite element program is developed based on earlier linear edition and can be utilized to predict nonlinear characteristics of miniaturized quartz crystal resonators in the design process.
  • Membrane-type Acoustic Metamaterials (MAMs) have demonstrated unusual capacity in controlling low-frequency sound transmission/reflection. In this paper, an analytical vibroacoustic membrane model is developed to study sound transmission behavior of the MAM under a normal incidence. The MAM is composed of a prestretched elastic membrane with attached rigid masses. To accurately capture finite-dimension rigid mass effects on the membrane deformation, the point matching approach is adopted by applying a set of distributed point forces along the interfacial boundary between masses and the membrane. The accuracy and capability of the theoretical model is verified through the comparison with the finite element method. In particular, microstructure effects such as weight, size and eccentricity of the attached mass, pretension and thickness of the membrane on the resulting transmission peak and dip frequencies of the MAM are quantitatively investigated. New peak and dip frequencies are found for the MAM with one and multiple eccentric attached masses. The developed model can be served as an efficient tool for design of such membrane-type metamaterials.
  • By considering the membrane's dissipation, the membrane-type acoustic metamaterial (MAM) has been demonstrated as a super absorber for low-frequency sound. In the paper, a theoretical vibroacoustic plate model is developed to reveal sound energy absorption mechanism within the MAM under a plane normal incidence. Based on the plate model in conjunction with the point matching method, the in-plane strain energy of the membrane due to the resonant and antiresonant motion of the attached masses can be accurately captured by solving the coupled vibroacoustic integrodifferential equation. Therefore, the sound absorption of the MAM is obtained and discussed, which is also in good agreement with the prediction from the finite element method. In particular, microstructure effects including eccentricity of the attached masses, the depth, thickness and loss factor of the membrane on sound absorption peak values are quantitatively investigated.