• ### Quality Assurance on Un-Doped CsI Crystals for the Mu2e Experiment(1802.08247)

Feb. 22, 2018 hep-ex, physics.ins-det
The Mu2e experiment is constructing a calorimeter consisting of 1,348 undoped CsI crystals in two disks. Each crystal has a dimension of 34 x 34 x 200 mm, and is readout by a large area silicon PMT array. A series of technical specifications was defined according to physics requirements. Preproduction CsI crystals were procured from three firms: Amcrys, Saint-Gobain and Shanghai Institute of Ceramics. We report the quality assurance on crystal's scintillation properties and their radiation hardness against ionization dose and neutrons. With a fast decay time of 30 ns and a light output of more than 100 p.e./MeV measured with a bi-alkali PMT, undoped CsI crystals provide a cost-effective solution for the Mu2e experiment.
• ### The Mu2e undoped CsI crystal calorimeter(1801.02237)

Feb. 22, 2018 physics.ins-det
The Mu2e experiment at Fermilab will search for Charged Lepton Flavor Violating conversion of a muon to an electron in an atomic field. The Mu2e detector is composed of a tracker, an electromagnetic calorimeter and an external system, surrounding the solenoid, to veto cosmic rays. The calorimeter plays an important role to provide: a) excellent particle identification capabilities; b) a fast trigger filter; c) an easier tracker track reconstruction. Two disks, located downstream of the tracker, contain 674 pure CsI crystals each. Each crystal is read out by two arrays of UV-extended SiPMs. The choice of the crystals and SiPMs has been finalized after a thorough test campaign. A first small scale prototype consisting of 51 crystals and 102 SiPM arrays has been exposed to an electron beam at the BTF (Beam Test Facility) in Frascati. Although the readout electronics were not the final, results show that the current design is able to meet the timing and energy resolution required by the Mu2e experiment.
• ### Expression of Interest for Evolution of the Mu2e Experiment(1802.02599)

Feb. 7, 2018 hep-ex, physics.ins-det
We propose an evolution of the Mu2e experiment, called Mu2e-II, that would leverage advances in detector technology and utilize the increased proton intensity provided by the Fermilab PIP-II upgrade to improve the sensitivity for neutrinoless muon-to-electron conversion by one order of magnitude beyond the Mu2e experiment, providing the deepest probe of charged lepton flavor violation in the foreseeable future. Mu2e-II will use as much of the Mu2e infrastructure as possible, providing, where required, improvements to the Mu2e apparatus to accommodate the increased beam intensity and cope with the accompanying increase in backgrounds.
• ### Measurement of the energy and time resolution of a undoped CsI + MPPC array for the Mu2e experiment(1702.03720)

Feb. 13, 2017 hep-ex, physics.ins-det
This paper describes the measurements of energy and time response and resolution of a 3 x 3 array made of undoped CsI crystals coupled to large area Hamamatsu Multi Pixel Photon Counters. The measurements have been performed using the electron beam of the Beam Test Facility in Frascati (Rome, Italy) in the energy range 80-120 MeV. The measured energy resolution, estimated with the FWHM, at 100 MeV is 16.4%. This resolution is dominated by the energy leakage due to the small dimensions of the prototype. The time is reconstructed by fitting the leading edge of the digitized signals and applying a digital constant fraction discrimination technique. A time resolution of about 110 ps at 100 MeV is achieved.
• ### The calorimeter of the Mu2e experiment at Fermilab(1701.07975)

Jan. 27, 2017 physics.ins-det
The Mu2e experiment at Fermilab looks for Charged Lepton Flavor Violation (CLFV) improving by 4 orders of magnitude the current experimental sensitivity for the muon to electron conversion in a muonic atom. A positive signal could not be explained in the framework of the current Standard Model of particle interactions and therefore would be a clear indication of new physics. In 3 years of data taking, Mu2e is expected to observe less than one background event mimicking the electron coming from muon conversion. Achieving such a level of background suppression requires a deep knowledge of the experimental apparatus: a straw tube tracker, measuring the electron momentum and time, a cosmic ray veto system rejecting most of cosmic ray background and a pure CsI crystal calorimeter, that will measure time of flight, energy and impact position of the converted electron. The calorimeter has to operate in a harsh radiation environment, in a 10-4 Torr vacuum and inside a 1 T magnetic field. The results of the first qualification tests of the calorimeter components are reported together with the energy and time performances expected from the simulation and measured in beam tests of a small scale prototype.
• ### Design and status of the Mu2e electromagnetic calorimeter(1608.02652)

Aug. 8, 2016 hep-ex, physics.ins-det
The Mu2e experiment at Fermilab aims at measuring the neutrinoless conversion of a negative muon into an electron and reach a single event sensitivity of 2.5x10^{-17} after three years of data taking. The monoenergetic electron produced in the final state, is detected by a high precision tracker and a crystal calorimeter, all embedded in a large superconducting solenoid (SD) surrounded by a cosmic ray veto system. The calorimeter is complementary to the tracker, allowing an independent trigger and powerful particle identification, while seeding the track reconstruction and contributing to remove background tracks mimicking the signal. In order to match these requirements, the calorimeter should have an energy resolution of O(5)% and a time resolution better than 500 ps at 100 MeV. The baseline solution is a calorimeter composed of two disks of BaF2 crystals read by UV extended, solar blind, Avalanche Photodiode (APDs), which are under development from a JPL, Caltech, RMD consortium. In this paper, the calorimeter design, the R&D studies carried out so far and the status of engineering are described. A backup alternative setup consisting of a pure CsI crystal matrix read by UV extended Hamamatsu MPPC's is also presented.
• ### Design, status and test of the Mu2e crystal calorimeter(1606.05448)

July 1, 2016 hep-ex, physics.ins-det
The Mu2e experiment at Fermilab searches for the charged-lepton flavor violating neutrino-less conversion of a negative muon into an electron in the field of a aluminum nucleus. The dynamic of such a process is well modeled by a two-body decay, resulting in a monoenergetic electron with an energy slightly below the muon rest mass (104.967 MeV). The calorimeter of this experiment plays an important role to provide excellent particle identification capabilities and an online trigger filter while aiding the track reconstruction capabilities. The baseline calorimeter configuration consists of two disks each made with about 700 undoped CsI crystals read out by two large area UV-extended Silicon Photomultipliers. These crystals match the requirements for stability of response, high resolution and radiation hardness. In this paper we present the final calorimeter design.
• ### Looking for Squark Pair Production in the Early LHC Data(1005.5062)

May 27, 2010 hep-ph
We examine the ability of LHC experiments to observe jets from squark pair production at the center-of-mass energy E$_{CM}$=10 TeV and 1 fb$^{-1}$ of integrated luminosity. We point out the crucial influence of initial- and final-state radiation on the signal/background discriminating ability of different kinematic variables. The reliable measurements of missing transverse energy and stransverse mass would play a key role in picking out the signal against the background.
• ### Looking for Large Extra Dimensions in the Early LHC Data(0911.3477)

Nov. 18, 2009 hep-ph
We explore the opportunity to look for large extra dimensions in the early stages of the LHC running. The high-E$_T$ dijet production is analyzed via a novel kinematic variable when the machine center-of-mass energy varies from 7 TeV through 10 TeV to 14 TeV and the accumulated data range from 0.5 to 8 fb$^{-1}$. The estimations of the reach in the effective scale $M_S$ for different numbers of large extra dimensions are presented.
• ### LHC Probe of Quark Substructure at the Early Stages of Running(0905.1008)

May 7, 2009 hep-ph
We explore the opportunity to look for quark compositeness in the early stages of the LHC running by analyzing high-$E_T$ dijet production. The quark substructure that will manifest itself by affecting various kinematic distributions at the center-of-mass energy $E_{CM}$=10 TeV and in the integrated luminosity range from 0.5 to 10 fb$^{-1}$ is investigated. The estimation of the characteristic energy scale $\Lambda$, based on the novel, potentially powerful observable, is found to be sensitive to the sign of the interference between Standard Model and four-fermion contact interactions. We find the lower limits on $\Lambda$ at the LHC to be about 10.5(15.0) TeV for constructive interference and 8.5(11.5) TeV for destructive one at the integrated luminosity 0.5(10) fb$^{-1}$ and $E_{CM}=10$ TeV.
• ### Impact of Energy and Luminosity upgrades at LHC on the Physics program of ATLAS(hep-ex/0203019)

March 13, 2002 hep-ex
The impact on the physics capabilities of the ATLAS detector of possible LHC upgrades is discussed. As a benchmark, an increase in the luminosity by a factor of ten is considered. For comparison, a doubling of the LHC energy is also explored. Both upgrades significantly enhance the physics capabilities of ATLAS. As measured in terms of the mass reach for new particles, the energy upgrade is more powerful. However, in cases where the effect of an upgrade is to increase the precision of measurements as a result of the larger data samples, the luminosity upgrade can be at least as powerful. The pile-up of minimum bias events at higher luminosity could limit the physics performance of ATLAS in areas where tagging of forward jets is needed.